Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item Power Quality Enhancement Using Current Injection Technique in a Zigzag Configured Autotransformer-Based 12-Pulse Rectifier(Institute of Electrical and Electronics Engineers Inc., 2018) Kalpana, R.; Chethana, K.S.; P, P.; Singh, B.This paper proposes a DC-side circuit configuration that improves the harmonic suppression ability of a 12-pulse diode bridge rectifier (DBR) using a zigzag configured autotransformer. The DC-side circuit uses a single-phase DBR along with interphase transformer which generates the required circulating current thereby modifies the DC currents at the DBR output, in turn shapes the input line current near to a sine wave. The proposed single-phase DBR is connected in parallel with the load which enables to reuse the harmonic energy thus improving the energy conversion efficiency. The zigzag configured autotransformer used for 12-pulse DBR possesses the inbuilt ability to hinder the zero-sequence components, which expel the need of zero sequence blocking transformer. The proposed configuration is analyzed, simulated in MATLAB Simulink and the simulation results are presented, which confirm the reduction of total harmonic distortion (THD) in the input line current thereby improving the power quality under large load variations. Furthermore, the viability of the proposed configuration is verified by experimental results, which confirm the suitability of the proposed configuration in industrial applications. © 1972-2012 IEEE.Item Three-phase three-level boost-type front-end PFC rectifier for improving power quality at input AC mains of telecom loads(Korean Institute of Power Electronics editor@kipe.or.kr, 2018) P, P.; Kalpana, R.; Singh, B.A three-phase, three-switch, and three-level boost-type PWM rectifier (Vienna rectifier) is proposed as an active front-end power factor correction (PFC) rectifier for telecom loads. The proposed active front-end PFC rectifier system is modeled by the switching cycle average model. The relation between duty ratios and DC link capacitor voltages is derived in terms of the system input currents. Furthermore, the feasible switching states are identified and applied to the proposed system to reduce the switching stress and DC ripples. A detailed equivalent circuit analysis of the proposed front-end PFC rectifier is conducted, and its performance is verified through simulations in MATLAB. Simulation results are verified using an experimental setup of an active front-end PFC rectifier that was developed in the laboratory. Simulation and experimental results demonstrate the improved power quality parameters that are in accordance with the IEEE and IEC standards. © 2018, Korean Institute of Power Electronics. All rights reserved.Item Application of voltage multiplier in 12-pulse rectifier for sinusoidal input current(Institution of Engineering and Technology journals@theiet.org, 2018) P, P.; Kalpana, R.; Singh, B.; Bhuvaneswari, G.A DC current injection circuit of a trifurcated autotransformer (TAT)-based 12-pulse diode bridge rectifier (DBR) is proposed which can help reduction of harmonics in the AC mains. The circuit at the DC side employs a voltage multiplier (VM) circuits namely voltage doubler, voltage tripler and voltage quadrupler and an interphase transformer which provides the required circulating current. This induced circulating current shapes the input AC line current near to a sine wave. The output of VM circuits is connected across the load and thereby reuses the harmonic energy absorbed by the system. Thus, improves the energy conversion efficiency of the proposed system. The TAT-based 12-pulse DBR has the implicit ability to prevent the zero sequence components thus expels the necessity of zero sequence blocking transformer. The proposed configuration is analysed, simulated in MATLAB Simulink and the simulation results are presented, which confirms the improvement in power quality parameters in the input AC line current. Further, the viability of the proposed configuration is verified by experimental results which confirm the suitability of the proposed configuration in AC-DC applications. © 2018 Springer Verlag. All rights reserved.Item Modified Current Control for Tracking Global Peak Under Fast Changing Partial Shading Conditions(Institute of Electrical and Electronics Engineers Inc., 2022) P, P.; Vignesh Kumar, V.; Balasubramanian, B.; Ramana, V.The power - voltage (P-V) characteristics of photovoltaic (PV) systems exhibit multiple power peaks under partially shaded conditions. Several global maximum power point tracking (GMPPT) algorithms in the literature recognize the irradiance change, only after the convergence of operating point to global peak, or use additional hardware to call GMPPT subroutine at definite time intervals to detect any insolation change, and thus track the global peak. However, during fast changing partial shading conditions, these methods are less effective, as they do not detect any irradiance change during the tracking phase of any shading pattern. This paper proposes a novel modified current control approach that uses current as a parameter to detect the insolation change during the tracking phase and track the global peak under fast changing partial shading conditions without any additional hardware. The proposed technique improves the tracking efficiency by as much as 39%, thus proving to be effective under fast-changing partial shading conditions. The superior tracking performance of the proposed algorithm over the existing techniques in terms of its tracking efficiency, dynamic tracking capability, tracking speed, and convergence to the global peak is demonstrated with extensive simulations using MATLAB/Simulink and experimental results. © 1986-2012 IEEE.Item A Novel Algorithm Based on Voltage and Current Perturbation to Track Global Peak Under Partial Shading Conditions(Institute of Electrical and Electronics Engineers Inc., 2022) P, P.; Vignesh Kumar, V.; Koothu Kesavan, K.K.; Balasubramanian, B.Under partial shading conditions, photovoltaic (PV) systems exhibit multiple peaks in their power-voltage (P-V) characteristics. It is essential to extract maximum energy from the PV system. The global maximum power point tracking (GMPPT) algorithms presented in the literature, track the global peak using different methods. It is imperative to have minimal convergence time for GMPPT process. This paper proposes a novel algorithm to track the global peak using voltage and current perturbation. The new GMPPT algorithm operates in a current perturbation or voltage perturbation mode, based on the value of a control variable. In either mode, the proposed technique generates reference current or reference voltage, for navigating the operating point to GMPP location. The proposed algorithm is compared with two GMPPT algorithms, namely, modified maximum power trapezium (M-MPT) and high-performance GMPPT algorithms. The simulation studies are performed in MATLAB and is validated using a laboratory prototype, with dSPACE 1202 MicroLabBox controller for implementing GMPPT methods. Simulation and experimental results show that the new technique exhibits superior performance in terms of tracking time. Also, the energy efficiency is improved by 40% while using the proposed GMPPT algorithm for the irradiance profiles considered in this paper compared to the other two techniques. © 1986-2012 IEEE.Item A Novel Two Five-Level Double-Boost Inverters for Grid-Tied Photovoltaic Applications(Springer, 2025) Maheswari, G.; Manjunatha Sharma, K.M.; P, P.This paper proposes two novel five-level inverters, both featuring a common ground configuration and double-boosting capability. The common ground configuration in the proposed topologies effectively eliminates leakage current, making them ideal for grid-connected photovoltaic applications. The first proposed inverter topology consists of a single DC source, six power switches, two diodes, two capacitors, and one charging inductor. The second topology also uses a single DC source but comprises seven power switches, one diode, two capacitors, and one charging inductor. In both proposed inverter topologies, the switched capacitors automatically balance to voltages of Vdc and 2Vdc. Additionally, the charging inductor helps reduce spike currents in the capacitor charging path. These inverters offer several advantages, including a reduced component count, low per-unit total standing voltage, high efficiency, increased power density due to fewer components, reduced spike currents, and a common ground (CG) structure that entirely eliminates leakage current. The proposed inverters employ a proportional-integral (PI) controller with phase disposition pulse-width modulation (for the first converter) and staircase modulation (for the second converter). A comparative analysis of existing and proposed five-level inverters is presented, demonstrating their suitability for grid-tied photovoltaic applications through MATLAB Simulink simulations and experimental validation using Hardware-in-the-Loop (HIL). © The Author(s), under exclusive licence to Springer Nature Singapore Pte Ltd. 2025.