Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
7 results
Search Results
Item Effect of oxygen substitution and phase on nickel selenide nanostructures for supercapacitor applications(Institute of Physics Publishing helen.craven@iop.org, 2018) Bhat, K.S.; Nagaraja, H.S.Electrochemical supercapacitors are the eminent technology for the progress of energy storage devices. The current manuscript deals with the formation of oxygen substituted nickel selenide nanostructures and their use as active electrode material for supercapacitor, expecting an enhanced performance owing to their sheet-like geometry, high specific surface area and porous assembly. In this context, Ni(OH)2 (nickel hydroxide) nanostructures were synthesized employing one-pot hydrothermal method and the ion-exchange reaction of Ni(OH)2 nanostructures with selenium resulted in cubic-NiSe2 (nickel selenide) nanostructures. Further, annealing NiSe2 nanostructures at intermediate pressure (10-3 Torr) has realized the partial oxygen substitution in place of selenium, resulting in NiSe/NiO nanostructures along with phase change from cubic-NiSe2 to hexagonal-NiSe. Supercapacitor electrodes fabricated using NiSe/NiO nanostructures delivered the specific capacitance of 83.5 F g-1 at the scan rate of 2 mV s-1, which is surprisingly more than a double as compared with pristine NiSe2 electrodes (37.4 F g-1). Annealing at intermediate pressure and high temperature significantly enhanced the specific capacitances of the nanostructured electrodes and also accompanied with the good capacitance retention of 94% for 5000 CV cycles. © 2018 IOP Publishing Ltd.Item Nickel selenide nanostructures as an electrocatalyst for hydrogen evolution reaction(Elsevier Ltd, 2018) Bhat, K.S.; Nagaraja, H.S.Electrochemical water splitting has gained momentum for the development of alternative energy sources. Herein, we report the synthesis of two different nickel selenide nanostructures of different morphology and composition employing hydrothermal method. NiSe2 nanosheets were obtained by the anion-exchange reaction of Ni(OH)2 with Se ions for 15 h. On the other hand, NiSe nanoflakes were synthesized by the direct selenization of nickel surface with the reaction time of 2 h. Tested as an electrocatalyst for hydrogen evolution reaction, NiSe2 nanosheets and NiSe nanoflakes can afford a geometric current density of 10 mA cm?2 at an overpotential of 198 mV and 217 mV respectively. The measured Tafel slope values of NiSe nanoflakes are 28.6 mV dec?1, which is three times lower as compared with NiSe2 nanosheets (72.1 mV dec?1). These results indicates the HER kinetics of NiSe nanoflakes are at par with the state-of-the-art Pt/C catalyst and also complimented with the short synthesis time of 2 h. Further, both nickel selenides exhibit ultra-long term stability for 30 h as evident from constant current chronopotentiometry and electrochemical impedance spectroscopy results. © 2018 Hydrogen Energy Publications LLCItem Influence of cations on the dielectric properties of spinel structured nanoferrites(Institute of Physics Publishing helen.craven@iop.org, 2019) Bindu, K.; Ajith, K.M.; Nagaraja, H.S.MFe2O4 (M: Fe, Zn, Ni and Sn) nanoparticles were prepared using single step hydrothermal method. Their structural, compositional and dielectric properties have been studied to investigate the effect of cations on spinel ferrites. XRD confirms the spinel structure of the samples with substitution of Zn, Ni and Sn in the lattice sites of Fe. FTIR spectra of all samples have characteristic ?1 and ?2 bands. SEM and EDS mapping show uniform distribution of cations throughout the samples. ZnFe2O4 and SnFe2O4 have higher ac conductivity and dielectric constant than that of Fe3O4 and NiFe2O4, which can be attributed to the different cationic distribution in the spinel structure. © 2019 IOP Publishing Ltd.Item Influence of cations in MFe2O4 (M: Fe, Zn, Ni, Sn) ferrite nanoparticles on the electrocatalytic activity for application in hydrogen peroxide sensor(Institute of Physics Publishing helen.craven@iop.org, 2019) Bindu, K.; Nagaraja, H.S.Hydrothermally prepared MFe2O4 (M: Fe, Zn, Ni and Sn) nanoparticles have been characterized by XRD, SEM and BET. The ferrite nanoparticles have been tested for their electrocatalytic activity and application towards the reduction and sensing of hydrogen peroxide using cyclic voltammetry and chronoamperometry techniques. ZnFe2O4 and SnFe2O4 reveal superior H2O2 sensing performance than Fe3O4 and NiFe2O4, which can be attributed to the lower redox potential of Sn2+/Sn4+ couple, lower charge-transfer resistance and higher specific surface area. ZnFe2O4 and SnFe2O4 have a sensitivity of 4.411 and 3.915 ?AmM-1 ?g-1, respectively, which is greater than that of Fe3O4 (0.434 ?AmM-1 ?g-1) and NiFe2O4 (0.644 ?AmM-1 ?g-1). SnFe2O4 has the lowest limit of detection (2.6 (M) with good selectivity towards H2O2 in the presence of other interference agents. © 2019 IOP Publishing Ltd.Item Morphology-dependent electrochemical performances of nickel hydroxide nanostructures(Indian Academy of Sciences, 2019) Bhat, K.S.; Nagaraja, H.S.Electrochemical capacitors form part of the developing technologies in the field of alternative energy sources. In the present work, nickel hydroxide (Ni(OH) 2) nanosheets and microflowers are hydrothermally prepared employing different chemical precursors. Structure, morphology and chemical analysis are conducted using powder X-ray diffraction, field emission scanning electron microscopy and energy-dispersive X-ray spectroscopy measurements. Electrochemical performances as supercapacitor electrodes of the synthesized nanostructures are evaluated through cyclic voltammetry and galvanostatic charge–discharge measurements with three-electrode configurations. The results indicated the specific capacitance of 180 and 417Fg-1 at a scan rate of 5mVs-1 for Ni(OH) 2 nanosheets and microflowers, respectively. The higher specific capacitances for Ni(OH) 2 microflowers could be attributed to the higher specific surface area, morphology, electronic conductivity and porosity. Both Ni(OH) 2 nanostructures exhibited good capacitance retention for 1500 cycles. © 2019, Indian Academy of Sciences.Item Mesoporous NiWO4@rGO nanoparticles as anode material for lithium-ion battery(Taylor and Francis Ltd., 2023) Brijesh, B.; Amudha, A.; Mukesh, M.P.; Sagar, L.; Moolayadukkam, S.; Nagaraja, H.S.Herein, we have tried to explore the charge storage properties of mesoporous NiWO4 as an anode in lithium-ion batteries (LIB). A one pot-solvothermal synthesis is used to tweak the properties of mesoporous NiWO4 nanoparticles with reduced graphene oxide (rGO) for the first time and explored the LIB anode applications. Materials are well characterised using structural and morphological characterisations to corroborate the relation between the electrochemical properties and the graphene addition. At 100 mA g−1, the NiWO4@rGO (NWZC) exhibits initial discharge capacity of 1439 mAh g−1, which is more than that of NiWO4 (NWZ). Both NWZ and NWZC display initial coloumbic efficiency of 91.65% and 62.1%. After 500 cycles, the coloumbic efficiency of the NWZ and NWZC is above 99%. The improved lithium-ion storage characteristics of the NWZC may be from the synergetic effect between NiWO4 and r-GO. © 2023 Informa UK Limited, trading as Taylor & Francis Group.Item Nano-composites of NiFe-LDH/V Se2 heterostructures for effective water splitting electrocatalyst(Elsevier Ltd, 2024) Hegde, A.; Mukesh, P.; G, L.S.; Kumar, A.; Nagaraja, H.S.In the realm of sustainable and environmentally friendly “green-hydrogen” fuel demand, water electrolysis stands as a pathway of hope for the extraction of renewable hydrogen. However, the durability and efficiency of electrocatalysts have been a major challenge in this process, owing to factors like the high costs of noble catalysts (Pt, Ir, Ru, etc.) and their limited stability. Layered Nickel-iron double hydroxides (NiFe-LDH) have shown potential as low-cost and efficient electrocatalysts because of their suitable electronic configuration and distinguished orbital confinement. However, their durability In the realm of sustainable and environmentally friendly “green-hydrogen” fuel demand, water electrolysis stands as a pathway of hope for the extraction of renewable hydrogen. However, the durability and efficiency of electrocatalysts have been a major challenge in this process, owing to factors like the high costs of noble catalysts (Pt, Ir, Ru, etc.) and their limited stability. Layered Nickel-iron double hydroxides (NiFe-LDH) have shown potential as low-cost and efficient electrocatalysts because of their suitable electronic configuration and distinguished orbital confinement. However, their performance and durability in corrosive alkaline water at high current density remain limited. In this regard, one can make the nano-composites of this NiFe-LDH with high electronic conductivity materials and layered structures like VSe2. With this motivation, this work presents a novel electrocatalyst, NiFe-LDH, supported with VSe2 nanosheets (V Se2/NiFe−LDH), designed to address these challenges and enhance water splitting efficiency. Experimental results demonstrate that the heterostructure synergistically reduces charge transfer resistance, increases exposure of active sites, and enhances oxygen gas evolution ability. Consequently, the V Se2/NiFe−LDH electrocatalyst demonstrated superior sustainability, maintaining an elevated current density (500mAcm−2) for over 50 h of continuous electrolysis without noticeable degradation. This research opens up new possibilities and shows that nano-compositing can be a good option for achieving efficient and durable electrocatalysts in alkaline water splitting, thereby contributing to sustainable hydrogen production. © 2024 Hydrogen Energy Publications LLC