Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
9 results
Search Results
Item Solar exfoliated graphene and its application in supercapacitors and electrochemical H2O2 sensing(Elsevier Ltd, 2015) Moolayadukkam, M.; Huang, N.M.; Nagaraja, H.S.In the present study, graphene nanosheets are synthesized using sunlight irradiation focussed onto graphite oxide. The morphological characteristics of graphene are examined using Scanning Electron Microscopy (SEM) and Transmission Electron Microscopy (TEM). Raman spectroscopy and X-ray diffraction (XRD) are used for the structural characterization of the sample. The electrochemical performance is evaluated using cyclic voltammetry (CV), charge-discharge characteristics and impedance spectroscopy. A high specific capacitance value of 223 F g-1 is obtained using cyclic voltammetry. The electrochemical detection of H2O2, a common biological species using solar graphene is demonstrated. The impedance spectroscopy and CV are used to study the electrocatalytic activity of the material. High sensitivity of 64.79 ?A mM-1 cm-2 is reported. © 2015 Elsevier Ltd. All rights reserved.Item Nickel selenide nanostructures as an electrocatalyst for hydrogen evolution reaction(Elsevier Ltd, 2018) Bhat, K.S.; Nagaraja, H.S.Electrochemical water splitting has gained momentum for the development of alternative energy sources. Herein, we report the synthesis of two different nickel selenide nanostructures of different morphology and composition employing hydrothermal method. NiSe2 nanosheets were obtained by the anion-exchange reaction of Ni(OH)2 with Se ions for 15 h. On the other hand, NiSe nanoflakes were synthesized by the direct selenization of nickel surface with the reaction time of 2 h. Tested as an electrocatalyst for hydrogen evolution reaction, NiSe2 nanosheets and NiSe nanoflakes can afford a geometric current density of 10 mA cm?2 at an overpotential of 198 mV and 217 mV respectively. The measured Tafel slope values of NiSe nanoflakes are 28.6 mV dec?1, which is three times lower as compared with NiSe2 nanosheets (72.1 mV dec?1). These results indicates the HER kinetics of NiSe nanoflakes are at par with the state-of-the-art Pt/C catalyst and also complimented with the short synthesis time of 2 h. Further, both nickel selenides exhibit ultra-long term stability for 30 h as evident from constant current chronopotentiometry and electrochemical impedance spectroscopy results. © 2018 Hydrogen Energy Publications LLCItem Corrosion protection of low-cost carbon steel with SS-309Mo and Inconel-625 bimetallic weld overlay(Institute of Physics Publishing helen.craven@iop.org, 2019) Mudha, A.A.; Shashikala, H.D.; Nagaraja, H.S.The dissimilar weld overlay coatings of components can lead to corrosion. In the present work, two different weld overlay layers (SS-309Mo and Inconel-625) are deposited on IS2062 grade B carbon steel, in order to avoid distortions and improve corrosion resistance. The microstructural investigations revealed that the intermediate layer SS-309Mo on carbon steel prevents the dilution by aiding crack-free weld overlay of Inconel-625 on the top. The corrosion behaviour of the coatings is studied using Linear Polarization Resistance and the Electrochemical Impedance Spectroscopy. The corrosion rate of the coatings decreased by two orders of magnitude compared to that of low carbon steel substrate. The corrosion rate of the deposited Inconel-625 along with intermediate SS-309Mo is 1.16×10-3 and is comparable to that of bare Inconel-625 (1.12×10-3 mmpy). Further, the immersion tests for 14 days show that, the depositions are stable with the formation of the passive film. ©2019 IOP Publishing Ltd.Item Lower Band Gap Sb/ZnWO4/r-GO Nanocomposite Based Supercapacitor Electrodes(Springer New York LLC barbara.b.bertram@gsk.com, 2019) Brijesh, K.; Nagaraja, H.S.Sb/ZnWO4/r-GO nanocomposite has been prepared by a single step solvothermal method. The crystal structure of the prepared nanocomposite has been characterized using a powder x-ray diffractometer (XRD). The optical properties of the prepared nanocomposite were studied using UV–visible spectroscopy and photoluminescence. The energy band gap of 3.52 eV is obtained for the ZWS-5 nanocomposite using Tauc plots. For both Sb/ZnWO4 and Sb/ZnWO4/r-GO nanocomposite XRD shows the monoclinic Wolframite structure. The supercapacitor performance of the prepared samples was carried out using electrochemical techniques such as cyclic voltammetry, galvanostatic charge–discharge and electrochemical impedance spectroscopy. The nanocomposite ZWS-5 exhibits a specific capacitance of 102 F/g, which is higher than pristine ZWS specific capacitance of 64 F/g. Both ZWS and ZWS-5 electrodes show good capacitance retention proficiency even after 1000 cycles. © 2019, The Minerals, Metals & Materials Society.Item ZnWO4/SnO2 composite for supercapacitor applications(Elsevier B.V., 2020) Vinayaraj, S.; Brijesh, K.; Dhanush, P.C.; Nagaraja, H.S.The pristine ZnWO4 and ZnWO4/SnO2 composite was synthesized by solvothermal method. The crystal structure of the ZnWO4 and ZnWO4/SnO2 composite is determined by powder X-ray diffraction (XRD) pattern. The morphology of the samples investigated using SEM and found to be agglomerated structure. The samples are tested as an electrode material for supercapacitor using electrochemical techniques like cyclic Voltammetry (CV), Galvanostatic Charge-Discharge (GCD) and Electrochemical Impedance Spectroscopy (EIS). The ZnWO4/SnO2 composite reveals 56.7 F/g specific capacitance at 1 mV/s scan rate which is higher than that of pristine material and also ZnWO4/SnO2 composite exhibits good cyclic stability than pure ZnWO4. © 2020 Elsevier B.V.Item Electrochemical hydrogen-storage performance of copper sulfide micro-hexagons(Elsevier Ltd, 2021) Bhat, K.S.; Nagaraja, H.S.Electrochemical hydrogen-storage is one of the prominent energy storage systems. In this work, the hydrothermally synthesized copper sulfide (Cu2S) revealed a unique morphology of micro-hexagons as envisioned through scanning electron microscopy measurements. Electrochemical hydrogen storage (EHS) performance was evaluated using various electrochemical techniques, such as cyclic voltammetry, galvanostatic charge-discharge, and impedance spectroscopy measurements. The hydrogen discharge capacity of ~59.32 mAh g?1 was obtained at an applied current density of 1 A g?1. Further, the analysis of the charge-storage mechanism indicates foremost contributions from the redox processes. The prominent hydrogen storage performance is complimented with reasonable cyclic retention for 2500 cycles. © 2020 Hydrogen Energy Publications LLCItem Impact of copper doping on the electrochemical response of MnSe2 as anode for lithium-ion battery(Springer, 2024) Mukesh, P.; Lakshmi Sagar, G.; Brijesh, K.; Kumawat, S.; Hegde, A.; Kumar, A.; Nagaraja, H.S.Transition Metal Chalcogenides (TMC), due to their unique physicochemical properties, are studied in various fields and have potent applications in energy storage applications. This work is based on the synthesis and characterization of copper-doped manganese di-selenide and the effect of its doping on electrochemical performance as anode material for lithium-ion battery applications using the solvothermal method. The characterization techniques used are X-ray diffraction, Raman spectroscopy, field-emission scanning electron microscopy, XPS, UV–visible absorption spectroscopy, and electrochemical analysis. The XRD data confirms the formation of MnSe2 exhibiting Cubic crystal geometry. The FESEM images show the micro-cube-like structure with agglomerated nanocluster nanostructures on the surface with a dimension of 100–200 nm. The doping of the copper has decreased the band gap of the MnSe2, as studied by the UV–visible absorption spectrum. The electrochemical performance is analyzed as anode material for lithium-ion batteries. The charge/discharge measurements show a specific capacity of 706 mAh g−1 as the initial discharge capacity and 336 mAh g−1 as the initial charge capacity at 0.1 A g−1 current density. Meanwhile, 3% Copper-doped MnSe2 showed a better specific capacity of 878 mAh g−1 as the initial discharge capacity and 461 mAh g−1 as the initial charge capacity at 0.1 A g−1 current density. Cyclic stability, rate capability, and electrochemical impedance spectroscopy were performed, and it shows that 3% copper-doped MnSe2 has good stability and better conductivity and charge kinetics, indicating copper doping has enhanced the electrochemical performance of pristine MnSe2. © The Author(s), under exclusive licence to Springer Science+Business Media, LLC, part of Springer Nature 2024.Item Synergistic boost in Fe3O4 anode performance for li-ion batteries via Zn and Cu double doping and multi-walled carbon nanotube composite integration(Elsevier B.V., 2024) Kumar, A.; Mukesh, P.; Lakshmi Sagar, G.; Hegde, A.; Nagaraja, H.S.In this study, a novel nanocomposite material comprising pure Fe3O4 (FO), doped Zn0.5Cu0.5Fe2O4-3 (ZCFO-3), and Zn0.5Cu0.5Fe2O4-3@ Multi-walled carbon nanotube (ZCFO-3@MWCNT) nanocomposite material is carefully prepared using a simple one-step hydrothermal process. Comprehensive surface and morphological analysis are conducted using X-ray diffraction (XRD), Field emission scanning electron microscopy (FESEM), and High-resolution transmission electron microscopy (HRTEM), while compositional studies are investigated through Raman spectroscopy and X-ray photoelectron spectroscopy (XPS). The electrochemical performance is fully analyzed through Cyclic voltammetry (CV), Electrochemical impedance spectroscopy (EIS), rate capability tests, discharge/charge capacity, and cyclic stability evaluations. Among these three nanomaterials, ZCFO-3@MWCNT nanocomposite at 100 mA g−1 current density reveals the best performance, with a discharge capacity of 1974 mAh g–1, ZCFO-3 and FO reveal 1340 mAh g–1 and 1317 mAh g–1 respectively. After 800 cycles at 500 mA g−1 current density, ZCFO-3@MWCNT stays strong with a discharge capacity of 646 mAh g–1, while ZCFO-3 manages only 362 mAh g–1 and FO only 111 mAh g–1. After 1200 cycles at 500 mA g−1, the nanocomposite still delivers 518 mAh g–1. This study suggests that ZCFO-3@MWCNT could be a promising anode material for lithium-ion batteries. © 2024 Elsevier B.V.Item Novel Ag2Cu2O3 nanorods as stable anode material for lithium-ion battery(Elsevier B.V., 2025) Kumar, A.; Sagar G, L.; P, M.; Hegde, A.P.; Nagaraja, H.S.In this research novel Ag2Cu2O3 nanorods was prepared, for lithium-ion battery as anode, using facile co-precipitation method with four different stirring time and correspondingly Ag2Cu2O3 named ACO – 30 M, ACO – 12 H, ACO – 24 H, and ACO – 36 H. Field Emission Scanning Electron Microscopy (FESEM) and High-Resolution Transmission Electron Microscopy (HRTEM) analyze surface and morphology, while X-ray Diffraction (XRD) examines structural properties. Compositional analysis is carried out using X-ray photoelectron spectroscopy (XPS) and Raman spectroscopy. The electrochemical analysis is evaluated by cyclic stability, rate capability, discharge/charge capacity, electrochemical impedance spectroscopy (EIS), and cyclic voltammetry (CV). The ACO – 24 H nanomaterial demonstrates an initial discharge capacity of 943 mAh g?1 at a current density of 50 mA g?1. Among the four materials tested, ACO – 24 H shows superior cycling performance, with a discharge capacity of 174 mAh g?1 at 200 mA g?1 after 1003 cycles. In comparison, ACO – 30 M, ACO – 12 H, and ACO – 36 H exhibit capacities of 134 mAh g?1, 91 mAh g?1, and 43 mAh g?1, respectively, under the same conditions. This study suggests that ACO – 24 H is a promising anode material for lithium-ion battery applications. © 2025 Elsevier B.V.