Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
14 results
Search Results
Item Solar exfoliated graphene and its application in supercapacitors and electrochemical H2O2 sensing(Elsevier Ltd, 2015) Moolayadukkam, M.; Huang, N.M.; Nagaraja, H.S.In the present study, graphene nanosheets are synthesized using sunlight irradiation focussed onto graphite oxide. The morphological characteristics of graphene are examined using Scanning Electron Microscopy (SEM) and Transmission Electron Microscopy (TEM). Raman spectroscopy and X-ray diffraction (XRD) are used for the structural characterization of the sample. The electrochemical performance is evaluated using cyclic voltammetry (CV), charge-discharge characteristics and impedance spectroscopy. A high specific capacitance value of 223 F g-1 is obtained using cyclic voltammetry. The electrochemical detection of H2O2, a common biological species using solar graphene is demonstrated. The impedance spectroscopy and CV are used to study the electrocatalytic activity of the material. High sensitivity of 64.79 ?A mM-1 cm-2 is reported. © 2015 Elsevier Ltd. All rights reserved.Item Melt quenched vanadium oxide embedded in graphene oxide sheets as composite electrodes for amperometric dopamine sensing and lithium ion battery applications(Elsevier B.V., 2017) Moolayadukkam, M.; Shenoy, S.; Sridharan, K.; Kufian, D.; Arof, A.K.; Nagaraja, H.S.Electrochemical sensors and lithium-ion batteries are two important topics in electrochemistry that have attracted much attention owing to their extensive applications in enzyme-free biosensors and portable electronic devices. Herein, we report a simple hydrothermal approach for synthesizing composites of melt quenched vanadium oxide embedded on graphene oxide of equal proportion (MVGO50) for the fabrication of electrodes for nonenzymatic amperometic dopamine sensor and lithium-ion battery applications. The sensing performance of MVGO50 electrodes through chronoamperometry studies in 0.1 M PBS solution (at pH 7) over a wide range of dopamine concentration exhibited a highest sensitivity of 25.02 ?A mM ?1 cm ?2 with the lowest detection limit of 0.07 ?M. In addition, the selective sensing capability of MVGO50 was also tested through chronoamperometry studies by the addition of a very small concentration of dopamine (10 ?M) in the presence of a fairly higher concentration of uric acid (10 mM) as the interfering species. Furthermore, the reversible lithium cycling properties of MVGO50 are evaluated by galvanostatic charge-discharge cycling studies. MVGO50 electrodes exhibited enhanced rate capacity of up to 200 mAhg ?1 at a current of 0.1C rate and remained stable during cycling. These results indicate that MVGO composites are potential candidates for electrochemical device applications. © 2017 Elsevier B.V.Item Porous cobalt chalcogenide nanostructures as high performance pseudo-capacitor electrodes(Elsevier Ltd, 2017) Bhat, K.S.; Shenoy, S.; Nagaraja, H.S.; Sridharan, K.Electrochemical supercapacitor is an essential technology that is pivotal for the development of reliable energy storage devices. Herein, we report the fabrication of supercapacitor electrodes using nanostructured porous cobalt chalcogenide (CoTe2 and CoSe2) electrodes, anticipating an enhanced performance owing to their higher contact area with electrolyte and large pore volume enabling shorter diffusion paths for ion exchange. In this regard, we synthesized CoTe2 and CoSe2 nanostructures via an anion-exchange-reaction between pre-synthesized Co(OH)2 hexagonal nanosheets and chalcogen (tellurium and selenium) ions under hydrothermal conditions. Structural, morphological and compositional properties of the as-synthesized materials are examined using X-ray diffraction, Raman spectroscopy, scanning electron microscopy, high resolution transmission electron microscopy and energy dispersive X-ray spectroscopy. Pseudo-capacitive properties of CoTe2 and CoSe2 nanostructures as working electrodes are studied through cyclic voltammetry and galvanostatic charge-discharge methods using an electrochemical workstation. CoSe2 electrode delivered a specific capacitance of 951 F g?1 at a scan rate of 5 mV s?1, which surprisingly is almost three times higher in comparison to CoTe2 electrode (360 F g?1). Both CoTe2 and CoSe2 electrodes exhibited good capacitance retention capability for 2500 CV cycles. The superior electrochemical performance of the nanoporous CoSe2 electrode indicate their applicability for high-performance energy storage device applications. © 2017 Elsevier LtdItem Lower Band Gap Sb/ZnWO4/r-GO Nanocomposite Based Supercapacitor Electrodes(Springer New York LLC barbara.b.bertram@gsk.com, 2019) Brijesh, K.; Nagaraja, H.S.Sb/ZnWO4/r-GO nanocomposite has been prepared by a single step solvothermal method. The crystal structure of the prepared nanocomposite has been characterized using a powder x-ray diffractometer (XRD). The optical properties of the prepared nanocomposite were studied using UV–visible spectroscopy and photoluminescence. The energy band gap of 3.52 eV is obtained for the ZWS-5 nanocomposite using Tauc plots. For both Sb/ZnWO4 and Sb/ZnWO4/r-GO nanocomposite XRD shows the monoclinic Wolframite structure. The supercapacitor performance of the prepared samples was carried out using electrochemical techniques such as cyclic voltammetry, galvanostatic charge–discharge and electrochemical impedance spectroscopy. The nanocomposite ZWS-5 exhibits a specific capacitance of 102 F/g, which is higher than pristine ZWS specific capacitance of 64 F/g. Both ZWS and ZWS-5 electrodes show good capacitance retention proficiency even after 1000 cycles. © 2019, The Minerals, Metals & Materials Society.Item Morphology-dependent electrochemical performances of nickel hydroxide nanostructures(Indian Academy of Sciences, 2019) Bhat, K.S.; Nagaraja, H.S.Electrochemical capacitors form part of the developing technologies in the field of alternative energy sources. In the present work, nickel hydroxide (Ni(OH) 2) nanosheets and microflowers are hydrothermally prepared employing different chemical precursors. Structure, morphology and chemical analysis are conducted using powder X-ray diffraction, field emission scanning electron microscopy and energy-dispersive X-ray spectroscopy measurements. Electrochemical performances as supercapacitor electrodes of the synthesized nanostructures are evaluated through cyclic voltammetry and galvanostatic charge–discharge measurements with three-electrode configurations. The results indicated the specific capacitance of 180 and 417Fg-1 at a scan rate of 5mVs-1 for Ni(OH) 2 nanosheets and microflowers, respectively. The higher specific capacitances for Ni(OH) 2 microflowers could be attributed to the higher specific surface area, morphology, electronic conductivity and porosity. Both Ni(OH) 2 nanostructures exhibited good capacitance retention for 1500 cycles. © 2019, Indian Academy of Sciences.Item ZnWO4/r-GO nanocomposite as high capacity anode for lithium-ion battery(Springer, 2020) Brijesh, K.; Nagaraja, H.S.The pristine ZnWO4 and ZnWO4/r-GO nanocomposite synthesized by the facile solvothermal method were tested as anode materials for lithium-ion battery. Ex situ X-ray photoelectron spectroscopy (XPS) confirms the elemental composition of the pristine ZnWO4 and ZnWO4/r-GO nanocomposite. The ZnWO4/r-GO nanocomposite shows mesoporous nature and exhibits 50.802 m2 g?1 BET specific surface area, which is higher than that of pristine ZnWO4. In addition, the electrochemical property of the pristine ZnWO4 and ZnWO4/r-GO nanocomposite investigated using 2032 half-cell reveals that GO enhances the electrochemical property of the ZnWO4. The ZnWO4/r-GO nanocomposite not only exhibits higher discharge capacity of 1158 mAh g?1 at 100 mA g?1 but also shows longer and stable cycle life at 300 mA g?1 current density. The ZnWO4/r-GO nanocomposite exhibits 80.74% capacity retention even after 500 cycles. The synergetic effect of r-GO and ZnWO4 improves the capacity, columbic efficiency, and stability of the material. The results indicate that ZnWO4/r-GO nanocomposite is an interesting anode material for Li-ion battery with higher capacity complemented with stability compared to pristine ZnWO4. [Figure not available: see fulltext.]. © 2020, Springer-Verlag GmbH Germany, part of Springer Nature.Item GeO2/ZnWO4@CNT nanocomposite as a novel anode material for lithium-ion battery(Springer, 2020) Brijesh, K.; Nagaraja, H.S.Single-walled carbon nanotube (SWCNT) wrapped GeO2/ZnWO4 nanocomposite was prepared by single-step solvothermal method. In this work, GeO2/ZnWO4 nanocomposites were prepared by varying the molar percentage of GeO2 and by further adding SWCNT for the composite to boost the electrochemical performance. The prepared GeO2/ZnWO4 nanocomposites and GeO2/ZnWO4@CNT nanocomposite are used as anode material for lithium-ion battery (LIB). As expected, GeO2/ZnWO4@CNT nanocomposite exhibits higher capacities and good rate capability than the GeO2/ZnWO4 nanocomposite. The GeO2/ZnWO4@CNT nanocomposite exhibits 930 mAh g?1 discharge capacity and 533 mAh g?1 charge capacity for the initial cycle at 100 mAh g?1 in the voltage range of 0.01–3 V (vs. Li+/Li). Even at high current density of 500 mAh g?1, GeO2/ZnWO4@CNT nanocomposite shows 231 mAh g?1 and 257 mAh g?1 charge/discharge capacity which are higher than that of GeO2/ZnWO4 nanocomposite. The GeO2/ZnWO4@CNT nanocomposite delivers 75.8% capacity retention and 100% coulombic efficiency even after 400 cycles at 300 mAh g?1. These results direct that GeO2/ZnWO4@CNT nanocomposite is a good negative electrode for lithium-ion battery. [Figure not available: see fulltext.]. © 2020, Springer-Verlag GmbH Germany, part of Springer Nature.Item ZnWO4/SnO2 composite for supercapacitor applications(Elsevier B.V., 2020) Vinayaraj, S.; Brijesh, K.; Dhanush, P.C.; Nagaraja, H.S.The pristine ZnWO4 and ZnWO4/SnO2 composite was synthesized by solvothermal method. The crystal structure of the ZnWO4 and ZnWO4/SnO2 composite is determined by powder X-ray diffraction (XRD) pattern. The morphology of the samples investigated using SEM and found to be agglomerated structure. The samples are tested as an electrode material for supercapacitor using electrochemical techniques like cyclic Voltammetry (CV), Galvanostatic Charge-Discharge (GCD) and Electrochemical Impedance Spectroscopy (EIS). The ZnWO4/SnO2 composite reveals 56.7 F/g specific capacitance at 1 mV/s scan rate which is higher than that of pristine material and also ZnWO4/SnO2 composite exhibits good cyclic stability than pure ZnWO4. © 2020 Elsevier B.V.Item Electrochemical hydrogen-storage performance of copper sulfide micro-hexagons(Elsevier Ltd, 2021) Bhat, K.S.; Nagaraja, H.S.Electrochemical hydrogen-storage is one of the prominent energy storage systems. In this work, the hydrothermally synthesized copper sulfide (Cu2S) revealed a unique morphology of micro-hexagons as envisioned through scanning electron microscopy measurements. Electrochemical hydrogen storage (EHS) performance was evaluated using various electrochemical techniques, such as cyclic voltammetry, galvanostatic charge-discharge, and impedance spectroscopy measurements. The hydrogen discharge capacity of ~59.32 mAh g?1 was obtained at an applied current density of 1 A g?1. Further, the analysis of the charge-storage mechanism indicates foremost contributions from the redox processes. The prominent hydrogen storage performance is complimented with reasonable cyclic retention for 2500 cycles. © 2020 Hydrogen Energy Publications LLCItem Fabrication of AgWO4/CNT nanomaterial for high capacity lithium ion battery(Taylor and Francis Ltd., 2022) Brijesh, K.; Prajil, M.K.; Nagaraja, H.S.Herein, we report the synthesis of AgWO4 nanomaterial (AWN) and Single-walled carbon nanotube (SWCNT) wrapped AgWO4 nanomaterial (AWNC) via the solvothermal method and is used as an anode material for lithium-ion battery (LIB). The AWNC exhibits, 1202 mAh g?1 discharge capacity at 0.1 A g?1 current density with good cyclic stability and 100% columbic efficiency even after 500 cycles. The AWNC electrode shows a reversible capacity of 594, 521, 252, 143 and 84 mAh g?1 at 0.1, 0.2, 0.3, 0.5 and 1 A g?1 respectively. The 543 mAh g?1 reversible capacity recovered at 0.1 A g?1 after cycling at several current densities suggests the good rate performance of the AWNC electrode. The decent electrochemical performance of the AWNC is due to the synergetic effect between AgWO4 and SWCNT. AWNC shows improved rate capability, better cycling stability, reversible capacity and capacity retention than that of AWN. These results suggest that AWNC is an exciting anode material for LIB. © 2020 Informa UK Limited, trading as Taylor & Francis Group.