Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item Monoclinic Wolframite ZnWO4/SiO2 nanocomposite as an anode material for lithium ion battery(Elsevier B.V., 2020) Brijesh, K.; Dhanush, P.C.; Vinayraj, S.; Nagaraja, H.S.Herein, we report the preparation and characterization of the ZnWO4 and ZnWO4/SiO2 nanocomposite. The ZnWO4/SiO2 nanocomposite exhibits 570 mAh g?1 discharge capacity and 314 mAh g?1 charge capacity at 10 mA g?1 for the primary cycle. The increasing amount of SiO2 in the ZnWO4/SiO2 nanocomposite increases the overall performance of the composite. The synergetic effect between the ZnWO4 and SiO2 enhances the rate capability, specific capacity, cycle stability and coloumbic efficiency of the composite. The good electrochemical performance of ZnWO4/SiO2 nanocomposite makes it a promising anode for Lithium ion battery. © 2020 Elsevier B.V.Item GeO2/ZnWO4@CNT nanocomposite as a novel anode material for lithium-ion battery(Springer, 2020) Brijesh, K.; Nagaraja, H.S.Single-walled carbon nanotube (SWCNT) wrapped GeO2/ZnWO4 nanocomposite was prepared by single-step solvothermal method. In this work, GeO2/ZnWO4 nanocomposites were prepared by varying the molar percentage of GeO2 and by further adding SWCNT for the composite to boost the electrochemical performance. The prepared GeO2/ZnWO4 nanocomposites and GeO2/ZnWO4@CNT nanocomposite are used as anode material for lithium-ion battery (LIB). As expected, GeO2/ZnWO4@CNT nanocomposite exhibits higher capacities and good rate capability than the GeO2/ZnWO4 nanocomposite. The GeO2/ZnWO4@CNT nanocomposite exhibits 930 mAh g?1 discharge capacity and 533 mAh g?1 charge capacity for the initial cycle at 100 mAh g?1 in the voltage range of 0.01–3 V (vs. Li+/Li). Even at high current density of 500 mAh g?1, GeO2/ZnWO4@CNT nanocomposite shows 231 mAh g?1 and 257 mAh g?1 charge/discharge capacity which are higher than that of GeO2/ZnWO4 nanocomposite. The GeO2/ZnWO4@CNT nanocomposite delivers 75.8% capacity retention and 100% coulombic efficiency even after 400 cycles at 300 mAh g?1. These results direct that GeO2/ZnWO4@CNT nanocomposite is a good negative electrode for lithium-ion battery. [Figure not available: see fulltext.]. © 2020, Springer-Verlag GmbH Germany, part of Springer Nature.Item Fabrication of AgWO4/CNT nanomaterial for high capacity lithium ion battery(Taylor and Francis Ltd., 2022) Brijesh, K.; Prajil, M.K.; Nagaraja, H.S.Herein, we report the synthesis of AgWO4 nanomaterial (AWN) and Single-walled carbon nanotube (SWCNT) wrapped AgWO4 nanomaterial (AWNC) via the solvothermal method and is used as an anode material for lithium-ion battery (LIB). The AWNC exhibits, 1202 mAh g?1 discharge capacity at 0.1 A g?1 current density with good cyclic stability and 100% columbic efficiency even after 500 cycles. The AWNC electrode shows a reversible capacity of 594, 521, 252, 143 and 84 mAh g?1 at 0.1, 0.2, 0.3, 0.5 and 1 A g?1 respectively. The 543 mAh g?1 reversible capacity recovered at 0.1 A g?1 after cycling at several current densities suggests the good rate performance of the AWNC electrode. The decent electrochemical performance of the AWNC is due to the synergetic effect between AgWO4 and SWCNT. AWNC shows improved rate capability, better cycling stability, reversible capacity and capacity retention than that of AWN. These results suggest that AWNC is an exciting anode material for LIB. © 2020 Informa UK Limited, trading as Taylor & Francis Group.Item Mesoporous NiWO4@rGO nanoparticles as anode material for lithium-ion battery(Taylor and Francis Ltd., 2023) Brijesh, B.; Amudha, A.; Mukesh, M.P.; Sagar, L.; Moolayadukkam, S.; Nagaraja, H.S.Herein, we have tried to explore the charge storage properties of mesoporous NiWO4 as an anode in lithium-ion batteries (LIB). A one pot-solvothermal synthesis is used to tweak the properties of mesoporous NiWO4 nanoparticles with reduced graphene oxide (rGO) for the first time and explored the LIB anode applications. Materials are well characterised using structural and morphological characterisations to corroborate the relation between the electrochemical properties and the graphene addition. At 100 mA g−1, the NiWO4@rGO (NWZC) exhibits initial discharge capacity of 1439 mAh g−1, which is more than that of NiWO4 (NWZ). Both NWZ and NWZC display initial coloumbic efficiency of 91.65% and 62.1%. After 500 cycles, the coloumbic efficiency of the NWZ and NWZC is above 99%. The improved lithium-ion storage characteristics of the NWZC may be from the synergetic effect between NiWO4 and r-GO. © 2023 Informa UK Limited, trading as Taylor & Francis Group.Item Impact of copper doping on the electrochemical response of MnSe2 as anode for lithium-ion battery(Springer, 2024) Mukesh, P.; Lakshmi Sagar, G.; Brijesh, K.; Kumawat, S.; Hegde, A.; Kumar, A.; Nagaraja, H.S.Transition Metal Chalcogenides (TMC), due to their unique physicochemical properties, are studied in various fields and have potent applications in energy storage applications. This work is based on the synthesis and characterization of copper-doped manganese di-selenide and the effect of its doping on electrochemical performance as anode material for lithium-ion battery applications using the solvothermal method. The characterization techniques used are X-ray diffraction, Raman spectroscopy, field-emission scanning electron microscopy, XPS, UV–visible absorption spectroscopy, and electrochemical analysis. The XRD data confirms the formation of MnSe2 exhibiting Cubic crystal geometry. The FESEM images show the micro-cube-like structure with agglomerated nanocluster nanostructures on the surface with a dimension of 100–200 nm. The doping of the copper has decreased the band gap of the MnSe2, as studied by the UV–visible absorption spectrum. The electrochemical performance is analyzed as anode material for lithium-ion batteries. The charge/discharge measurements show a specific capacity of 706 mAh g−1 as the initial discharge capacity and 336 mAh g−1 as the initial charge capacity at 0.1 A g−1 current density. Meanwhile, 3% Copper-doped MnSe2 showed a better specific capacity of 878 mAh g−1 as the initial discharge capacity and 461 mAh g−1 as the initial charge capacity at 0.1 A g−1 current density. Cyclic stability, rate capability, and electrochemical impedance spectroscopy were performed, and it shows that 3% copper-doped MnSe2 has good stability and better conductivity and charge kinetics, indicating copper doping has enhanced the electrochemical performance of pristine MnSe2. © The Author(s), under exclusive licence to Springer Science+Business Media, LLC, part of Springer Nature 2024.Item Novel Ag2Cu2O3 nanorods as stable anode material for lithium-ion battery(Elsevier B.V., 2025) Kumar, A.; Sagar G, L.; P, M.; Hegde, A.P.; Nagaraja, H.S.In this research novel Ag2Cu2O3 nanorods was prepared, for lithium-ion battery as anode, using facile co-precipitation method with four different stirring time and correspondingly Ag2Cu2O3 named ACO – 30 M, ACO – 12 H, ACO – 24 H, and ACO – 36 H. Field Emission Scanning Electron Microscopy (FESEM) and High-Resolution Transmission Electron Microscopy (HRTEM) analyze surface and morphology, while X-ray Diffraction (XRD) examines structural properties. Compositional analysis is carried out using X-ray photoelectron spectroscopy (XPS) and Raman spectroscopy. The electrochemical analysis is evaluated by cyclic stability, rate capability, discharge/charge capacity, electrochemical impedance spectroscopy (EIS), and cyclic voltammetry (CV). The ACO – 24 H nanomaterial demonstrates an initial discharge capacity of 943 mAh g?1 at a current density of 50 mA g?1. Among the four materials tested, ACO – 24 H shows superior cycling performance, with a discharge capacity of 174 mAh g?1 at 200 mA g?1 after 1003 cycles. In comparison, ACO – 30 M, ACO – 12 H, and ACO – 36 H exhibit capacities of 134 mAh g?1, 91 mAh g?1, and 43 mAh g?1, respectively, under the same conditions. This study suggests that ACO – 24 H is a promising anode material for lithium-ion battery applications. © 2025 Elsevier B.V.