Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item Combustion characteristics of diesel engine operating on jatropha oil methyl ester(Serbian Society of Heat Transfer Engineers, 2010) Dhananjaya, D.A.; Sudhir, C.V.; Mohanan, P.Fuel crisis because of dramatic increase in vehicular population and environmental concerns have renewed interest of scientific community to look for alternative fuels of bio-origin such as vegetable oils. Vegetable oils can be produced from forests, vegetable oil crops, and oil bearing biomass materials. Non-edible vegetable oils such as jatropha oil, linseed oil, mahua oil, rice bran oil, karanji oil, etc., are potentially effective diesel substitute. Vegetable oils have reasonable energy content. Biodiesel can be used in its pure form or can be blended with diesel to form different blends. It can be used in diesel engines with very little or no engine modifications. This is because it has combustion characteristics similar to petroleum diesel. The current paper reports a study carried out to investigate the combustion, performance and emission characteristics of jatropha oil methyl ester and its blend B20 (80% petroleum diesel and 20% jatropha oil methyl ester) and diesel fuel on a single-cylinder, four-stroke, direct injections, water cooled diesel engine. This study gives the comparative measures of brake thermal efficiency, brake specific energy consumption, smoke opacity, HC, NOx, ignition delay, cylinder peak pressure, and peak heat release rates. The engine performance in terms of higher thermal efficiency and lower emissions of blend B20 fuel operation was observed and compared with jatropha oil methyl ester and petroleum diesel fuel for injection timing of 20° bTDC, 23° bTDC and 26° bTDC at injection opening pressure of 220 bar.Item Evaluation of combustion, performance and emissions of a diesel engine fueled with bio-fuel produced from cashew nut shell liquid(Taylor and Francis Ltd. michael.wagreich@univie.ac.at, 2015) Dinesha, P.; Mohanan, P.Presently, energy security and food security are two major problems of developing countries. The use of edible oils as an alternative fuel for internal combustion may lead to a food crisis. The non-edible plant-based alternative fuel not only results in energy security but also helps to keep the environment free from pollution. In this experimental investigation, a non-edible plant-based bio-fuel cardanol produced from cashew nut shell liquid (CNSL) is used to study the combustion, performance and emissions of a single-cylinder diesel engine. The test conditions of the engine are 200 bar injection pressure and 27.5 degree bTDC injection timing. The bio-fuel blends B10M10 (10% cardanol + 80% diesel + 10% methanol), B20M10, and B30M10 (30% cardanol + 60% diesel + 10% methanol) were tested at 25%, 50%, 75%, and full load conditions. The results were compared with baseline diesel operation. From the experimental work, it was observed that the brake thermal efficiency of B10M10 and B20M10 (20% cardanol + 70% diesel + 10% methanol) is comparatively similar to that of diesel. The lower emissions of CO, hydrocarbon, and smoke are encouraging to recognize B20M10 as an optimized fuel blend for a compression ignition engine at 200 bar injection pressure and 27.5 degree bTDC. The significant factors of cardanol bio-fuel include its low cost, non-edible, abundance, and it is a by-product of the cashew nut industries. © © 2015 Taylor & Francis.Item Cycle by cycle variations of LPG-gasoline dual fuel on a multi-cylinder MPFI gasoline engine(Taylor and Francis Ltd. michael.wagreich@univie.ac.at, 2018) Vighnesha, N.; Shankar, K.S.; Dinesha, P.; Mohanan, P.Combustion stability of a multipoint port fuel injection spark ignition engine working on liquefied petroleum gas (LPG)-gasoline dual fuel mode of operation was analysed. LPG-gasoline ratio was varied from 0 to 100% by controlling the injector signals at wide open throttle condition and 3000 RPM. Increasing LPG ratio will give higher peak pressure and higher indicated mean effective pressure (IMEP) because of the higher flame propagation speed of LPG. The experiment showed that maximum pressure will occur nearer to top dead centre when compared to gasoline. Fluctuation in maximum pressure is higher for LPG and is minimum for 50% LPG. Time return map showed that combustion instabilibity will be more for 100% LPG and is less for 50% LPG. Coefficient of variation of IMEP and maximum pressure for gasoline is higher than LPG. With 100% LPG, NOx emission is almost three times that of gasoline. Hence it can be concluded that 50% LPG will give the better combustion characteristics when compared to other fuel blends. © 2017, © 2017 Informa UK Limited, trading as Taylor & Francis Group.