Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Author: search.filters.author.Manu, B.Subject: search.filters.subject.water treatment

Search Results

Now showing 1 - 3 of 3
  • No Thumbnail Available
    Item
    Degradation of paracetamol in aqueous solution by Fenton Oxidation and photo-Fenton Oxidation processes using iron from Laterite soil as catalyst
    (2011) Manu, B.; Mahamood
    For the treatment of paracetamol in water, the photo-Fenton Oxidation process and Classic Fenton oxidation process have been demonstrated and found effective. An iron catalyst extracted from lateritic soil is used to exhibit the degradation and mineralization of paracetamol. Paracetamol reduction and chemical oxygen demand (COD) removal are measured as the objective functions to be maximized. The experimental conditions of the degradation of paracetamol are optimized by Fenton process. the optimum conditions observed for 10 mg/L initial paracetamol concentration are influent pH 3, initial H 2O 2 dosage 30 mg/L, [paracetamol]/[H 2O 2] ratio 1:3 (w/w) and [H 2O 2] / [Laterite iron] ratio 30:0.75 (w/w). At the optimum conditions, for 10 mg/L of initial paracetamol concentration, 76% paracetamol reduction and 69% COD removal by Fenton oxidation and 79% paracetamol reduction and 77% COD removal by UV-C Fenton process are observed in 120 minutes reaction time. At the above optimum conditions, HPLC analysis has demonstrated 100% removal of paracetamol for Fenton oxidation process in 240 minutes and for UV-C photo- Fenton process in 120 minutes. The methods are effective and they may be used in the paracetamol industry. © 2011 CAFET-INNOVA TECHNICAL SOCIETY.
  • No Thumbnail Available
    Item
    Enhanced degradation of paracetamol by UV-C supported photo-Fenton process over Fenton oxidation
    (2011) Manu, B.; Mahamood, S.
    For the treatment of paracetamol in water, the UV-C Fenton oxidation process and classic Fenton oxidation have been found to be the most effective. Paracetamol reduction and chemical oxygen demand (COD) removal are measured as the objective functions to be maximized. The experimental conditions of the degradation of paracetamol are optimized by the Fenton process. Influent pH 3, initial H 2O 2 dosage 60 mg/L, [H 2O 2]/[Fe 2+] ratio 60 : 1 are the optimum conditions observed for 20 mg/L initial paracetamol concentration. At the optimum conditions, for 20 mg/L of initial paracetamol concentration, 82% paracetamol reduction and 68% COD removal by Fenton oxidation, and 91% paracetamol reduction and 82% COD removal by UV-C Fenton process are observed in a 120 min reaction time. By HPLC analysis, 100% removal of paracetamol is observed at the above optimum conditions for the Fenton process in 240 min and for the UV-C photo-Fenton process in 120 min. The methods are effective and they may be used in the paracetamol industry. © IWA Publishing 2011.
  • No Thumbnail Available
    Item
    Fenton's treatment of actual agriculture runoff water containing herbicides
    (IWA Publishing 12 Caxton Street London SW1H 0QS, 2017) Sangami, S.; Manu, B.
    This research was to study the efficiency of the Fenton's treatment process for the removal of three herbicides, namely 2,4-dichlorophenoxy acetic acid (2,4-D), ametryn and dicamba from the sugarcane field runoff water. The treatment process was designed with the Taguchi approach by varying the four factors such as H 2 O 2 /COD (1-3.5), H 2 O 2 /Fe 2+ (5-50), pH (2-5) and reaction time (30-240 min) as independent variables. Influence of these parameters on chemical oxygen demand (COD), ametryn, dicamba and 2,4-D removal efficiencies (dependent variables) were investigated by performing signal to noise ratio and other statistical analysis. The optimum conditions were found to be H 2 O 2 /COD: 2.125, H 2 O 2 /Fe 2+ : 27.5, pH: 3.5 and reaction time of 135 min for removal efficiencies of 100% for ametryn, 95.42% for dicamba, 88.2% for 2,4-D and with 75% of overall COD removal efficiencies. However, the percentage contribution of H 2 O 2 /COD ratio was observed to be significant among all four independent variables and were 44.16%, 67.57%, 51.85% and 50.66% for %COD, ametryn, dicamba and 2,4-D removal efficiencies, respectively. The maximum removal of herbicides was observed with the H 2 O 2 dosage of 5.44 mM and Fe 2+ dosage of 0.12 mM at pH 3.5. © IWA Publishing 2017 W.