Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
4 results
Search Results
Item Enhanced degradation of paracetamol by UV-C supported photo-Fenton process over Fenton oxidation(2011) Manu, B.; Mahamood, S.For the treatment of paracetamol in water, the UV-C Fenton oxidation process and classic Fenton oxidation have been found to be the most effective. Paracetamol reduction and chemical oxygen demand (COD) removal are measured as the objective functions to be maximized. The experimental conditions of the degradation of paracetamol are optimized by the Fenton process. Influent pH 3, initial H 2O 2 dosage 60 mg/L, [H 2O 2]/[Fe 2+] ratio 60 : 1 are the optimum conditions observed for 20 mg/L initial paracetamol concentration. At the optimum conditions, for 20 mg/L of initial paracetamol concentration, 82% paracetamol reduction and 68% COD removal by Fenton oxidation, and 91% paracetamol reduction and 82% COD removal by UV-C Fenton process are observed in a 120 min reaction time. By HPLC analysis, 100% removal of paracetamol is observed at the above optimum conditions for the Fenton process in 240 min and for the UV-C photo-Fenton process in 120 min. The methods are effective and they may be used in the paracetamol industry. © IWA Publishing 2011.Item Low cost Fenton's oxidative degradation of 4-nitroaniline using iron from laterite(IWA Publishing 12 Caxton Street London SW1H 0QS, 2016) Amritha, A.S.; Manu, B.The present study aims to establish the use of iron (Fe) from larerite in the case of Fenton's oxidation process which is a simple and cost-effective method for degradation of nitro compounds in effluents and in surface or ground water. 4-nitroaniline (4-NA) degradation by Fenton's oxidation method is the subject of the present study so as to optimize pH, hydrogen peroxide/iron (H/F) ratio at different initial concentrations of 4-NA. The optimum pH obtained was 3. The present study has also established optimum H/F ratio for the different initial concentrations of 4-NA for both conventional and use of Fe from laterite. The maximum removal efficiency of 99.84% was obtained for an H/F ratio of 100 for 0.5 mM initial concentration of 4-NA. The study establishes the use of Fe extracted from locally available laterite soil (LS) as a replacement of Fe salts so as to reduce the cost of the process. © 2016 IWA Publishing.Item Fenton's treatment of actual agriculture runoff water containing herbicides(IWA Publishing 12 Caxton Street London SW1H 0QS, 2017) Sangami, S.; Manu, B.This research was to study the efficiency of the Fenton's treatment process for the removal of three herbicides, namely 2,4-dichlorophenoxy acetic acid (2,4-D), ametryn and dicamba from the sugarcane field runoff water. The treatment process was designed with the Taguchi approach by varying the four factors such as H 2 O 2 /COD (1-3.5), H 2 O 2 /Fe 2+ (5-50), pH (2-5) and reaction time (30-240 min) as independent variables. Influence of these parameters on chemical oxygen demand (COD), ametryn, dicamba and 2,4-D removal efficiencies (dependent variables) were investigated by performing signal to noise ratio and other statistical analysis. The optimum conditions were found to be H 2 O 2 /COD: 2.125, H 2 O 2 /Fe 2+ : 27.5, pH: 3.5 and reaction time of 135 min for removal efficiencies of 100% for ametryn, 95.42% for dicamba, 88.2% for 2,4-D and with 75% of overall COD removal efficiencies. However, the percentage contribution of H 2 O 2 /COD ratio was observed to be significant among all four independent variables and were 44.16%, 67.57%, 51.85% and 50.66% for %COD, ametryn, dicamba and 2,4-D removal efficiencies, respectively. The maximum removal of herbicides was observed with the H 2 O 2 dosage of 5.44 mM and Fe 2+ dosage of 0.12 mM at pH 3.5. © IWA Publishing 2017 W.Item Degradation of nitroaromatic compounds: a novel approach using iron from laterite soil(Springer Verlag, 2018) Amritha, A.S.; Manu, B.The Fenton’s oxidation process has been found to be a simple and economical method for the treatment of nitroaromatic compounds in water. In the present study, the iron extracted from the laterite soil was used as a catalyst and optimization of pH, hydrogen peroxide concentration and iron concentration was studied for different initial concentrations of 2-nitroaniline (2-NA), 3-nitroaniline (3-NA) and 4-nitroaniline (4-NA). The optimum pH obtained was 2.5 for 2-NA and 3-NA and 3 for 4-NA. The maximum removal efficiency obtained was 85.3%, 84.3% and 98.7% for 0.5 mM initial concentration at a hydrogen peroxide concentration of 3.5 mM, 4.5 mM and 5 mM for 2-NA, 3-NA and 4-NA, respectively, with a constant iron concentration of 0.05 mM. © 2018, The Author(s).