Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item Degradation of paracetamol in aqueous solution by Fenton Oxidation and photo-Fenton Oxidation processes using iron from Laterite soil as catalyst(2011) Manu, B.; MahamoodFor the treatment of paracetamol in water, the photo-Fenton Oxidation process and Classic Fenton oxidation process have been demonstrated and found effective. An iron catalyst extracted from lateritic soil is used to exhibit the degradation and mineralization of paracetamol. Paracetamol reduction and chemical oxygen demand (COD) removal are measured as the objective functions to be maximized. The experimental conditions of the degradation of paracetamol are optimized by Fenton process. the optimum conditions observed for 10 mg/L initial paracetamol concentration are influent pH 3, initial H 2O 2 dosage 30 mg/L, [paracetamol]/[H 2O 2] ratio 1:3 (w/w) and [H 2O 2] / [Laterite iron] ratio 30:0.75 (w/w). At the optimum conditions, for 10 mg/L of initial paracetamol concentration, 76% paracetamol reduction and 69% COD removal by Fenton oxidation and 79% paracetamol reduction and 77% COD removal by UV-C Fenton process are observed in 120 minutes reaction time. At the above optimum conditions, HPLC analysis has demonstrated 100% removal of paracetamol for Fenton oxidation process in 240 minutes and for UV-C photo- Fenton process in 120 minutes. The methods are effective and they may be used in the paracetamol industry. © 2011 CAFET-INNOVA TECHNICAL SOCIETY.Item Optimization of Fenton’s oxidation of herbicide dicamba in water using response surface methodology(Springer Verlag, 2017) Sangami, S.; Manu, B.In this study Fenton’s oxidation of dicamba in aqueous medium was investigated by using the response surface methodology. The influence of H2O2/COD (A), H2O2/Fe2+ (B), pH (C) and reaction time (D) as independent variables were studied on two responses (COD and dicamba removal efficiency). The dosage of H2O2 (5.35–17.4 mM) and Fe2+ (0.09–2.13 mM) were varied and optimum percentage removal of dicamba of 84.01% with H2O2 and Fe2+ dosage of 11.38 and 0.33 mM respectively. The whole oxidation process was monitored by high performance liquid chromatography (HPLC) along with liquid chromatography/mass spectrometry (LC/MS). It was found that 82% of dicamba was mineralized to oxalic acid, chloride ion, CO2 and H2O, which was confirmed with COD removal of 81.53%. The regression analysis was performed, in which standard deviation (<4%), coefficient of variation (<8), F value (Fisher’s Test) (>2.74), coefficient of correlation (R2 = Radj2) and adequate precision (>12) were in good agreement with model values. Finally, the treatment process was validated by performing the additional experiments. © 2017, The Author(s).Item Evaluation of pyrolyzed areca husk as a potential adsorbent for the removal of Fe2+ ions from aqueous solutions(Academic Press, 2019) Sheeka Subramani, B.; Shrihari, S.; Manu, B.; BabuNarayan, K.S.[No abstract available]