Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item Improved electrochemical performance of graphene oxide supported vanadomanganate (IV) nanohybrid electrode material for supercapacitors(Elsevier Ltd, 2020) Kumari, S.; Maity, S.; Anandan Vannathan, A.A.; Shee, D.; Das, P.P.; Mal, S.S.Graphene oxide (GO)-supported polyoxometalates (POMs) have been considered as promising electrode materials for energy storage applications due to their ability to undergo fast and reversible redox reactions. Herein, vanadomanganate-GO composites (K7MnIVV13O38.18H2O-GO with 2:1 and 4:1 ratio) were investigated for use as potential electrode materials in supercapacitors (SCs). The K7MnIVV13O38.18H2O (MnV13) was synthesized and anchored on GO through electron transfer interaction and electrostatic interaction to make the composite electrodes for the present study. All synthesized electrode materials were fully characterized by various techniques, e.g., Fourier Transform Infrared (FTIR) Spectroscopy, Powder X-ray Diffraction (XRD), Scanning Electron Microscopy/Energy Dispersive X-ray Spectroscopy (SEM/EDS) and High Resolution-Transmission Electron Microscopy (HR-TEM). The electrochemical properties of MnV13/GO composites with different MnV13/GO ratios were investigated by two-electrode cyclic voltammetry (CV) and galvanostatic charge/discharge (GCD) in different electrolytes. The MnV13/GO composite of ratio 2:1 in 1 M LiCl electrolyte and that of ratio 4:1 in 1 M Na2SO4 electrolyte showed significant specific capacitance values of 269.15 F/g and 387.02 F/g, respectively and energy density of 37.38 Wh/kg and 53.75 Wh/kg, respectively for a scan rate of 5 mV/s. Interestingly, the 1:1 (MnV13/GO) composite in 1 M Na2SO4 and 1 M LiCl electrolytes showed very low specific capacitance values as the deposition of MnV13 on GO was not sufficient, as indicated by FTIR and SEM. Thus, it is evident that the specific capacitance value of these composite materials depends on the amount of MnV13 deposited on GO and these composite materials exhibit the potential to improve the performance of GO-based SCs. © 2019Item In situ vanadophosphomolybdate impregnated into conducting polypyrrole for supercapacitor(Elsevier Ltd, 2020) Anandan Vannathan, A.A.; Maity, S.; Kella, T.; Shee, D.; Das, P.P.; Mal, S.S.The fast modernization and advancement in lifestyle increase the consumption of power daily due to all innovative technologies, e.g., hybrid vehicles, solar cells, smart power grid, communication devices, artificial hearts, etc. Conducting organic polymer-based energy storage devices had attracted much attention due to the conductive nature for a long time. However, its application has been restricted because of swelling and shrinking capability during the charge and discharge cycle. The combination of redox-active inorganic metal oxides, such as polyoxometalates (multi-metal oxide cluster) with conduction polymers, could enhance the material's stability due to its fast multi-electron redox property. Here, we report the two polypyrroles combined vanadophosphomolybdates, namely PPy-H4[PVMo11O40] and PPy-H5[PV2Mo10O40] nanohybrid electrode materials. The PPy-H5[PV2Mo10O40] electrode material behaves as pseudocapacitance and can deliver an excellent capacitance of 561.1 F/g in 0.1 M H2SO4 electrolyte solution at a 0.2 A/g current density, indicating capacitive composite material. The electrochemical impedance spectroscopy (EIS) reveals that PPy-H5[PV2Mo10O40] is more capacitive than PPy-H4[PVMo11O40] and PPy with equivalent series resistance (ESR) of 5.74 ?. The cell capacitance of PPy-H5[PV2Mo10O40] and PPy-H4[PVMo11O40] are found to be 5.38 and 9.15 mF, stipulating in small SC cell application. Likewise, the PPy-H5[PV2Mo10O40] nanohybrid electrode shows better responsive behavior with a relaxation time of 0.16 ms. Furthermore, the PPy-H5[PV2Mo10O40] electrode exhibits outstanding cycle stability, retaining ~95% of its capacitance after 4500 cycles as compare to PPy-H4[PVMo11O40] (~91%) electrode. © 2020Item Enhanced Power Density of Graphene Oxide–Phosphotetradecavanadate Nanohybrid for Supercapacitor Electrode(Springer, 2021) Maity, S.; Anandan Vannathan, A.A.; Kumar, K.; Das, P.P.; Mal, S.S.Successful exploration of supercapacitor (SC) material to integrate with high energy and high power density storage device still remains a daunting challenge. Conducting carbon nanostructures have been primarily used for this purpose; however, most of their surface area remains unutilized throughout the storage process. Herein, a new type of hybrid material has been reported by effectively using active sides of carbon nanostructures. Insertion of faradaic-type polyoxometalates (POMs), namely phosphotetradecavanadate (Na7[H2PV14O42], hereafter described as PV14), into the graphene oxide (GO) matrix creates a novel hybrid material for SC applications. Owing to the formation of nanohybrid, it can store charges both electrostatically and electrochemically. PV14/GO composite’s electrochemical behavior in different electrolyte (acidic/neutral) solutions shows different types of characteristics. The PV14/GO composite as a working electrode exhibits a high galvanostatic capacitance of 139 F/g while maintaining at a power density of 97.94 W/kg in 0.25 M H2SO4 electrolyte. The specific energy density was also found out to be around 56.58 Wh/kg at a 5 mV/s scan rate for the same electrolyte. Furthermore, in 1 M Na2SO4 solution, PV14/GO composite demonstrates a specific capacitance of 85.4 F/g at a scan rate of 5 mV/s. The equivalent series resistance for the device was found to be approximately 0.51 ? with a circuit resistance of 3.881 ?, using electrochemical impedance spectroscopy. The cell capacitance, employing the Nyquist plot, was calculated to be around 2.78 mF. © 2021, ASM International.Item Activated carbon- supported Vanado-nickelate (IV) based hybrid materials for energy application(Elsevier Ltd, 2021) Maity, S.; BM, N.; Kella, T.; Shee, D.; Das, P.P.; Mal, S.S.The rapid development of supercapacitor (SC) technology leads to increased demand for nanofabrication of novel and effective electroactive hybrid materials for next-generation energy storage devices. Herein, nickel tetradecavanadate, K2H5[NiV14O40](NiV14), is doped into porous activated carbon (AC), for the first time, in different wt.% in order to investigate the homogeneous loading of the inorganic metal-oxide component on the AC matrix. The resulting complex, AC-NiV14, is found to have possessed an enhanced electrochemical characteristic (for both symmetric and asymmetric SC cell), which operates at a significantly higher potential of 1.2 V. The combination of the double-layer capacitance (EDLC) and the redox-active polyoxometalate cluster leads to an intrinsic increase in specific capacitance (capacity) (from 45.3 Fg?1 (54.4 Cg?1) for AC to 316 Fg?1 (379.2 Cg?1) for 15 wt.% AC-NiV14 at a current density of 1 Ag?1). It was also observed that there is an increase of 20% in the operating voltage compared to conventional AC supercapacitors with acidic aqueous electrolytes. Firstly, symmetric supercapacitor's electrochemical performances of various wt.% of NiV14 composition were studied in acidic aqueous electrolyte (0.5 M H2SO4) solution. We observed that the 15 wt.% of AC-NiV14 hybrid electrode showed remarkable specific energy value (~63.2 Wh kg?1) compared with pristine AC and NiV14 electrodes, separately. Besides, the asymmetric layout (AC//AC-NiV14) increased the potential window up to 1.5 V and enhanced the specific energy and power values (90.1 Whkg?1 and 2400 Wkg?1, respectively), with 98% coulombic efficiency. Meanwhile, the AC-NiV14//NiV14 asymmetric cell possesses a specific capacitance (capacity) of 375 Fg?1 (450 Cg?1) with a maximum power of 3140 Wkg?1 at the high current density of 2 Ag?1. © 2021 Elsevier LtdItem Electrochemical performance of activated carbon-supported vanadomolybdates electrodes for energy conversion(Elsevier Ltd, 2021) Maity, S.; Anandan Vannathan, A.; Kella, T.; Shee, D.; Das, P.P.; Mal, S.Reinforcing polyoxomolybdates (POMs) into the activated carbon (AC) template engenders a nanohybrid electrode material for high-performance supercapacitor applications. Herein, a first-time novel integration of two polyoxometalates ([PVMo11O40]4-, [PV2Mo10O40]5-) with AC has been demonstrated, and their structural and electrochemical performances were analyzed. AC-VMo11 composite displayed an enhanced capacitance of 450 Fg-1 with an improved energy density of 59.7 Whkg-1. Furthermore, the symmetric supercapacitor cell for AC-VMo11 and AC-V2Mo10 showed high cell capacitances of 38.8 and 20.01 mF, respectively, alongside 99.99% capacitance retention of over 5000 cycles. In addition, the influence of ionic liquid as an electrolyte on AC-V2Mo10 based supercapacitor cell was investigated in tetrabutylammonium bromide (TBAB) electrolyte solution. © 2021 Elsevier Ltd and Techna Group S.r.l.Item Fabrication of supercapacitor electrode material using carbon derived from waste printer cartridge(Springer Science and Business Media Deutschland GmbH, 2024) Biradar, B.R.; Maity, S.; Chandewar, P.R.; Shee, D.; Das, P.P.; Mal, S.S.Transforming recyclable materials into a suitable product is an important area of research nowadays. This report demonstrates that carbon material derived from waste printer cartridges can be exploited to fabricate electrochemical cells—particularly supercapacitors (SCs). SCs are electrochemical energy storage devices currently attracting much attention in the research community due to their salient features, such as cost-effectiveness, extended cycle stability, and durability. Here, we report the results of thoroughly examining the effects of acidic, basic, and neutral aqueous electrolytes on printer waste carbon electrode material in SC efficiency. In our work, the waste carbon collected from used printer cartridges shows a specific capacitance of 178.4 F/g with energy and power density of 24.77 Wh/kg and 999.68 W/kg, respectively, at 0.5 A/g current density in acidic (1 M H2SO4) electrolyte medium. Moreover, it exhibited very promising capacitance of 135.04 F/g and 87.04 F/g in basic (1 M LiOH) and neutral (1 M NaCl) electrolyte medium, respectively, at 0.8 A/g current density with considerably better cycle stability. In an acidic medium, printer waste carbon drives a DC motor for 1 min with a three-cell series arrangement. The properties of that waste carbon (extracted from the cartridges) are similar to high-rate activated carbon available commercially. Graphical Abstract: (Figure presented.). © The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature 2024.