Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
5 results
Search Results
Item Reusable floating polymer nanocomposite photocatalyst for the efficient treatment of dye wastewaters under scaled-up conditions in batch and recirculation modes(John Wiley and Sons Ltd vgorayska@wiley.com Southern Gate Chichester, West Sussex PO19 8SQ, 2019) Das, S.; Mahalingam, H.BACKGROUND: In the last decade, research on floating photocatalysts has increased rapidly with polymer substrates being a popular choice. However, most of the published work is on very small volumes and there is very little work on scale-up of such systems. RESULTS: Polystyrene–titanium dioxide nanocomposite floating films were prepared using a facile solvent casting method and tested for the photocatalytic degradation of four different dyes under UV irradiation. The prepared film was characterised by Fourier-transform infrared (FTIR), scanning electron microscopy (SEM), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), inductively coupled plasma optical emission spectrometry (ICP-OES) and profilometry. Scale-up studies were done in batch mode under optimised conditions, and for the larger reactor volume, the effect of recirculation was studied. Complete decolourisation of the model dye (Remazol Turquoise Blue) was observed within 80 min in the scaled-up batch process. In the recirculation mode, for a much larger volume of the dye solution, around 75% decolourisation in 6 h was observed. The reusability of the photocatalytic film was tested, and the results promise a minimum decolourisation efficiency of around 70%. Finally, total organic carbon (TOC) and liquid chromatography mass spectrometry (LC-MS) analysis were used to assess the degradation of the dye. The maximum TOC reduction observed was around 25% possibly due to the complex nature of the dye used in this study. The intermediate products of degradation were identified, and a tentative mechanism is suggested. CONCLUSION: This work demonstrates the recirculation aspects of the photocatalytic reactor under the scaled-up conditions for a complex dye. The prepared film showed excellent stability with satisfactory wastewater decontamination under UV irradiation even after repeated use. © 2019 Society of Chemical Industry. © 2019 Society of Chemical IndustryItem Exploring the synergistic interactions of TiO2, rGO, and g-C3N4 catalyst admixtures in a polystyrene nanocomposite photocatalytic film for wastewater treatment: Unary, binary and ternary systems(Elsevier Ltd, 2019) Das, S.; Mahalingam, H.Reduced graphene oxide (rGO) as well as graphitic carbon nitride (g-C3N4) were synthesised and blended along with TiO2 at specific ratios in polystyrene photocatalytic films to find out the optimum efficiency. The prepared photocatalysts were characterised by scanning electron microscopy (SEM-EDX), X-ray diffraction (XRD), Fourier transform infrared spectra (FTIR) and contact angle analyser. The SEM, XRD, and FTIR analysis indicated that the nanoparticles were evenly distributed on the surface of the polystyrene film. The stability of the polymer film with respect to possible leaching of the embedded catalyst particles was evaluated by ICP-OES analysis. The photocatalytic activity of the admixture was evaluated using remazol turquoise blue dye as a model organic pollutant, and it was found that the photocatalytic ternary admixtures displayed much higher photocatalytic activity (99%) than the unary (89%) or binary (94%) mixtures indicating the synergistic effect of these catalysts. The effect of catalyst ratio, immobilisation, pH, initial dye concentration, irradiated light source, the presence of H2O2 and reusability of the film were also evaluated. The degradation of the dye is confirmed by TOC analysis (40% reduction), and HPLC/MS was used to identify the final degraded compounds. © 2019 Elsevier Ltd.Item Dye degradation studies using immobilized pristine and waste polystyrene-TiO2/rGO/g-C3N4 nanocomposite photocatalytic film in a novel airlift reactor under solar light(Elsevier Ltd, 2019) Das, S.; Mahalingam, H.Complex dyes are not completely removed in most wastewater treatment plants and thus released into nearby waterbodies posing problems to aquatic life and humans. In this study, a chemically synthesized nanocomposite photocatalyst containing TiO2, rGO and g-C3N4 immobilized in a polystyrene film is evaluated for the degradation of the Cu-phthalocyanine complex dye (Remazol Turquoise Blue, RTB) in a multiphase airlift reactor under sunlight. Both pristine and waste polystyrene were used in the synthesis of the film. The characterisation of the powder photocatalyst composite as well as the immobilized photocatalyst film is performed using particle size analyzer, SEM-EDX, BET, XRD, XPS, FTIR, and ICP-OES. The optimization of various parameters affecting the photocatalytic decolourization such as the g-C3N4 quantity in the composite catalyst, catalyst loading, the initial concentration of dye, use of waste polystyrene and catalyst reuse has been studied thoroughly. The photocatalytic treatment of RTB dye under optimum conditions for 90min shows that the decolourization (60%) and degradation (51.43%) as measured by TOC analysis are quite similar. The possible breakdown compounds from the parent molecule after the photocatalytic operation are identified by HPLC-MS. In conclusion, the immobilized nano-composite photocatalyst incorporated into a multiphase airlift reactor, is a very promising system to improve the water quality by TOC reduction, before discharge to nearby natural water sources. © 2019 Elsevier Ltd.Item Novel immobilized ternary photocatalytic polymer film based airlift reactor for efficient degradation of complex phthalocyanine dye wastewater(Elsevier B.V., 2020) Das, S.; Mahalingam, H.Reduced graphene oxide (rGO) as well as graphitic carbon nitride (g-C3N4) catalysts were synthesized and a physical admixture of rGO and g-C3N4 along with TiO2 in the ratio of 1:1:1 by weight was immobilized in a polystyrene film using the facile solvent casting method. An internal loop airlift reactor with a working volume of 1.2 litres incorporating the prepared polymer-based photocatalytic film was designed and tested for the photocatalytic degradation of remazol turquoise blue dye synthetic wastewater. The reactor parameters affecting the photocatalytic activity such as airflow rate and Di/Do (ratio of draft tube diameter to outer tube diameter) were evaluated. The successful operation of the reactor obtained using the ternary immobilized catalyst mixture film gave 92.25% total organic carbon reduction and 94% decolourization within 140 min, compared to 91% decolourization by the slurry form within 40 min. Complete and quicker decolourization of the dye was also demonstrated under the influence of O3 or H2O2. The immobilized catalyst was successfully reused four times. The ternary catalyst admixture employed in this work and the unique design of the photocatalytic reactor helps to increase the degradation rate of toxic textile effluents thus making it suitable for larger scales of treatment. © 2019 Elsevier B.V.Item Upcycling of waste EPS beads to immobilized codoped TiO2 photocatalysts for ciprofloxacin degradation and E. coli disinfection under sunlight(Nature Research, 2023) Manjunatha, M.; Mahalingam, H.The emerging global problem of antimicrobial resistance needs immediate attention. In this regard, this work demonstrates the use of expanded polystyrene waste in the synthesis of immobilized photocatalytic films for the treatment of antibiotics as well as for bacterial disinfection. A boron–cerium codoped TiO2 catalyst (of specific composition: B0.8Ce0.2TiO2) was immobilized in an expanded polystyrene (EPS) film prepared from waste EPS beads. These films were studied for the degradation of ciprofloxacin (CIP) and disinfection of E. coli under sunlight. The film with a catalyst loading of 20 wt% showed a maximum degradation of 89% in 240 min with a corresponding TOC reduction of 84%. A 7.4 and 6.3 log reduction from the bacterial inactivation studies in the presence and absence of antibiotics, respectively, was obtained. The EPS film was stable after five times of reuse, and no significant chemical changes in the used film were observed from FTIR analysis. The average thickness of the prepared film was found from FESEM analysis to be 1.09 mm. These EPS films were also tested for degradation of other antibiotics, such as norfloxacin, levofloxacin and moxifloxacin. The EPS films were tested in two different reactor volumes at optimum conditions. Also, the effectiveness of B0.8Ce0.2TiO2/EPS film in real water samples indicates its potential in large-scale and real-world applications. Thus, these B0.8Ce0.2TiO2/EPS films can be effectively employed for both degradation of ciprofloxacin and the disinfection of E. coli under solar light to solve the increasing problem of antimicrobial resistance. © 2023, Springer Nature Limited.