Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Author: search.filters.author.Kuntikana, P.Subject: search.filters.subject.Heat flux distributions

Search Results

Now showing 1 - 2 of 2
  • No Thumbnail Available
    Item
    Effect of preheated mixture on heat transfer characteristics of impinging methane-air premixed flame jet
    (Elsevier Ltd, 2015) Tajik, A.R.; Kuntikana, P.; Prabhu, S.V.; Hindasageri, V.
    Energy from spent flame or other low grade energy can be used to increase the temperature of the air before mixing with fuel. This would improve the heat transfer characteristics of the impinging flame jet. The studies on impinging flame jets reported in the literature are based on the fuel-air mixture at ambient temperature. In the present work, the inlet air for mixture is heated by an electrical heater. The heat flux distribution is estimated using an inverse heat conduction (IHCP) technique. The Nusselt number (Nu) and effectiveness (?) distributions are obtained by estimating the adiabatic wall temperature (Taw) by the analytical-numerical method. A circular burner of 13.5 mm is used for impingement on quartz plate of 3 mm thickness. Reynolds number (Re) varying from 500 to 2000 for the non-dimensional burner tip to impingement plate spacing (Z/d) of 2-6 and stoichiometric condition (Ø = 1.0) is considered for varying preheated condition. The effect of equivalence ratio is studied for Ø = 0.75 to 1.5 for Re = 1000 and Z/d = 4. By increase in preheat temperature, the stagnation point heat flux increases from 20% to 50% unless the inner premixed zone touches the impingement plate. CFD simulations are carried out in FLUENT software to explain the distribution of heat flux. © 2015 Elsevier Ltd. All rights reserved.
  • No Thumbnail Available
    Item
    Axis switching in impinging premixed methane-air flame jets
    (Elsevier Ltd, 2016) Hindasageri, V.; Kuntikana, P.; Tajik, A.R.; Vedula, R.P.; Prabhu, S.V.
    Axis switching in non-circular tube burner flame jets is studied. Experimental data of heat flux is obtained for square and rectangular burners of different aspect ratios: 1, 1.55, 2.1 and 3.73. A three dimensional CFD simulation is carried out to explain the phenomenon of axis switching in premixed flame jets. From the CFD simulations it is observed that the vortices formed near the corner of the tube exit are responsible for the axis switching phenomenon. These vortices control the spreading (in a preferential manner) of the flame jet along the tube axis. This preferential spreading of the flame jet is responsible for switching of contours of heat flux on the impingement plate. Furthermore, for the rectangular burner, elliptical lobes of heat flux distribution on the impingement plate are observed and this is again attributed to vortex structures. © 2016 Elsevier Ltd