Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
7 results
Search Results
Item Influence of spark timing on the performance and emission characteristics of gasoline–hydrogen-blended high-speed spark-ignition engine(Taylor and Francis Ltd. michael.wagreich@univie.ac.at, 2017) Shivaprasad, K.V.; Chitragar, P.R.; Nayak, V.; Kumar, G.N.This article experimentally investigates the effect of spark timing on performance and emission characteristics of high-speed spark-ignition (SI) engine operated with different hydrogen–gasoline fuel blends. For this purpose, the conventional carbureted SI engine is modified into an electronically controllable engine, wherein an electronically controllable unit was used to control the ignition timings and injection duration of gasoline. The tests were conducted with different spark timings at the wide open throttle position and 3000 rpm engine speed. The experimental results demonstrated that brake mean effective pressure and engine brake thermal efficiency increased first and then decreased with the increase in spark advance. Peak cylinder pressure, temperature and heat release rate were increased until 20% hydrogen addition and with increased spark timings. NOx emissions were continuously increased with the increment in both spark timings and hydrogen addition, whereas hydrocarbon emissions were increased with spark timings but decreased with hydrogen addition. CO emissions were reduced with the increase in spark timing and hydrogen addition. © 2016 Informa UK Limited, trading as Taylor & Francis Group.Item Effect of exhaust gas recirculation on a CRDI engine fueled with waste plastic oil blend(Elsevier Ltd, 2018) Ayodhya, A.S.; Lamani, V.T.; Bedar, P.; Kumar, G.N.The inevitable rise in the usage of plastic poses a serious threat to the environment owing to their non-biodegradable nature. The lack of proper infrastructure for treating and recycling plastic wastes give rise to the disposal problem. However, the oil synthesized from these waste plastics can be used as an alternative fuel for C.I engines which not only helps to tackle the disposal problem but also aids in recovering precious energy from these wastes. This experimental investigation aims to study the effects of plastic-diesel blend(P30) fuel on the performance, emission and combustion characteristics of a twin cylinder CRDI engine operating at different EGR rates (0%, 10% and 20%). The experimental results showed a slight drop in the engine performance while operating with plastic blend, mainly overall due to its higher viscosity and lower heating value. The vast upsurge of NOX emissions with plastic blend was mitigated by the aid of EGR methodology. Marginal increase in the discharge of regulated emissions like HC, CO and soot were noticed for both plastic blend as well as EGR operations. The experiments were carried out for five different loading conditions varying from 0% to 80% in steps of 20% each and found out that waste plastic-diesel blend can be successfully used as an alternative fuel in diesel vehicles without any prior modifications in the engine. © 2018 Elsevier LtdItem Combustion, performance, and tail pipe emissions of common rail diesel engine fueled with waste plastic oil-diesel blends(American Society of Mechanical Engineers (ASME) infocentral@asme.org, 2018) Lamani, V.T.; Yadav, A.K.; Kumar, G.N.The demand for plastic is eternally growing in urban areas and producing enormous quantity of plastic waste. The management and disposal of plastic waste have become a major concern worldwide. The awareness of waste to energy retrieval is one of the promising modes used for the treatment of the waste plastic. The present investigation evaluates the prospective use of waste plastic oil (WPO) as an alternative fuel for diesel engine. Different blends (WPO0, WPO30, and WPO50) with diesel are prepared on a volume basis and the engine is operated. Experiments are conducted for various injection timings (9 deg, 12 deg, 15 deg, and 18 deg BTDC) and for different exhaust gas recirculation (EGR) rates (0%, 10%, 15%, and 20%) at 100 MPa injection pressure. Combustion, performance, and tail pipe emissions of common rail direct injection (CRDI) engine are studied. The NOx, CO, and Soot emissions for waste plastic oil-diesel blends are found more than neat diesel. To reduce the NOx, EGR is employed, which results in reduction of NOx considerably, whereas other emissions, i.e., CO and Soot, get increased with increase in EGR rates. Soot for WPO-diesel blends is higher because of aromatic compounds present in plastic oils. Brake thermal efficiency (BTE) of blends is found to be higher compared to diesel. © 2018 by ASME.Item Effect of bioethanol–diesel blends, exhaust gas recirculation rate and injection timing on performance, emission and combustion characteristics of a common rail diesel engine(Taylor and Francis Ltd. michael.wagreich@univie.ac.at, 2019) Lamani, V.T.; Baliga M, A.U.; Yadav, A.K.; Kumar, G.N.This investigation is focused on the effect of exhaust gas recirculation (EGR) and injection timing on the performance, combustion and exhaust emission characteristics of common rail direct injection (CRDI) engine fueled with bioethanol-blended diesel using computational fluid dynamics (CFD) simulation. Simulation is carried out for various EGR rates (0, 10, 20 and 30%), two different injection timings, and two different bioethanol–diesel blends (10 and 20%) at injection pressure. The equivalence ratio is kept constant in all the cases of bioethanol–diesel blends. The results indicate that the mean CO formation and ignition delay increase, whereas mean NO formation and in-cylinder temperature decrease, with increase in the EGR rate. Further, with an increase in percentage of the bioethanol blends, CO and soot formation decrease as compared to neat diesel. A significant increase in in-cylinder pressure (15%) is found at 14° before top dead centre (BTDC) compared to 9° BTDC, which leads to an increase in indicated thermal efficiency of 4% for neat diesel at 30% EGR. In the present study, maximum indicated thermal efficiency is obtained in the case of 10 and 20% bioethanol–diesel blend, and remains constant for all EGR rates considered in the study. Obtained results are validated with the available literature data and indicate good agreement. © 2017, © 2017 Informa UK Limited, trading as Taylor & Francis Group.Item Effect of injection pressure on the performance and emission characteristics of the CI engine using Vateria indica biodiesel(Taylor and Francis Ltd. michael.wagreich@univie.ac.at, 2019) Rao, G.; Kumar, G.N.; Herbert, M.A.Vateria indica Linn seeds were found to contain nearly 19% of oil/fat content. This fat is converted into biodiesel by a novel method by the authors at the biodiesel preparation facility at NITK, Surathkal, India. As biodiesel is a promising alternative fuel for petro diesel in compression ignition (CI) engines, this biofuel is tested in a single-cylinder diesel engine. The objective of this work is to find combustion, performance and emission characteristics of a CI engine with diesel and blends of V. indica biodiesel at 180, 200 and 220 bar injection pressures. Blending is done in volumetric ratios of 10%, 15%, 20% and 25% of biodiesel with diesel which are called as B10, B15, B20 and B25. The idea of increasing fuel injection pressure is to promote atomisation and full penetration into the combustion chamber leading to better combustion. Blend B25 showed best thermal efficiency of the order of 33.03% and the least NOX emission of 1047 ppm at 220 bar injection pressure at 75% load. © 2018, © 2018 Informa UK Limited, trading as Taylor & Francis Group.Item Impact of changing compression ratio on engine characteristics of an SI engine fueled with equi-volume blend of methanol and gasoline(Elsevier Ltd, 2020) Nuthan Prasad, B.S.; Pandey, J.K.; Kumar, G.N.In the present investigation, experiments were conducted in wide open throttle condition (WOT) for different speed ranging from 1200 rpm to 1800 rpm at an interval of 200 on a single-cylinder four-stroke variable compression ratio (VCR) SI engine. The engine fueled with equi-volume blend of methanol/gasoline fuel, while 14° BTDC ignition timing is maintained for all three different compression ratios (8, 9 & 10). Increasing the compression ratio from CR8 to CR10 for the methanol/gasoline blend has improved combustion efficiency by increasing the peak pressure and net heat release value by 27.5% and 30% respectively at a speed of 1600 rpm. The performance results show a good agreement of improvisation of 25% increase in BTE, and BSFC reduction by 19% at compression ratio 10:1. At higher compression ratio 10:1, there was a significant decrease observed in CO and HC by 30–40%, and the same trend is observed at all speeds; however, NOx emission increased with the increasing CR. © 2019 Elsevier LtdItem Effect of hydrogen enrichment on performance, combustion, and emission of a methanol fueled SI engine(Elsevier Ltd, 2021) Nuthan Prasad, B.S.; Pandey, J.K.; Kumar, G.N.The study of potentially high rated alternative fuel (Methanol) for the IC engines is an exciting topic in the recent research advancement. However, the study of combination of methanol and hydrogen is considered to address both economic and environmental needs. Hydrogen with best combustion characteristics will compensate for the drawbacks of methanol as a fuel. In the present investigation hydrogen enrichment to methanol has shown a significant enhancement in performance and combustion; the overall emission has reduced substantially. The experiments for a different set of trials, including hydrogen enrichment ranging between 5% and 20% with 2.5% increment, the engine is operated with wide-open throttle (WOT) condition for different speeds. The increase in enrichment of hydrogen has shown a rise in BTE, BP, and a reduced BSEC value. The percentage increase in BTE is between 20 and 30%, and an increase in hydrogen beyond 12.5% would affect the volumetric efficiency, and thus performance declines after that. The exhaust emissions have a huge impact on hydrogen enrichment; CO, HC, and CO2 emission are reduced by 30–40%; however, an increase in cylinder temperature due to rapid combustion slightly increases the NOx emission. Thus hydrogen enriched methanol operating at higher compression ratio can improve the overall engine characteristics significantly. © 2021 Hydrogen Energy Publications LLC