Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
7 results
Search Results
Item Effect of exhaust gas recirculation (EGR) on diesel engine using Simarouba glauca biodiesel blends(Regional Energy Resources Information Center (RERIC) enreric@ait.ac.th, 2015) Bedar, P.; Pandey, J.K.; Kumar, G.N.This article deals with the usage of non-edible Simarouba glauca (paradise) oil as a biodiesel for single cylinder diesel engine with application of exhaust gas recirculation (EGR) rates. Biodiesel blends B10, B20 with EGR rates of 10%, 15%, and 20% are used for different load conditions. Parameters like brake thermal efficiency (BTE), nitrogen oxides (NOx), carbon monoxide (CO), hydrocarbons (HC) and smoke opacity were evaluated from the experimental study. The results show that Simarouba glauca biodiesel usage decreases HC, CO and smoke emissions with slight increase of NOx, also an improvement in the performance was observed for B10 blend. EGR rates 10% and 15% are beneficiated in terms of performance and emission but negative trend is observed for 20% EGR rate. On the whole it is concluded that a better trade-off between NOx and other emissions is attained with simultaneous application of EGR (15%) and biodiesel blend (B10) without compromising engine performance.Item Combustion, performance, and tail pipe emissions of common rail diesel engine fueled with waste plastic oil-diesel blends(American Society of Mechanical Engineers (ASME) infocentral@asme.org, 2018) Lamani, V.T.; Yadav, A.K.; Kumar, G.N.The demand for plastic is eternally growing in urban areas and producing enormous quantity of plastic waste. The management and disposal of plastic waste have become a major concern worldwide. The awareness of waste to energy retrieval is one of the promising modes used for the treatment of the waste plastic. The present investigation evaluates the prospective use of waste plastic oil (WPO) as an alternative fuel for diesel engine. Different blends (WPO0, WPO30, and WPO50) with diesel are prepared on a volume basis and the engine is operated. Experiments are conducted for various injection timings (9 deg, 12 deg, 15 deg, and 18 deg BTDC) and for different exhaust gas recirculation (EGR) rates (0%, 10%, 15%, and 20%) at 100 MPa injection pressure. Combustion, performance, and tail pipe emissions of common rail direct injection (CRDI) engine are studied. The NOx, CO, and Soot emissions for waste plastic oil-diesel blends are found more than neat diesel. To reduce the NOx, EGR is employed, which results in reduction of NOx considerably, whereas other emissions, i.e., CO and Soot, get increased with increase in EGR rates. Soot for WPO-diesel blends is higher because of aromatic compounds present in plastic oils. Brake thermal efficiency (BTE) of blends is found to be higher compared to diesel. © 2018 by ASME.Item Impact of 1-Hexanol/diesel blends on combustion, performance and emission characteristics of CRDI CI mini truck engine under the influence of EGR(Elsevier Ltd, 2020) Santhosh, K.; Kumar, G.N.Biofuels are the most promising sustainable and renewable alternative to diesel fuel. In the present renewable energy world, alcohols are gaining prime importance due to their nature of production and fuel properties. The present work aims to investigate the impact of 1-Hexanol and exhaust gas recirculation (10% and 20%) on engine characteristics of the common rail direct injection compression ignition engine. The experiment is carried out on a bench engine. The fraction of 1-Hexanol is varied from 10% to 40% in a step of 10% by volume. The results demonstrate that the use of 1-Hexanol/diesel blends lowers the cylinder pressure and mean gas temperature, which is 4.25% and 1.88% lower at 60% load for 40% 1-Hexanol compared to neat diesel fuel operation. The combustion duration is increased by 2.66?CA for 40% 1-Hexanol at 60% load compared to neat diesel fuel. However, an improvement in net heat release rate is noted which is 13.95% higher at 60% load for 40% 1-Hexanol, this increment is due to prolonged ignition delay. With the use of 1-Hexanol in the engine, there is a drastic reduction in nitrogen oxide emission is observed, this is the greatest impact of 1-Hexanol. However, a slight increment in the hydrocarbon and carbon monoxide emission is also noted due to poor fuel properties like lower cetane number, higher viscosity and higher latent heat of evaporation of 1-Hexanol. Compared to all other blends in the test 10% 1-Hexanol shows comparable results with pure diesel fuel, which is only 2.37% lower in brake thermal efficiency, 3.6% higher in brake specific fuel consumption, 17.55% lower in nitrogen oxide emission, 18.18% higher in hydrocarbon and 33.33% higher in carbon monoxide emission is noted. The exhaust gas recirculation helps in reducing the NOx emission, 40% 1-Hexanol is less sensitive to exhaust gas recirculation. Up to 40% of 1-Hexanol can be used in the CI engine without any modification. It is concluded that 1-Hexanol is a sustainable renewable biofuel due to the reason that even though the use of 1-Hexanol lowers the performance which helps in reducing the NOx emission greatly; the performance can be improved by modifying the engine parameters. © 2020 Elsevier LtdItem Investigation of preheated Dhupa seed oil biodiesel as an alternative fuel on the performance, emission and combustion in a CI engine(Elsevier Ltd, 2021) Kodate, S.V.; Satyanarayana Raju, P.; Yadav, A.K.; Kumar, G.N.The present study investigates the suitability of preheated Vateria indica methyl ester (VIME) as an alternative fuel for a diesel engine. VIME is a renewable, non-toxic and sustainable alternative biodiesel obtained from Dhupa fat by transesterification. This study aims to evaluate the combustion, performance, and emission characteristics of four different blends such as B0 (0% VIME and 100% mineral diesel), B30, B50 and B100 at elevated fuel inlet temperatures ranging from 35 °C to 95 °C. The tests are carried out in a single cylinder diesel engine at optimum loading condition and fixed speed. Results are obtained in terms of brake thermal efficiency (BTE), brake specific fuel consumption (BSFC), in-cylinder pressure, heat release rate and exhaust emissions (CO, HC, NOX, CO2 and soot). It is observed that the preheating of blends decreases the viscosity which enhances fuel spray characteristics, leading to higher engine performance, lower CO and HC emissions with a slight increase in NOX and CO2 emissions. BTE and peak in-cylinder pressure for B100 at 95 °C and 75% load are increased by 7.44%, 2.97% respectively compared to unheated B100 biodiesel. BSFC, CO, HC emissions at 75% load for B100 at 95 °C are reduced by 26.73%, 28.08%, 42.7% respectively compared to unheated B100. © 2021 Elsevier LtdItem Effect of parallel LPG fuelling in a methanol fuelled SI engine under variable compression ratio(Elsevier Ltd, 2022) Dinesh, M.H.; Pandey, J.K.; Kumar, G.N.In the present experimental study, five LPG fractions from 25% to 45% based on total energy are tested in a methanol fuelled SI engine at compression ratios (CR) varying from 12 to 15. Results are affirmative towards methanol/LPG dual fuel. The brake power, brake thermal efficiency, and volumetric efficiency are found to increase by 51%, 21.2%, and 13% respectively by changing from 25% LPG fraction at CR12 to 45% LPG fraction at CR15. The flame development period is found to decrease with CR and LPG, while the flame propagation period and total combustion duration are found to decrease with CR but increase with LPG. The maximum cylinder pressure and net heat release rate are found to increase by 101% and 27.8% respectively and advanced. CO emissions are found to decrease with CR while increase with LPG fraction. HC is found to decrease with LPG as well as CR. CO2 emissions are found to increase continuously with increasing LPG fractions and CR. The NOx emissions are also found to increase explicitly with LPG and CR, a net 209% increase in it is found 25% LPG at CR 12–45% LPG at CR15. © 2021 Elsevier LtdItem Effects of hydrogen assisted combustion of EBNOL IN SI engines under variable compression ratio and ignition timing(Elsevier Ltd, 2022) Pandey, J.K.; Kumar, G.N.Alcohols are oxygenated fuels, holding a good reputation among alternatives, but single alcohol does not possess all qualities. Besides, the high latent heat and low vapor pressure limit their uses in SI engines. Hence, an energy enhancing and combustion promoting fuel helps overcome the drawbacks, among all available hydrogen fits the race most. Hence, hydrogen-assisted combustion of equivolume blend of ethanol/butanol (ENBOL) is experimentally tested under various compression ratios (CR) (11–15), ignition timing (16°CA-24°CA BTDC) for three hydrogen fractions (5%–15%) at three speeds (1400RPM-1800RPM). The experimental outcome notices an increase in brake power (BP), brake thermal efficiency (BTE), peak pressure (Pmax), heat release rate (HRRmax), and NOx emissions with increasing CR and Hydrogen addition. The combustion duration, CO, and UBHC emissions reduce while CO2 emissions reduce with hydrogen; increasing CR notices a drop in CO2 at a much advanced or much-delayed ignition. Hydrogen improves combustion but reduces volumetric efficiency; increasing CR improves it, and hydrogen effect reduces with increasing CR. BP, BTE, and CA10-90 improve with retarding ignition from 24°CA, while CA10, Pmax, and HRRmax reduce continuously. UBHC and CO emissions increase while NOx reduces with retarding ignition. The ignition timing of 20°CA at CR15 and 15% hydrogen performed better than gasoline. © 2022 Elsevier LtdItem Study of combustion and emission of a SI engine at various CR fuelled with different ratios of biobutanol/hydrogen fuel(Elsevier Ltd, 2023) Pandey, J.K.; Kumar, G.N.The global requirement is shifting to territorial independence of energy sources, and the introduction of alcohols and biofuels are the primary sectors. Recently agriculture products-based ethanol has replaced a larger portion of gasoline. Butanol is another impressive fuel in the same chain, much better than ethanol in many parameters. Butanol has certain limitations, too, such as higher latent heat and low heating value. Therefore, biobutanol/hydrogen is tested experimentally at various compression ratios (CR) in the present study. Brake thermal efficiency was not significantly changed by CR at 90% butanol, while CR is more impressive with increasing hydrogen. The flame development period was reduced by 34%, while the flame propagation phase was reduced by 29% by increasing CR to 15 and hydrogen to 25%. Peak pressure and heat release rate surged by 12.89% and 12.32% and advanced by 6°CA. The coefficient of variations is also reduced by 21% by increasing CR to 15 and hydrogen to 30%. Higher hydrogen faced combustion difficulties due to increasing stratification and heterogeneity during combustion. Unlikely to trend, Tmax (peak cylinder temperature) and NOx were continuously increased with CR and hydrogen due to increased fuel quantity and larger mass burning before TDC. However, CO and HC emissions were reduced by CR due to increased BTE (brake thermal efficiency) and reduced by hydrogen due to less HC supply. A slight increase in HC and CO was noticed for higher hydrogen due to local heterogeneity and disassociation at high temperatures. © 2023 Hydrogen Energy Publications LLC