Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
4 results
Search Results
Item A Mechanistic Study on the Structure Formation of NiCo2O4 Nanofibers Decorated with In Situ Formed Graphene-Like Structures(Springer New York LLC barbara.b.bertram@gsk.com, 2018) Kumar, B.; Gudla, V.C.; Ambat, R.; Kalpathy, S.K.; Anandhan, S.Nickel cobaltite (NCO) nanofibers were synthesized using poly(styrene-co-acrylonitrile) (SAN) as the polymeric binder through sol–gel assisted electrospinning. Defect-free precursor nanofiber mats were pyrolyzed at 773 K at three different pyrolysis soaking times t = 2, 4, and 6 h. The SAN present in the precursor nanofibers caused morphological changes in the NCO nanofibers during their thermochemical degradation. Consequently, fractal aggregates of NCO nanoparticles were formed along the length of the nanofibers. X-ray photoelectron spectroscopy (XPS) revealed both + 2 and + 3 oxidation states for Ni and Co, with spinel crystal defects due to oxygen rich atmosphere. XPS, high-resolution transmission microscopy, and optical analysis showed graphene-like structures embedded within the NCO nanofibers. With increase in pyrolysis soaking time, the morphology of the NCO particles markedly changed from spherical to rod-like. We propose a mechanism for the morphological change of NCO nanoparticles on the basis of crystallite splitting accompanied by particle splitting and reordering. © 2018, Springer Science+Business Media, LLC, part of Springer Nature.Item Polymorph nickel titanate nanofibers as bifunctional electrocatalysts towards hydrogen and oxygen evolution reactions(Royal Society of Chemistry, 2019) Kumar, B.; Tarafder, K.; Shetty, A.R.; Hegde, A.C.; Gudla, V.C.; Ambat, R.; Kalpathy, S.K.; Anandhan, S.Producing pure H2 and O2 to sustain the renewable energy sources with minimal environmental damage is a key objective of photo/electrochemical water-splitting research. Metallic Ni-based electrocatalysts are expensive and eco-hazardous. This has rendered the replacement or reduction of Ni content in Ni-based electrocatalysts a decisive criterion in the development of bifunctional electrocatalytic materials. In the current study, spinel/ilmenite composite nickel titanate (NTO) nanofibers were synthesised using sol-gel assisted electrospinning followed by pyrolysis at different soaking temperatures (viz., 773, 973, and 1173 K). The presence of a defective spinel NTO phase (SNTO) distributed uniformly along the nanofibers was confirmed by X-ray photoelectron and Raman spectroscopy. The electron micrographs revealed the morphological change of NTO nanofibers from a mosaic to bamboo structure with an increase in pyrolysis soaking temperature. The electrocatalytic activity of NTO nanofibers obtained at different pyrolysis soaking temperatures for alkaline water-splitting was studied. The highly defective SNTO manifests properties similar to metallic Ni and favours H2 evolution through the hydrogen evolution reaction (HER) by adsorbing more H+ ions on active sites. In contrast, the ilmenite NTO favours O2 discharge. These results are explained based on the morphology of the NTO nanofibers. The mosaic structure which has higher porosity and greater SNTO content shows excellent HER performance. In contrast, the large bamboo structured NTO nanofibers which have lesser porosity and SNTO content cage the bigger (OH)ads ions at their catalytic sites to facilitate OER performance. 2019 © The Royal Society of Chemistry.Item Magnetic behavior of polymorph composite nickel titanate nanofibers(Royal Society of Chemistry, 2021) Kumar, B.; Dhanasekhar, C.; Anandhan, S.; Kalpathy, S.K.Polymorph (spinel/ilmenite) composite nanofibers of nickel titanate (NTO) were prepared by a sol-gel assisted electrospinning process followed by pyrolysis using the styrene-acrylonitrile copolymer as a precursor at three different pyrolysis soaking temperatures (i.e. T= 773, 973, and 1173 K). The magnetic behavior of these composite NTO nanofibers was studied under isothermal and non-isothermal conditions in the temperature range of 20-300 K. The magnetic parameters such as coercivity (Hc), remanence (Mr), and saturation magnetisation (Ms) were found to be strongly dependent onT. The highestHcandMrwere observed for NTO nanofibers developed at 973 K, which have a mosaic structured morphology with spinel and ilmenite NTO crystallite sizes of ~39 nm and ~24 nm, respectively. On the other hand, the highestMsand switching field distribution were observed for mosaic structured NTO nanofibers having smaller crystallites (~13 nm and 24 nm for spinel and ilmenite NTO, respectively, with high inter-particle distance and high porosity) developed at 773 K, which are also rich in spinel NTO content. The correlation between the variation in magnetic behavior and structural/morphological features of NTO nanofibers is useful for NTO-based soft magnetic and multiferroic applications. © The Royal Society of Chemistry and the Centre National de la Recherche Scientifique 2021.Item Understanding the interplay of solution and process parameters on the physico-chemical properties of ZnO nanofibers synthesized by sol-gel electrospinning(Institute of Physics, 2023) Prabhu, N.N.; Rajendra, B.V.; Anandhan, S.; Murthy, K.; Jagadeesh Chandra, R.B.; George, G.; Kumar, B.; Shivamurty, B.Aging populations and the increase in chronic diseases worldwide demand efficient healthcare tools for simple, rapid, and accurate diagnosis and monitoring the human health. In this context, gas sensors are used to analyze the type of gas in the breath to diagnose chronic diseases. Metal oxide and ceramic nanofibers (NFs) produced by the electrospinning (ES) method have been investigated for potential use as gas sensors in the engineering and medical sectors. The material and process parameters are the main influencing factors on the functional performance of electrospun metal oxide NFs. Zinc oxide (ZnO) based NFs are used in various gas sensors due to the wide band gap (3.37eV), large exciton binding energy, and high mobility of charge carriers of ZnO. In this research, we made an attempt to study the effect of poly(vinyl alcohol) (PVA) and zinc acetate dihydrate (ZnAc2) concentrations and feed rate, voltage, spinneret tip-to-collector distance (TCD), and pyrolysis temperature on the physical properties of ZnO NFs. An average fiber diameter of 119 nm was obtained after pyrolysis at 600 °C of electrospun fiber produced from an aqueous PVA solution of concentration 15 w% with 7.5 w% ZnAc2 based on the weight of PVA. The grain size, transmittance, structural defects, and band gap energy of NFs were found to increase as a function of the pyrolysis temperature, which could be beneficial for the functional applications of these NFs. © 2023 The Author(s). Published by IOP Publishing Ltd