Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
2 results
Search Results
Item Dual storage mechanism of Bi2O3/Co3O4/MWCNT composite as an anode for lithium-ion battery and lithium-ion capacitor(Elsevier B.V., 2024) Lakshmi Sagar, G.; Brijesh, K.; Mukesh, P.; Hegde, A.P.; Kumar, A.; Kumar, A.; Bhat, K.S.; Nagaraja, H.S.Bismuth oxide(Bi2O3) and cobalt oxide(Co3O4) are promising owing to their unique properties, high storage capacity, low cost, and eco-friendliness, making them ideal for lithium-ion batteries(LIBs) and lithium-ion capacitors(LICs) anodes. This study presents the synthesis and thorough characterization of Bi2O3/Co3O4 and Bi2O3/Co3O4/MWCNT composites as potential LIB and LIC anode materials. The materials are synthesized using a hydrothermal process succeeded by annealing. Structural, morphological, and compositional studies were analyzed. Various tests evaluated electrochemical performance, including cyclic voltammetry(CV), confirming a dual storage mechanism like alloying and conversion reaction involved for better energy storage. Specific discharge capacities of 834 mAh/g and 1184 mAh/g were recorded for Bi2O3/Co3O4 and Bi2O3/Co3O4/MWCNT composite electrodes at a current density of 100 mA/g, respectively. The composite material exhibited notably enhanced rate capability, with 31 % and 51 % discharge capacities for Bi2O3/Co3O4 and Bi2O3/Co3O4/MWCNT, respectively. The cyclic stability assessment revealed that Bi2O3/Co3O4 and Bi2O3/Co3O4/MWCNT maintained a high coulombic efficiency of around 99 % over 250 charge–discharge cycles at a high current density of 1 A/g. The capacity retention was approximately 253 mAh/g for Bi2O3/Co3O4 and 439 mAh/g for the Bi2O3/Co3O4/MWCNT composite, indicating excellent cyclic stability and minimal energy loss during cycling. Moreover, the LICs assembly of Bi2O3/Co3O4/MWCNT//CB was investigated, revealing a power density of 200 W kg?1 alongside an energy density of 8.64 Wh kg?1. The cyclic stability assessment over 10,000 cycles exhibits a capacity retention of approximately 45 % under a high current density of 2 A/g. © 2024 Elsevier B.V.Item Insights into the potential of Sb alloyed Cu2AgBiI6-based solar cells: For efficient indoor energy-harvesting(Elsevier Ltd, 2025) Kumar, A.; Siddharth, G.; Dwivedi, P.; Pandey, S.K.; Sengar, B.S.; Garg, V.Recently, indoor photovoltaics have attracted significant attention due to their remarkable capability to generate power from indoor light sources. This work investigates the performance of perovskite-inspired material Sb alloyed Cu2AgBiI6 (CABI-Sb) based indoor photovoltaic device, which has shown a power conversion efficiency of 9.53 %, reported in a recent experimental study by B. Al-Anesi et al. The baseline model of the CABI-Sb device structure (FTO/TiO2/CABI-Sb/Spiro-OMeTAD/Au) is developed in SCAPS-1D using the earlier reported experimental data. Baseline model parameters under WLED illumination are Jsc: 128.2 µA/cm2, Voc: 0.51 V, FF: 66.57 %, and PCE: 9.53 %, with a minor deviation of less than 1 %, which validates the developed model with experimental data. The performance of the device is fine-tuned by optimizing 1) Absorber thickness and defect density 2) Electron Transport Layer (ETL) doping density, conduction band offset (CBO) and interface defect density between the ETL/absorber (TiO2 /CABI-Sb) interface, 3) Hole Transport Layer (HTL) doping density, valence band offset (VBO) and interface defect density between HTL/absorber (CABI-Sb/Spiro-OMeTAD) interface, 4) work function of contacts, and 5) Series and shunt resistance were optimized. The performance parameters of the optimized device under the WLED illumination are Jsc: 1.84 mA/cm2, Voc: 1.60 V, FF: 86.78 %, and PCE: 49.31 %. A remarkable improvement in PCE is achieved from 9.53 % to 49.31 %. Further, to validate the suitability of the optimized device under different indoor environments, optimized device performance is evaluated under different lux intensities of WLED (6500 K), WLED (2700 K), compact fluorescent light (CFL), and halogen. © 2024 International Solar Energy Society