Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
Search Results
Item Pseudoelastic Behavior of Boron-Doped ?1 -Type Cu-Al-Be Shape Memory Alloys(Springer, 2021) Kalinga, T.; Murigendrappa, S.M.; Kattimani, S.This paper examines the influence of 0-0.2 wt.%B-doping on the microstructure, mechanical properties, and pseudoelastic behavior of Cu-Al11.5-Be0.57 shape memory alloys (SMAs). This microstructure study reveals that the addition of boron leads to significant grain refinement in ?1-type polycrystalline Cu-Al-Be SMAs. A maximum refinement size of 50 µm was achieved with the addition of 0.15 wt.%B. The fine-grained (Cu-Al11.5-Be0.57)-B0.15 SMA with serrated grain boundaries exhibited the maximum enhancement of ultimate tensile strength, 744.65 ± 29.34 MPa, and ductility of 21.93 ± 0.56%. The fracture morphology revealed the transformation of intergranular to transgranular fracture in the SMAs with boron-doping. Maximum pseudoelasticity of 4% was achieved in the SMA with 0.15 wt.%B and suits as a damper in seismic applications. © 2021, ASM International.Item An experimental evaluation of the microstructure, mechanical and functional fatigue properties of the boron-doped Cu-Al-Be SMA wires(Elsevier Ltd, 2021) Singh, R.K.; Biswas, P.; Murigendrappa, S.M.; Kattimani, S.An experimental evaluation of the microstructure, mechanical and functional fatigue properties of the Cu-11.70Al-0.45Be doped with Bx (x = 0.05, 0.10, 0.12, and 0.14 wt%) SMA wires has been carried out. The experiments were performed to investigate microstructure, phase/precipitates, and transformation temperatures for both as-cast and wire samples. Furthermore, tensile properties, shape recovery ratio, and functional fatigue evaluation have also been carried out for the wire samples. The investigation shows that the addition of the minor amount of boron and secondary processes involved during the specimen preparation induced excellent grain refinement. The addition of boron decreased transformation temperatures; however, there was not a considerable change observed due to the secondary process. It was observed that tensile properties increases with the boron addition, and complete shape recovery was observed for all the selected alloys. Finally, functional fatigue tests were conducted under constant stress condition and observed that the number of cycles until the failure has increased and more distance recovery was achieved with an increase in boron doping. © 2021