Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
4 results
Search Results
Item Improvement in Harmonic Reduction of a Zigzag Autoconnected Transformer Based 12-Pulse Diode Bridge Rectifier by Current Injection at DC Side(Institute of Electrical and Electronics Engineers Inc., 2017) Vidyasagar, V.; Kalpana, R.; Singh, B.; P, P.P.In this paper, to improve the harmonic reduction ability in the input line current of a 12-pulse diode bridge rectifier using zigzag autoconnected transformer with a dc side current injection technique is presented. Conventional 12-pulse rectifier does not meet the IEEE-519 standard and therefore current injection technique at dc side is used to shape the converter current to minimize the harmonic distortion in the input line current. The proposed converter configuration uses a zigzag autoconnected transformer with inherent ability to block zero-sequence components, which eliminates the requirement of a zero-sequence blocking transformer, and thereby reduces the overall rating of the converter. The current injection technique at dc side enables to alter the dc side currents, which further shapes the input line currents to near sinewave with total harmonic distortion of less than 1% and power factor close to unity. The proposed converter configuration is simulated and analyzed in MATLAB/Simulink. The effects of variation in the magnitude of injected current on the input line current harmonics in terms of power quality indices are analyzed. A prototype of the proposed converter configuration is developed, and experimental results are presented to validate the theoretical design, analysis, and simulation results. © 1972-2012 IEEE.Item A 20-Pulse Asymmetric Multiphase Staggering Autoconfigured Transformer for Power Quality Improvement(Institute of Electrical and Electronics Engineers Inc., 2018) P, P.; Kalpana, R.; Singh, B.; Bhuvaneswari, G.This letter presents a 20-pulse multiphase staggering autoconfigured transformer (MSAT) for power quality improvement in medium and high power applications. The proposed autoconfigured transformer is a combination of delta and zig-zag transformers. Contrary to the prior art multipulse autoconnected transformers, magnetic rating of the proposed configuration is only 40% of the load rating in addition to improved power quality indices. Moreover, the creation of a neutral point ascribed to inbuilt zig-zag windings supplements as one of the remarkable advantages of the proposed MSAT. Therefore, with this suggested configuration, the performance of zig-zag transformer is accomplished within the autoconfigured transformer. A detailed comparison of the proposed MSAT configuration with that of other multipulse autoconnected transformers in terms of magnetic rating and power quality indices are presented. Further, the feasibility and operability of the proposed MSAT are verified and validated through experimental tests on the laboratory prototype. The test results so obtained complies with the IEEE-519 and IEC 61000-3-2 standards on power quality requirements. © 2017 IEEE.Item Power Quality Enhancement Using Current Injection Technique in a Zigzag Configured Autotransformer-Based 12-Pulse Rectifier(Institute of Electrical and Electronics Engineers Inc., 2018) Kalpana, R.; Chethana, K.S.; P, P.; Singh, B.This paper proposes a DC-side circuit configuration that improves the harmonic suppression ability of a 12-pulse diode bridge rectifier (DBR) using a zigzag configured autotransformer. The DC-side circuit uses a single-phase DBR along with interphase transformer which generates the required circulating current thereby modifies the DC currents at the DBR output, in turn shapes the input line current near to a sine wave. The proposed single-phase DBR is connected in parallel with the load which enables to reuse the harmonic energy thus improving the energy conversion efficiency. The zigzag configured autotransformer used for 12-pulse DBR possesses the inbuilt ability to hinder the zero-sequence components, which expel the need of zero sequence blocking transformer. The proposed configuration is analyzed, simulated in MATLAB Simulink and the simulation results are presented, which confirm the reduction of total harmonic distortion (THD) in the input line current thereby improving the power quality under large load variations. Furthermore, the viability of the proposed configuration is verified by experimental results, which confirm the suitability of the proposed configuration in industrial applications. © 1972-2012 IEEE.Item Control of Converter for a Solar PV-BESS Powered Telecom Load With Real, Reactive and Harmonic Power Exchange With Grid(Institute of Electrical and Electronics Engineers Inc., 2023) Sheeja, V.; Kalpana, R.; Subramaniam, U.; Almakhles, D.J.Due to safety considerations and the challenges involved in tracking the maximum output of series-connected cells, solar photovoltaic (PV) arrays are generally operated at lower voltage levels. A multiport converter can be used to interface telecom DC loads, typically rated at 48 V and powered by PV arrays and battery energy storage system (BESS). The grid integration of the system improves reliability while lowering the BESS rating. This work proposes a sliding mode control-based power flow management controller that maintains the load voltage of a telecom DC load, allows maximum power extraction from the PV module, and facilitates power sharing with AC grid. A voltage source converter and a high-gain bidirectional converter exchange power with the AC grid. A second-order generalized integral algorithm-based voltage source converter control is provided to inject/absorb active power, reactive power, and eliminate the harmonics of the telecom AC load. Detailed simulation studies employing MATLAB software are performed to validate the functionality of the converter as well as the power flow management control. Moreover, the system's performance is evaluated using a laboratory-developed experimental prototype. © 2013 IEEE.