Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
2 results
Search Results
Item Heat transfer distribution of impinging flame and air jets - A comparative study(Elsevier Ltd, 2016) Kadam, A.R.; Tajik, A.R.; Hindasageri, V.Heat transfer distribution of impinging flame jet is compared with that of the impinging air jet based on the experimental data reported in literature for methane-air flame jet and air jet impingement for Reynolds number, R=600-1400 and the non-dimensional nozzle tip to impingement plate distance, Z/d=2-6. The comparative data based on mapping experimental data reported in literature suggest that there is a good agreement between the Nusselt numbers for higher Z/d near stagnation region. However, away from the stagnation region, the Nusselt number for flame jet is higher than that of air jet for similar operating conditions of Re and Z/d. A CFD simulation for impinging air jet and impinging flame jet is carried out to explain the physics and reason for the deviations observed in experimental data. A scale analysis is carried out to identify the dominant forces and their influence on the heat transfer distribution on the impingement plate. © 2015 Elsevier Ltd. All rights reserved.Item Inverse estimation of heat transfer coefficient and reference temperature in jet impingement(American Society of Mechanical Engineers (ASME), 2020) Kadam, A.R.; Hindasageri, V.; Kumar, G.N.Applications of impinging jets are wide-ranging from cooling to heating in industrial as well as domestic field. Most of the reported heat transfer distribution data to and from impinging jets have been found from steady-state measurements. This study utilizes the solution to three-dimensional (3D) inverse heat conduction problem to estimate transient temperatures on the impingement side. Then, the temperature gradient is determined near the impingement wall (×0.01mm inside) with which transient heat flux is estimated on the impingement side. Instead of steady-state values, transient heat flux and corresponding wall temperatures are utilized in a thin foil technique to find out heat transfer coefficient and reference temperature simultaneously. The scope of the present technique is examined through its application to impinging jets with various configurations such as laminar jet, turbulent jet, hot jet, cold jet, and multiple jets. In all cases, estimations are reasonably close. The application of this inverse technique can be extended to any configuration of jet impingement irrespective of geometry of nozzle (circular/rectangular), the orientation of nozzle (orthogonal/inclined), the temperature of a jet (hot/cold), Reynolds numbers (laminar/turbulent), the nozzle-to-plate spacing (any Z/d), and roughness of the plate surface. The effect of plate thickness on the accuracy of the present technique is also studied. Up to 5mm thick plates can be used in impinging jet applications without worrying much on accuracy. The use of the present technique significantly reduces the experimental cost and time since it works on transient data of just a few seconds. © © 2020 by ASME.