Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
2 results
Search Results
Item Optimum design of heat exchanging device for efficient heat absorption using high porosity metal foams(Elsevier Ltd, 2021) Jadhav, P.H.; Gnanasekaran, N.The present research provides a numerical assessment of waste heat recovery system which contains high porosity metal foam that absorbs heat from the hot flue gases. Top wall of the heat exchanging device is designed as a sinusoidal corrugated/wavy wall. Three different wavelengths (Lw) of 39, 24.375 and 17.728 mm and three different wave amplitudes (a) of 0.5, 1.0 and 1.5 mm along with various heights of metallic foam of 0.25H, 0.5H and 0.75H are considered. Two different pore density of 20 and 40 with constant porosity of 0.937 are accomplished for the numerical investigation over wide range of fluid velocities. Local thermal equilibrium (LTE) and Darcy extended Forchheimer (DEF) models are employed at the metallic foam region; k-? turbulence model is accomplished at free flow region of the channel. The heat dissipation rate at the cold wall increases significantly to a maximum height of 0.5H and increases with increasing wave amplitudes of the channel at the expense of pressure drop. On account of smaller wavelength and higher wave amplitude, the heat absorption rate is found to be 26.25% - 32% more than the straight channel with 25% filling rate of metallic foams in the range of fluid velocity considered. © 2021 Elsevier LtdItem Analysis of functionally graded metal foams for the accomplishment of heat transfer enhancement under partially filled condition in a heat exchanger(Elsevier Ltd, 2023) Jadhav, P.H.; Gnanasekaran, N.; Mobedi, M.The use of partially filled high porosity graded aluminum and copper foams is explored to satisfy both heat transfer and pressure drop in a heat exchanger. Both positive and negative orientations are accomplished for the enhancement of heat transfer with reduction in the pressure drop. The present research includes three different configurations M1, M2 and M3 (porous layer inner diameter = 0.06 m, 0.04 m, and 0.02 m, respectively, while outer diameter = 0.10 m) partially filled with positive (i.e., increasing, 20/45 PPI) negative (i.e., decreasing, 45/20 PPI) and compound (i.e., 45 Cu/20 Al PPI) graded porous layer thickness. Each configuration involves three different graded porous layer to present the optimum graded porous layer thickness. The thermo-hydrodynamic characteristics are apprehended by using Darcy Extended Forchheimer (DEF) flow and local thermal non-equilibrium (LTNE) models for the partially filled graded porous structure and k-ω turbulence model is accomplished in open passage flow of the conduit. The decreasing graded foam located inside the models M1 and M2 performed 1.68%–12.85% and 13.42%–23.32% higher heat transfer rate compared to without graded metal foam of models M2 and M3, respectively accompanied with 55.43%–84.02% and 35.69%–50.31% lesser pumping power. © 2022 Elsevier Ltd