Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item New polypropylene supported chitosan NF-membrane for desalination application(2011) Padaki, M.; Isloor, A.M.; Fernandes, J.; Prabhu, K.N.In the present study, a new NF membrane was prepared by coating chitosan on polypropylene fiber support, by the dissolution of chitosan in 2% acetic acid solution. The resulting membrane was characterized by thermo gravimetric analysis, water absorption, contact angle measurement and scanning electron microscopy. Prepared membrane showed two Tg peaks, one at ~90 °C that was due to chitosan and the other peak at ~170 °C that was corresponding to the supporting polypropylene membrane. The membrane showed a low swelling ratio at pH 7, 9, and 11 as compared with pH 5. The performance of the membrane was assessed out using dead end cell. Water flux was studied at different pressures. The salt rejection study was done using NaCl solution and the effect of pH on performance of the membrane was also examined. Newly prepared membrane showed improved water flux, and % of rejection is highest in acidic pH and lowest in basic pH. Hydrulic permeability coefficient and the dielectric constant confirms that the prepared membrane is nanofiltration membrane. © 2011 Elsevier B.V.Item Synthesis and characterization of schiff base metal complexes and reactivity studies with malemide epoxy resin(Korean Chemical Society sunlee@kcsnet.or.kr, 2012) Lakshmi, B.; Shivananda, K.N.; Prakash, G.A.; Isloor, A.M.; Mahendra, K.N.A novel malemide epoxy containing Co(II), Ni(II) and Cu(II) ions have been synthesized by curing malemide epoxy resin (MIEB-13) and Co(II), Ni(II) and Cu(II) complexes of macrocyclic bis-hydrazone Schiff base. The Schiff base was synthesized by reacting 1,4-dicarbnyl phenyl dihydrazide with 2,6-diformyl-4-methyl phenol. The Schiff base and its Co(II), Ni(II) and Cu(II) complexes have been characterized by elemental analyses, spectral (IR, 1H NMR, UV-vis., FAB mass, ESR), thermal and magnetic data. The curing reaction of maleimide epoxy compound with metal complexes was studied as curing agents. The stability of cured samples was studied by thermo-gravimetric analyses and which have excellent chemical (acid/alkali/solvent) and water absorption resistance. Further, the scanning electron microscopy (SEM) and definitional scanning colorimetric (DSC) techniques were confirmed the phase homogeneity of the cured systems.Item Photoreactor-ultrafiltration hybrid system for oily bilge water photooxidation and separation from oil tanker(Elsevier, 2016) Moslehyani, A.; Mobaraki, M.; Isloor, A.M.; A.F., A.F.; Othman, M.H.D.A novel design of hybrid system consisting of photoreactor (PR) combined with ultrafiltration (UF) membrane was investigated for oily bilge water degradation and separation from oil tanker. Initially, the bilge organic compounds were photooxidized using ultraviolet type A (UVA) light irradiation on 100, 200 and 300 ppm of TiO2. Further TiO2 and oxidized oily bilge water was filtered using hollow fiber membrane separator, which was prepared by polyvinylidene fluoride (PVDF) and halloysite nanotubes. The hollow fiber membranes were characterized by ATR-IR spectrum, thermal gravimetric analysis (TGA), X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM) and X-ray photoelectron spectroscope (XPS). Individual hydrocarbon of oily bilge water was identified by using gas chromatography-mass spectrometry (GC-MS) analysis. According to the GC-MS analysis, over 90% decomposition of oil in bilge water has occurred by 200 and 300 ppm of TiO2 suspension. On the other hand, pH meter showed that, decomposed oily bilge water was more acidic, which increased to pH 7 after UF system process. Moreover, over 99% of degraded oil in bilge water was filtered by this promising hybrid system. © 2016 Elsevier B.V. All rights reserved.Item Improved separation of dyes and proteins using membranes made of polyphenylsulfone/cellulose acetate or acetate phthalate(Springer Science and Business Media Deutschland GmbH, 2020) Kumar, M.; Isloor, A.M.; Todeti, S.R.; Gnani Peer Mohamed, G.P.S.; Siddique, I.; A.F., A.F.; Asiri, A.M.Industrial wastewater often contains xenobiotics such as heavy metals, dyes and proteins, yet there is a lack of efficient cleaning methods. Therefore, here we fabricated hollow fiber membranes using polyphenylsulfone containing 1, 3 and 5 wt% of cellulose acetate and cellulose acetate phthalate by non-solvent induced phase separation. Membrane morphology was characterized by field emission scanning electron microscopy. The hydrophilicity of the membranes was measured by contact angle, water uptake and porosity measurement. The thermal miscibility of the membrane with additives was assessed by thermogravimetric analysis. Hollow fiber membranes were tested for separation of azo dyes, e.g., reactive orange 16 and reactive black 5, and of proteins: bovine serum albumin, egg albumin and pepsin. Results show increasing rejection of dyes and proteins with the content of cellulose acetate and cellulose acetate phthalate. Water permeability was 41.26 L/m2 h bar for the polyphenylsulfone membrane, 64.47 L/m2 h bar for the polyphenylsulfone/5 wt% cellulose acetate membrane and 72.60 L/m2 h bar for the polyphenylsulfone/5 wt% cellulose acetate phthalate membrane. © 2020, Springer Nature Switzerland AG.Item Effect of binary zinc-magnesium oxides on polyphenylsulfone/cellulose acetate derivatives hollow fiber membranes for the decontamination of arsenic from drinking water(Elsevier B.V., 2021) Kumar, M.; Isloor, A.M.; Todeti, S.R.; Nagaraja, H.S.; A.F., A.F.; Susanti, R.Arsenic contamination is continuously threatening the safety of drinking water in many parts of the world. The consumption of chronic arsenic contaminated drinking water can cause serious health related issues. Therefore, the synthesis of novel materials is very much essential for the selective removal of arsenic from aqueous solution. In the present investigation, the effect of increased concentrations (0.6, 1.0 and 1.5 wt%) of binary zinc-magnesium oxide (ZnO-MgO) on cellulose acetate (CA)/polyphenylsulfone (PPSU) and cellulose acetate phthalate (CAP)/PPSU hollow fiber membranes for arsenic removal was performed. As used ZnO-MgO was characterized by using x-ray diffraction (XRD), transmission electron microscopy (TEM) and particle size distribution. Fabricated hollow fiber membranes were characterized using scanning electron microscopy (SEM), atomic force microscopy (AFM), zeta potential, fourier transform infrared (FTIR), x-ray photoelectron spectrophotometer (XPS), thermogravimetric analysis (TGA) and antifouling studies. The results revealed that, there is significant enhancement in the overall performance of the ZnO-MgO containedmembranes. An enhancement of arsenic removal properties was demonstrated from 0.6 wt% of ZnO-MgO in CAP/PPSU (ZMCAP-0.6) membrane was 81.31% with the retention permeability of 69.58 L/m2h bar respectively. Similarly, 1 wt% of ZnO-MgO in CA/PPSU (ZMCA-1) was found to be 78.48% and 198.47 L/m2h bar respectively using 1 ppm laboratory prepared aqueous arsenic solution (pH 6.8 ± 0.2) at 1 bar transmembrane pressure. In addition, improved antifouling properties was noticed with an increased flux recovery ratio and enhanced thermal stability from ZnO-MgO contained membranes. Therefore, as fabricated ZnO-MgO contained membranes provided enhanced arsenic removal tendency without compromising the retention permeability. © 2020Item Hydrophilic polydopamine/polyvinylpyrrolidone blended polyphenylsulfone hollow fiber membranes for the removal of arsenic-V from water(Elsevier Ltd, 2023) Kumar, M.; Isloor, A.M.; Nayak, M.C.S.; Todeti, S.R.; Padaki, M.; A.F., A.F.The demand for fresh drinking water is sky rocketing with the world's increasing population, urbanization and various industrial growth. However, toxic heavy metals and metalloids like arsenic is contaminating the drinking water. Arsenic is poisonous, carcinogenic and mutagenic for millions of population. We hereby proposing in-house fabricated novel hollow fiber membranes using polyphenylsulfone (PPSU) and pore-forming agent polyvinylpyrrolidone (PVP) along with increased concentrations of bio-inspired hydrophilic additive polydopamine (PDA) for removal of arsenic-V from the drinking water. The crystallinity of PDA was interpreted by X-ray diffraction. The morphology, topology and membrane surface chemistry of fabricated membranes were evaluated by scanning electron microscopy, atomic force microscopy, thermogravimetric analysis, fourier transform infrared spectroscopy and x-ray photoelectron spectroscopy. The results indicated that, for the PDA-contained membranes overall performance was increased in terms of membrane hydrophilic characteristics and rejection efficacy. A 3 wt% of PDA in PPSU/PVP (PDA-3) executed enhanced arsenate (As-V) removal as high as 87.15% with flux of 31.80 L/m2h, which was higher than the neat membrane (PDA-0) as 67.70% with flux of 15.07 L/m2h for 5 mL/L arsenic-V aqueous solution at 0.2 MPa transmembrane pressure. Improved antifouling properties were observed from PDA-contained hollow fiber membranes, as evidenced by the improved flux recovery ratio and superior thermal stability. The mechanical properties (tensile strength) of pristine and PDA-contained membranes was also investigated. © 2023