Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item Synthesis, characterization & impedance studies of some new nano filtration membranes(Trans Tech Publications Ltd ttp@transtec.ch, 2010) Padaki, M.; Hegde, C.; Isloor, A.M.In the recent years membrane technology has gained significant attention from polymer chemists all around the world due to their attractive features such as efficiency, low costs, low energy costs and as effective solutions to longstanding problems in the chemical industries. Membrane technologies have been widely applied in the separation of liquids and even gases. Many separation problems can be solved economically by nanofiltration alone or in combination with other separation processes. This study aimed to synthesize polysulfone based nanofiltration membranes using DIPS (diffusion induced phase separation) technique. Newly synthesized polymer membranes were subjected to Infra red spectral and water uptake studies. Membranes were also characterized using electrochemical spectroscopy for their proton conducting property. Their surface morphology is visualized by SEM. © (2010) Trans Tech Publications.Item Synthesis and desalination performance of Ar+-N+ irradiated polysulfone based new NF membrane(2011) Hegde, C.; Isloor, A.M.; Padaki, M.; Wanichapichart, P.; Liangdeng, Y.In the last few years, membrane technology has gained more attention from polymer chemists throughout the globe. Nowadays, surface modification of membrane is very useful in biotechnology and food science. In the present investigation, we have synthesized polysulfone based composite nanofiltration (NF) membranes, and characterized these membranes by FT-IR, SEM and membrane performance studies. Surface plasma treatment was carried out by irradiation with argon and nitrogen beams in suitable conditions. It was observed that nitrogen beam caused surface roughness that was more severe than the Ar beam. After irradiation, water contact angle was slightly increased. For pure water permeability, flux increased linearly with the operating pressure. However, for the salt solution, the flux was decreased marginally and salt rejection increased after irradiation due to surface modification. The modification effect was characterized in terms of contact angle, AFM employed roughness measurement and dielectric property. It revealed that irradiated NF membranes showed higher salt rejection and lower flux as compared to the nonmodified membranes. Accordingly, the roughness of the membrane surface intensively affected the performance of RO membrane. © 2010 Elsevier B.V.Item Novel polyphenylsulfone (PPSU)/nano tin oxide (SnO2) mixed matrix ultrafiltration hollow fiber membranes: Fabrication, characterization and toxic dyes removal from aqueous solutions(Elsevier B.V., 2019) Nayak, M.C.; Isloor, A.M.; Siddique, I.; Balakrishna Prabhu, B.; Ismail, N.I.; Asiri, A.M.Novel polyphenylsulfone (PPSU)/nano tin oxide (SnO2) mixed matrix hollow fiber membranes (HFMs) were fabricated by dry-wet spinning via phase separation method. In the current research, reported the contrast between neat PPSU membrane and nanocomposite membranes (PPSU/SnO2), to determine the toxic reactive dyes namely, reactive black-5 (RB-5) and reactive orange-16 (RO-16) removal ability from the aqueous media. Scanning electron microscopy (SEM) was used to observe the HFMs cross-sectional morphological changes and surface roughness parameters of membranes were analyzed using atomic force microscopy (AFM). The surface wettability ability of HFMs was examined with a contact angle, water uptake, and porosity measurements. The cross-flow filter unit was engaged to quantify the water permeability, anti-fouling ability as well as the dye rejection ability of fabricated membranes. With increasing the SnO2 NPs wt% in PPSU polymer matrix the membrane performance was enhanced continuously, it became evident that the incorporated SnO2 NPs plays main role in membrane performance. Added, water-soluble poly (vinylpyrrolidone) (PVP) can also impact the pore morphology in membranes. At the end, PS-3 membrane exhibited lower contact angle (63.7 0), higher water uptake (74.8%), porosity (84.1%), pure water flux 362.9 L/m2 h, and high potential for dyes rejection application, of about >94% for RB-5, and >73% for RO-16 dye, respectively. From the preliminary results, it can be stated that the usage of SnO2 NPs in membrane technology become effective towards wastewater treatment. © 2019 Elsevier B.V.