Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item Permeation, Antifouling and desalination performance of TiO2 nanotube incorporated PSf/CS blend membranes(2013) Kumar, R.; Isloor, A.M.; A.F., A.F.; Abdul Rashid, S.A.; Ahmed, A.A.Polysulfone (PSf) and chitosan (CS) blend membranes were prepared by incorporating titanium dioxide nanotubes (TiO2NT) in different compositions. The proper blending of PSf and CS in the PSf/CS/TiO2 membranes was confirmed by ATR-IR spectroscopy. The influence of nanotubes on morphology of membranes was investigated by Field Emission Scanning Electron Microscopy (FESEM). The effect of nanotubes on hydrophilicity of the membranes was studied by water swelling and contact angle measurements. The distribution of TiO2NT on the membrane surface was determined by Transmission Electron Microscope (TEM) analysis. The permeation property of PSf/CS/TiO2NT membranes was carried out by measuring the time dependent pure water flux (PWF). Bovine serum albumin (BSA) protein rejection studies were performed to know the antifouling properties. The rheological percolation threshold of PSf/CS/TiO2NT solutions was measured by viscosity studies. The nanotubes incorporated PSf/CS membranes showed enhanced permeation and antifouling properties compared to PSf/CS and nascent PSf ultrafiltration membranes. Membranes prepared well above rheological percolation threshold showed drastic reduction in pore size and acted as nanofiltration (NF) membranes. © 2013 Elsevier B.V.Item Novel hybrid photocatalytic reactor-UF nanocomposite membrane system for bilge water degradation and separation(Royal Society of Chemistry, 2015) Moslehyani, A.; A.F., A.F.; Othman, M.H.D.; Isloor, A.M.This study focuses on the design and performance of a hybrid system consisting of a photocatalytic reactor and ultrafiltration permeation cell. Initially, an ultraviolet (UV) lamp was installed in the photocatalytic reactor to decompose the bilge organic pollutants in the presence of 200 ppm titanium-dioxide (TiO2). Individual hydrocarbon compounds of bilge water samples were identified by gas chromatography-mass spectrometry (GC-MS) analysis. Two types of membrane, which are a pure polyvinylidene fluoride (PVDF) membrane and PVDF/modified halloysite nanotube clay (M-HNTs) nanocomposite membrane were fabricated aiming to enhance the rejection, flux and fouling resistance for full filtration of pollutants from the photocatalytic reactor. The membranes were characterized by Fourier transform infrared (FTIR), field emission scanning electron microscopy (FESEM) and atomic force microscopy (AFM). Furthermore, GC-MS analysis showed that, over 90% bilge decomposition occurred by a photocatalytic reaction. The TiO2 cross-over during permeation was detected by using an atomic absorption spectrophotometer (AAS), which proved that, TiO2 rejection was more than 99% for the nanocomposite membrane. A UV- vis spectrophotometer confirmed over 99% rejection of decomposed bilge hydrocarbons via the nanocomposite membrane with 1.0 wt% of M-HNTs incorporated in the PVDF matrix. This journal is © The Royal Society of Chemistry 2015.Item Photoreactor-ultrafiltration hybrid system for oily bilge water photooxidation and separation from oil tanker(Elsevier, 2016) Moslehyani, A.; Mobaraki, M.; Isloor, A.M.; A.F., A.F.; Othman, M.H.D.A novel design of hybrid system consisting of photoreactor (PR) combined with ultrafiltration (UF) membrane was investigated for oily bilge water degradation and separation from oil tanker. Initially, the bilge organic compounds were photooxidized using ultraviolet type A (UVA) light irradiation on 100, 200 and 300 ppm of TiO2. Further TiO2 and oxidized oily bilge water was filtered using hollow fiber membrane separator, which was prepared by polyvinylidene fluoride (PVDF) and halloysite nanotubes. The hollow fiber membranes were characterized by ATR-IR spectrum, thermal gravimetric analysis (TGA), X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM) and X-ray photoelectron spectroscope (XPS). Individual hydrocarbon of oily bilge water was identified by using gas chromatography-mass spectrometry (GC-MS) analysis. According to the GC-MS analysis, over 90% decomposition of oil in bilge water has occurred by 200 and 300 ppm of TiO2 suspension. On the other hand, pH meter showed that, decomposed oily bilge water was more acidic, which increased to pH 7 after UF system process. Moreover, over 99% of degraded oil in bilge water was filtered by this promising hybrid system. © 2016 Elsevier B.V. All rights reserved.Item Fabrication of novel PPSU/ZSM-5 ultrafiltration hollow fiber membranes for separation of proteins and hazardous reactive dyes(Taiwan Institute of Chemical Engineers, 2018) Nayak, M.C.; Isloor, A.M.; Moslehyani, A.; Ismail, N.; A.F., A.F.Polyphenylsulfone (PPSU) based asymmetric hollow fiber membranes were prepared by the addition of different percentages of ZSM-5 particles by diffusion induced phase separation method. Polyvinylpyrrolidone (PVP) was used as a pore forming agent. The fabricated membranes were characterized by Field Emission scanning electron microscopy (FESEM), Energy Dispersive Spectroscopy (EDS), contact angle, water permeability, water uptake and by porosity measurements. Membranes filtration study was performed using different proteins namely bovine serum albumin (BSA), egg albumin (EA) and hazardous dyes like Reactive black 5 (RB-5), Reactive orange 16 (RO-16) in aqueous solutions. It was found that, addition of ZSM-5 in membrane matrix showed better dye removal capacity because of its hydrophilic and adsorptive nature. The membrane (PZ-3) with higher loading of additive exhibited rejection percentages of 100% for BSA, 95.23% for EA proteins and with reactive dyes 90.81% for RB-5 and 82.84% for RO-16 as compared to the pristine HF membrane. © 2017 Taiwan Institute of Chemical EngineersItem Surface plasmon resonance sensor using polypyrrole-chitosan/graphene quantum dots layer for detection of sugar(Institute of Physics Publishing helen.craven@iop.org, 2019) Sadrolhosseini, A.R.; Abdul Rashid, S.; Jamaludin, N.; Bin Muhammad Noor, A.S.M.; Isloor, A.M.The Polypyrrole-chitosan/graphene quantum dots nanocomposite layer was prepared by using electrochemical deposition on the surface of gold-coated glass. The prepared layer was used to detect and measure the low concentration of glucose, fructose, and sucrose, using the surface plasmon resonance sensor. X-ray diffraction spectroscopy, and field emission scanning electron microscopy confirmed the GQDs as being formed in the composite layer. The thickness of the polypyrrole-chitosan/graphene quantum dots composite layer was in the range of 10.2 nm to 46.5 nm. The sensitivity of the sensor for glucose detection was higher than fructose and sucrose. The sensor limit and the response time were about 1 ppm and 320 s, respectively. © 2019 IOP Publishing Ltd.Item Improved separation of dyes and proteins using membranes made of polyphenylsulfone/cellulose acetate or acetate phthalate(Springer Science and Business Media Deutschland GmbH, 2020) Kumar, M.; Isloor, A.M.; Todeti, S.R.; Gnani Peer Mohamed, G.P.S.; Siddique, I.; A.F., A.F.; Asiri, A.M.Industrial wastewater often contains xenobiotics such as heavy metals, dyes and proteins, yet there is a lack of efficient cleaning methods. Therefore, here we fabricated hollow fiber membranes using polyphenylsulfone containing 1, 3 and 5 wt% of cellulose acetate and cellulose acetate phthalate by non-solvent induced phase separation. Membrane morphology was characterized by field emission scanning electron microscopy. The hydrophilicity of the membranes was measured by contact angle, water uptake and porosity measurement. The thermal miscibility of the membrane with additives was assessed by thermogravimetric analysis. Hollow fiber membranes were tested for separation of azo dyes, e.g., reactive orange 16 and reactive black 5, and of proteins: bovine serum albumin, egg albumin and pepsin. Results show increasing rejection of dyes and proteins with the content of cellulose acetate and cellulose acetate phthalate. Water permeability was 41.26 L/m2 h bar for the polyphenylsulfone membrane, 64.47 L/m2 h bar for the polyphenylsulfone/5 wt% cellulose acetate membrane and 72.60 L/m2 h bar for the polyphenylsulfone/5 wt% cellulose acetate phthalate membrane. © 2020, Springer Nature Switzerland AG.