Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
2 results
Search Results
Item Morphological and structural characterisation of sol-gel electrospun Co3O4 nanofibres and their electro-catalytic behaviour(Royal Society of Chemistry, 2015) George, G.; Elias, L.; Hegde, A.C.; Anandhan, S.Evolution of hydrogen and oxygen are a crucial part of many renewable energy systems. The replacement of the essential and expensive components in such systems can reduce the capital cost and improve the effectiveness of those systems. In this study, Co3O4 nanofibres were fabricated from sol-gel assisted electrospun poly(styrene-co-acrylonitrile)/cobalt acetate tetrahydrate precursor composite fibres. The morphological and compositional features of the Co3O4 nanofibres obtained after calcination of the precursor nanofibers were studied using scanning electron microscopy, transmission electron microscopy, X-ray photoelectron spectroscopy and Fourier transform infrared spectroscopy. The results of X-ray diffraction study and Raman spectroscopy revealed that the average grain size of the fibres increased with the calcination temperature. Clear evidence of defects in the fibres was observed in ultraviolet-visible-near infrared and energy dispersive spectroscopic measurements. The electrocatalytic behaviour of Co3O4 nanofibres obtained at different calcination temperatures was studied using them for the water splitting reaction in an alkaline medium. The maximum efficiency in the hydrogen evolution reaction was achieved using the Co3O4 nanofibres obtained at the lowest calcination temperature, which had the highest surface area and the smallest grain size. © The Royal Society of Chemistry 2015.Item Electrochemical studies on the corrosion resistance of Zn–Ni–Co coating from acid chloride bath(Springer, 2020) Bhat, R.S.; Manjunatha, K.B.; Prasanna Shankara, R.; Venkatakrishna, K.; Hegde, A.C.Anticorrosive deposits are a valuable approach to defending against corrosion from mild steel structures/machinery equipment. The Zn–Ni–Co coating has been deposited on low carbon steel surfaces using environment friendly optimized acidic chloride bath with ZnCl2·6H2O, NiCl2·6H2O, CoCl2·6H2O, sulphanilic acid (C6H7NO3S) and gelatin (C6H8O6). The standard Hull cell technique has been adopted for the optimization of bath components and experimental conditions, for the superior corrosion resistant coating. The corrosion test with potentiodynamic polarization method was performed to investigate the role of pH on the film quality and corrosion performances of the films. Further, the effect of current densities on corrosion resistance, thickness and hardness, have been investigated. Cyclic voltammetry technique has been used to test the electrochemical properties of the Zn–Ni–Co coating in acidic solutions. The results revealed that the increase in the current density favoured the increase in Ni and Co content in the deposit, showed higher corrosion resistance and higher cathodic current efficiency. The structural and morphological characteristics of the alloy coating have been obtained through scanning electron microscopy and X-ray diffraction techniques. The atomic force microscope was used to examine the topographic structure of the coating. X-ray Photoelectron spectroscopy was used to determine the chemical composition of alloy coatings and verified by energy dispersive X-ray analysis. The results indicate that a new and low-cost chloride bath for Zn–Ni–Co coating exhibit superior corrosion resistance properties and can be implement in various industrial applications such as automobiles, machine tools etc.[Figure not available: see fulltext.]. © 2020, Springer-Verlag GmbH Germany, part of Springer Nature.