Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
Search Results
Item A Parametric Study on Mixed Convection in a Vertical Channel in the Presence of Wire Mesh(Taylor and Francis Ltd., 2021) Kotresha, B.; Gnanasekaran, N.A numerical study on mixed convection is carried out through a partially filled brass wire mesh in a vertical channel. A heater embedded with aluminum plates is placed at the center of the vertical channel. The aluminum heater assembly is wrapped with brass wire mesh to facilitate more heat transfer. The vertical channel that consists of aluminum heater assembly with the brass wire mesh is considered as the numerical model. Local thermal non-equilibrium and Darcy extended Forchheimer models are used to accomplish the numerical simulations for thermal and flow characteristics of the considered domain. The aim of the study is to find out the optimum filling of the brass wire mesh in the channel which gives a higher heat transfer rate with low pumping power of the fluid. In the present analysis, three different filling conditions of wire mesh are considered: (i) fully filled channel, (ii) 70% filled channel, and (iii) 40% filled channel. From the results, it is inferred that the vertical channel partially filled with 70% of wire mesh porous medium predicts 89% of heat transfer of the completely filled channel with 41% reduced pressure loss. As a result, the proposed parametric study is good enough to prove that the partly filled wire mesh can be used in the thermal applications where augmentation of heat transfer is required with less pressure drop. © 2020 Taylor & Francis Group, LLC.Item Numerical consideration of LTNE and darcy extended forchheimer models for the analysis of forced convection in a horizontal pipe in the presence of metal foam(American Society of Mechanical Engineers (ASME), 2021) Jadhav, P.H.; Gnanasekaran, N.; Arumuga Perumal, D.The intent of the current research work is to emphasize the computational modeling of forced convection heat dissipation in the presence of high porosity and thermal conductivity metallic foam in a horizontal pipe for different regimes of the fluid flow for a range of Reynolds number. A two-dimensional physical domain is considered in which Darcy extended Forchheimer (DEF) model is adopted in the aluminum metallic foam to predict the features of fluid flow and local thermal nonequilibrium (LTNE) model is employed for the analysis of heat transfer in a horizontal pipe for different flow regimes. The numerical results are initially matched with experimental and analytical results for the purpose of validation. The average Nusselt number for fully filled foam is found to be higher compared to other filling rate of metallic foams and the clear pipe at the cost of pressure drop. As an important finding, it has been observed that the laminar and transition flow gives higher heat transfer enhancement ratio and thermal performance factor compared to turbulent flow. This work resembles numerous industrial applications such as solar collectors, heat exchangers, electronic cooling, and microporous heat exchangers. The novelty of the work is the selection of suitable flow and thermal models in order to clearly assimilate the flow and heat transfer in metallic foam. The presence of aluminum metal foam is highlighted for the augmentation of heat dissipation in terms of PPI and porosity. The parametric study proposed in this work surrogates the complexity and cost involved in developing an expensive experimental setup. © 2021 American Society of Mechanical Engineers (ASME). All rights reserved.