Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Author: search.filters.author.Gautam, R.Subject: search.filters.subject.Graphite

Search Results

Now showing 1 - 2 of 2
  • No Thumbnail Available
    Item
    Microwave-assisted in-situ catalytic pyrolysis of polystyrene: Analysis of product formation and energy consumption using machine learning approach
    (Institution of Chemical Engineers, 2022) Terapalli, A.; Kamireddi, D.; Sridevi, V.; Tukarambai, M.; Suriapparao, D.V.; Sankar Rao, C.S.; Gautam, R.; Modi, P.R.
    Microwave-assisted catalytic pyrolysis is a prominent technology for the production of high-quality fuel intermediates and value-added chemicals from polystyrene waste. The objectives of this study were to understand the role of catalyst (KOH) on polystyrene (PS) pyrolysis. Pyrolysis experiments were conducted using a microwave oven at a power of 450 W and a temperature of 600 °C. Graphite susceptor (10 g) was used to achieve the required pyrolysis conditions. In addition, the design of experiments (DoE) with machine learning (ML) was used to understand the loading of PS (5 g, 27.5 g, and 50 g), and KOH (5 g, 7.5 g, and 10 g). The products including oil, gas, and char were collected in every experiment. The average heating rates achieved were in the range of 30–50 °C/min. The specific microwave power (microwave power per unit mass of feedstock) decreased with an increase in PS amount from 90 to 9 W/g. However, the specific microwave energy (microwave energy per unit mass of feedstock) (27–73 kJ/g) was in line with the average heating rate. The maximum yield of pyrolysis oil was found to be 95 wt%, which was obtained with a PS:KOH ratio of 27.5 g: 7.5 g. The oil yield increased from 80 to 95 wt% when the mass of the catalyst increased from 5 to 7.5 g. On the other hand, the gas yield (3–18 wt%) varied significantly and char yield (1–2 wt%) was not influenced. The yields predicted by ML matched well with the experimental yields. This study demonstrated the potential of KOH as a catalyst for PS pyrolysis technology as the formation of aliphatic hydrocarbons in the oil fraction was significantly promoted. © 2022 The Institution of Chemical Engineers
  • No Thumbnail Available
    Item
    Effective electronic waste valorization via microwave-assisted pyrolysis: investigation of graphite susceptor and feedstock quantity on pyrolysis using experimental and polynomial regression techniques
    (Springer, 2024) Mistry, C.; Surya, D.V.; Ramesh, R.; Basak, T.; Kumar, P.S.; Sankar Rao, C.S.; Gautam, R.; Sridhar, P.; Choksi, H.; Remya, N.
    Waste printed circuit board (WPCB) was subjected to microwave-assisted pyrolysis (MAP) to investigate the energy and pyrolysis products. In MAP, pyrolysis experiments were conducted, and the effects of WPCB to graphite mass ratio on three-phase product yields and their compositions were analyzed. In addition, the role of the initial WPCB mass (10, 55, and 100 g) and susceptor loading (2, 22, and 38 g) on the quality of product yield was also evaluated. By using design of experiments, the effects of graphite susceptor addition and WPCB feedstock quantity was investigated. A significant liquid yield of 38.2 wt.% was achieved at 38 g of graphite and 100 g of WPCB. Several other operating parameters, including average heating rate, pyrolysis time, microwave energy consumption, specific microwave power used, and product yields, were optimized for the MAP of WPCB. Pyrolysis index (PI) was calculated at the blending of fixed quantity WPCB (100 g) and various graphite quantities in the following order: 2 g (21) > 20 g (20.4) > 38 g (19.5). The PI improved by increasing the WPCB quantity (10, 55, and 100 g) with a fixed quantity of graphite. This work proposes the product formation and new reaction pathways of the condensable compounds. GC–MS of the liquid fraction from the MAP of WPCBs without susceptor resulted in the generation of phenolic with 46.1% relative composition. The addition of graphite susceptor aided in the formation of phenolic and the relative composition of phenolics was found to be 83.6%. The area percent of phenol increased from 42.8% (without susceptor) to 78.6% (with susceptor). Without a susceptor, cyclopentadiene derivative was observed in a very high composition (~ 31 area %). © The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature 2023.