Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Filters

2007 - 20082

Settings

Author: search.filters.author.Fernandes, P.Subject: search.filters.subject.Heat transfer

Search Results

Now showing 1 - 2 of 2
  • No Thumbnail Available
    Item
    Effect of section size and agitation on heat transfer during quenching of AISI 1040 steel
    (2007) Fernandes, P.; Prabhu, K.N.
    In the present work an attempt has been made to determine the heat flux transients during quenching of Ø28 mm × 56 mm height and Ø44 mm × 88 mm height AISI 1040 steel specimens during lateral quenching in brine, water, palm oil and mineral oil. The heat flux transients were estimated by inverse modeling of heat conduction. The variation of heat flux transients with surface temperature for different quenching media is investigated. Higher peak heat flux transients are obtained for 28 mm diameter specimen than 44 mm diameter specimen during quenching in aqueous media. However quenching with oil media shows opposite results. Agitation of quenching medium increases the peak heat flux during the quenching of steel specimen in all the quenching media. Peak hardness is obtained at the surface and with smaller diameter specimens during agitation. © 2006 Elsevier B.V. All rights reserved.
  • No Thumbnail Available
    Item
    Comparative study of heat transfer and wetting behaviour of conventional and bioquenchants for industrial heat treatment
    (2008) Fernandes, P.; Prabhu, K.N.
    An investigation was conducted to study the suitability of vegetable oils as bioquenchants for industrial heat treatment. The study involved the assessment of the severity of quenching and wetting behaviour of conventional and vegetable oil quench media. Quench severities of sunflower, coconut and palm oils were found to be greater than mineral oil. The quench severity of aqueous media is greater than oil media although their wettability is poor as indicated by their higher contact angles. A dimensionless contact angle parameter defined in this work is found to be a better parameter to compare the wetting behaviour with heat transfer. © 2007 Elsevier Ltd. All rights reserved.