Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item Removal of toxic arsenic from aqueous media using polyphenylsulfone/cellulose acetate hollow fiber membranes containing zirconium oxide(Elsevier B.V., 2020) Kumar, M.; Isloor, A.M.; Somasekhara Rao, T.; A.F., A.F.; Farnood, R.; Nambissan, P.M.G.Arsenic is one of the highly dangerous metalloid present in the polluted water, it's effective and economical removal is one of the major challenges to the researchers. It was planned to prepare hollow fiber membranes using polyphenylsulfone (PPSU) as a polymer, cellulose acetate (CA) and cellulose acetate phthalate (CAP) as additives with increased dosages (0.6, 1 and 1.5 wt%) of zirconium oxide (ZrO2) nanoparticle. The fabricated hollow fiber membranes were characterized by SEM, AFM, zeta potential, ATR-FTIR and XPS to analyze the membrane's morphologies (cross-section and surface), topography, surface charge and assessment of different functional groups. As used ZrO2 was characterized by TEM and XRD to analyze the morphology and crystallinity. The positron annihilation lifetime spectroscopy (PALS) analysis was carried out for neat and ZrO2 contained membranes, to study the expansion of free-volume in membrane morphology. Leaching studies of the used zirconium with respect to different pH from the ZrO2 contained hollow fiber membrane was also examined. The enhancement of membrane hydrophilicity was confirmed by contact angle, porosity, water uptake and pure water permeability measurements. Membranes prepared by 1 wt% of ZrO2 in PPSU/CA (PZCA-1) and 0.6 wt% of ZrO2 in PPSU/CAP (PZCAP-0.6) were proved to be efficient as arsenic removal membranes (i.e. PZCA-1 as 87.24% and PZCAP-0.6 as 70.48% and permeability of 89.94 L/m2h bar and 70.59 L/m2h bar respectively) using lab-prepared 1 ppm standard arsenic solution at pH range of 6.8 ± 0.2. Also, there is a decrease in the arsenic removal tendency was observed with the excessive dosages of ZrO2, which is due to the concentration polarization on surfaces of the membranes. Antifouling behavior of the prepared hollow fiber membranes was also studied using bovine serum albumin (BSA). © 2020Item Tuning the surface properties of Fe3O4 by zwitterionic sulfobetaine: application to antifouling and dye removal membrane(Springer, 2020) Gnani Peer Mohamed, G.P.; Isloor, A.M.; Siddique, I.; Asiri, A.M.; Farnood, R.In this paper, zwitterionic polysulfobetaine@Fe3O4 (PSBMA@Fe3O4) nanoparticles were synthesized via covalent grafting and free radical polymerization and characterized. The PSBMA@Fe3O4 noparticles had a zeta potential of ? 36 mV (pH 6.3), which guaranteed the high colloidal stability. The as-synthesized nanoparticles were employed as a nanofiller to prepare superior antifouling polysulfone hybrid hollow fiber membranes. The FM-2 membrane exhibited the maximum pure water permeability of 61.1 L/m2 h bar with humic acid (HA) removal efficiency of 98%. The fouling resistance was evaluated using HA as a foulant, and the results suggested that the FM-2 membrane had less amount of HA adsorption with flux recovery ratio of 88.4%. Furthermore, the FM-2 membrane was demonstrated the reactive black-5 and reactive orange-16 removal of above 99% and 84% without much reduction in the dye solution permeability. © 2020, Islamic Azad University (IAU).Item Hydrophilic nano-aluminum oxide containing polyphenylsulfone hollow fiber membranes for the extraction of arsenic (As-V) from drinking water(Elsevier Ltd, 2021) Kumar, M.; Isloor, A.M.; Todeti, S.R.; A.F., A.F.; Farnood, R.In the present work, hollow fiber ultrafiltration membranes were fabricated by incorporating intensified dosages of nano?aluminum oxide (nano-Al2O3; 0.6 wt%, 1.0 wt% and 1.5 wt%) into cellulose acetate (CA)/polyphenylsulfone (PPSU) and cellulose acetate phthalate (CAP)/PPSU by non-solvent induced phase separation (NIPS) process. The topological structures and the morphologies were investigated using atomic force microscope (AFM) and scanning electron microscope (SEM). The crystalline and morphological structures of the nano-Al2O3 were investigated using X-ray diffraction (XRD) and transmission electron microscope (TEM) respectively. Fourier transform infra-red spectroscope (FTIR) and x-ray photoelectron spectroscopy (XPS) analysis have been carried out to validate the dosages of nano-Al2O3, CA and CAP on PPSU membranes. The membrane's surface charge measurement of 1.5 wt% of nano-Al2O3 in CA/PPSU (ALCA-1.5) was scrutinized by zeta potential analysis. Membranes removed more arsenate oxide as the removal rate from membranes ALCA-1.5 and 1.0 wt% of nano-Al2O3 in CA/PPSU (ALCA-1) was 98.67% and 94.89% with retention permeabilities of 88.41 L/m2h bar and 53.53 L/m2h bar respectively from laboratory prepared 1 ppm of aqueous arsenic solution with pH in the range 6.8 ± 0.2 at 1 bar transmembrane pressure. In addition, membrane's antifouling analysis was performed using laboratory prepared 0.8 g/L (Bovine Serum Albumin) BSA as standard protein solution. © 2021 Elsevier Ltd