Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
4 results
Search Results
Item Effect of parallel LPG fuelling in a methanol fuelled SI engine under variable compression ratio(Elsevier Ltd, 2022) Dinesh, M.H.; Pandey, J.K.; Kumar, G.N.In the present experimental study, five LPG fractions from 25% to 45% based on total energy are tested in a methanol fuelled SI engine at compression ratios (CR) varying from 12 to 15. Results are affirmative towards methanol/LPG dual fuel. The brake power, brake thermal efficiency, and volumetric efficiency are found to increase by 51%, 21.2%, and 13% respectively by changing from 25% LPG fraction at CR12 to 45% LPG fraction at CR15. The flame development period is found to decrease with CR and LPG, while the flame propagation period and total combustion duration are found to decrease with CR but increase with LPG. The maximum cylinder pressure and net heat release rate are found to increase by 101% and 27.8% respectively and advanced. CO emissions are found to decrease with CR while increase with LPG fraction. HC is found to decrease with LPG as well as CR. CO2 emissions are found to increase continuously with increasing LPG fractions and CR. The NOx emissions are also found to increase explicitly with LPG and CR, a net 209% increase in it is found 25% LPG at CR 12–45% LPG at CR15. © 2021 Elsevier LtdItem Study of performance, combustion, and NOx emission behavior of an SI engine fuelled with ammonia/hydrogen blends at various compression ratio(Elsevier Ltd, 2022) Dinesh, M.H.; Pandey, J.K.; Kumar, G.N.In the present paper, an experimental investigation has been performed under variable CR and 1400&1800RPM speed at a fixed spark timing of 24ºCA BTDC under wide-open throttle conditions. The hydrogen blending is performed based on energy fractions from 5% to 21% of the total fuel energy. With increasing compression ratio (CR), the flame development gets faster, and the flame propagation speed improves, leading to a short combustion period. Similarly, increasing hydrogen fraction improves combustion, resulting in a rapid rise in pressure and temperature. Despite a 13.64% decrease in volumetric efficiency from 5% to 21% hydrogen fraction at 1400 and 1800 RPM, BP and BTE increased by 16.89% and 33%, respectively. The slow-burning properties of NH3 extend the combustion period, resulting in a long-delayed burning period. As a result, the temperature of the low-hydrogen fraction of the exhaust gas is higher. As the hydrogen fraction and CR increase, this effect decreases, resulting in lower EGT. The hydrogen addition increases the peak temperature; therefore, NOx increases continuously with increasing hydrogen despite reducing ammonia. Ammonia is a key element used to reduce NOx from vehicles. A practical solution for controlling the NOx due to the ammonia/hydrogen blend is selective catalytic reduction (SCR). © 2022 Hydrogen Energy Publications LLCItem Consequences of varying compression ratio and ignition timing on engine fueled with E-MEBANOL(SAGE Publications Ltd, 2023) Pandey, J.K.; Dinesh, M.H.; Gn, K.Alcohols are oxygenated renewable fuels responsible for low carbon emission and high H/C ratio. In the present study, a blend of methanol, ethanol, and n-butanol in equal proportion by volume (E-MEBANOL) is tested as a sustainable fuel for SI engines under variable compression ratio (CR) and ignition timing (SOI). The performance of the engine is found to improve by increasing CR as well as advancing the SOI, as the brake power (BP), brake thermal efficiency (BTE), and volumetric efficiency are found to increase by increasing CR to 15 from 11 at an advanced SOI of 24°CA before top dead center (BTDC) from 16°CA BTDC by 17.54%, 17.47%, and 10.53% respectively. Similarly, combustion is also enhanced with increasing CR and advancing SOI as the peak cylinder pressure (Pmax), and maximum net heat release rate (NHRmax) are found to increase by 60% and 27.64%, respectively, while positions of these peaks are advanced by 17°CA and 18°CA respectively by increasing CR from 11 to 15 and SOI advanced to 24°CA BTDC. The flame development period (CA10) increases with advancing SOI and decreases with increasing CR, while the flame development period (CA10-90) and total combustion duration decrease with both increasing CR and advancing SOI. The CO & HC emissions improve with increasing CR and advancing SOI, while NOx increases drastically, but EGT decreases continuously. © IMechE 2022.Item Experimental investigation of variable compression ratio and ignition timing effects on performance, combustion, and Nox emission of an ammonia/hydrogen-fuelled Si engine(Elsevier Ltd, 2023) Dinesh, M.H.; Kumar, G.N.In the present experimental study hydrogen-assisted ammonia combustion strategy is used in a SI engine with variable ignition timings (18ºCA bTDC to 32ºCA bTDC) and wide-open throttle conditions, CR changes (14–16) at 1400RPM and 1800RPM. This article aims to optimize ignition timing to boost efficiency and power without knocking. It has been established that ammonia/hydrogen fuels are a clean energy source capable of reducing pollution caused by undesirable emissions. The results revealed that increasing the CR from 14 to 16 increased brake power, brake thermal efficiency, NOX, cylinder pressure, and net heat release rate by 36.82%, 25.11%, 30.21%, 10.35%, and 9.53%, respectively. CA10-90 and EGT, on the other hand, are reduced. Increased speed reduces volumetric efficiency by 9.5% at 1800 RPM. In each CR, 28ºCA bTDC ignition timing and 21% hydrogen energy fraction performed well, which can be observed. Hence, the experiment results indicate hydrogen can be used as a combustion promoter, establishing a new standard for developing ammonia-fuelled engines. © 2023 Hydrogen Energy Publications LLC