Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
5 results
Search Results
Item Enhanced Power Density of Graphene Oxide–Phosphotetradecavanadate Nanohybrid for Supercapacitor Electrode(Springer, 2021) Maity, S.; Anandan Vannathan, A.A.; Kumar, K.; Das, P.P.; Mal, S.S.Successful exploration of supercapacitor (SC) material to integrate with high energy and high power density storage device still remains a daunting challenge. Conducting carbon nanostructures have been primarily used for this purpose; however, most of their surface area remains unutilized throughout the storage process. Herein, a new type of hybrid material has been reported by effectively using active sides of carbon nanostructures. Insertion of faradaic-type polyoxometalates (POMs), namely phosphotetradecavanadate (Na7[H2PV14O42], hereafter described as PV14), into the graphene oxide (GO) matrix creates a novel hybrid material for SC applications. Owing to the formation of nanohybrid, it can store charges both electrostatically and electrochemically. PV14/GO composite’s electrochemical behavior in different electrolyte (acidic/neutral) solutions shows different types of characteristics. The PV14/GO composite as a working electrode exhibits a high galvanostatic capacitance of 139 F/g while maintaining at a power density of 97.94 W/kg in 0.25 M H2SO4 electrolyte. The specific energy density was also found out to be around 56.58 Wh/kg at a 5 mV/s scan rate for the same electrolyte. Furthermore, in 1 M Na2SO4 solution, PV14/GO composite demonstrates a specific capacitance of 85.4 F/g at a scan rate of 5 mV/s. The equivalent series resistance for the device was found to be approximately 0.51 ? with a circuit resistance of 3.881 ?, using electrochemical impedance spectroscopy. The cell capacitance, employing the Nyquist plot, was calculated to be around 2.78 mF. © 2021, ASM International.Item Activated carbon- supported Vanado-nickelate (IV) based hybrid materials for energy application(Elsevier Ltd, 2021) Maity, S.; BM, N.; Kella, T.; Shee, D.; Das, P.P.; Mal, S.S.The rapid development of supercapacitor (SC) technology leads to increased demand for nanofabrication of novel and effective electroactive hybrid materials for next-generation energy storage devices. Herein, nickel tetradecavanadate, K2H5[NiV14O40](NiV14), is doped into porous activated carbon (AC), for the first time, in different wt.% in order to investigate the homogeneous loading of the inorganic metal-oxide component on the AC matrix. The resulting complex, AC-NiV14, is found to have possessed an enhanced electrochemical characteristic (for both symmetric and asymmetric SC cell), which operates at a significantly higher potential of 1.2 V. The combination of the double-layer capacitance (EDLC) and the redox-active polyoxometalate cluster leads to an intrinsic increase in specific capacitance (capacity) (from 45.3 Fg?1 (54.4 Cg?1) for AC to 316 Fg?1 (379.2 Cg?1) for 15 wt.% AC-NiV14 at a current density of 1 Ag?1). It was also observed that there is an increase of 20% in the operating voltage compared to conventional AC supercapacitors with acidic aqueous electrolytes. Firstly, symmetric supercapacitor's electrochemical performances of various wt.% of NiV14 composition were studied in acidic aqueous electrolyte (0.5 M H2SO4) solution. We observed that the 15 wt.% of AC-NiV14 hybrid electrode showed remarkable specific energy value (~63.2 Wh kg?1) compared with pristine AC and NiV14 electrodes, separately. Besides, the asymmetric layout (AC//AC-NiV14) increased the potential window up to 1.5 V and enhanced the specific energy and power values (90.1 Whkg?1 and 2400 Wkg?1, respectively), with 98% coulombic efficiency. Meanwhile, the AC-NiV14//NiV14 asymmetric cell possesses a specific capacitance (capacity) of 375 Fg?1 (450 Cg?1) with a maximum power of 3140 Wkg?1 at the high current density of 2 Ag?1. © 2021 Elsevier LtdItem Polyoxomolybdate-Polypyrrole-Graphene Oxide Nanohybrid Electrode for High-Power Symmetric Supercapacitors(American Chemical Society, 2021) Maity, S.; Je, M.; Biradar, B.R.; Chandewar, P.R.; Shee, D.; Das, P.P.; Mal, S.Supercapacitors have emerged as one of the most promising candidates for high-performance, safe, clean, and economical routes to store and release of nonfossil energy. Designing hybrid materials by integrating double-layer and pseudocapacitive materials is crucial to achieving high-power and high-energy storage devices simultaneously. Herein, we synthesized a polyoxomolybdate-polypyrrole-graphene oxide nanohybrid via a one-pot reaction. The inclusion of polypyrrole enables a uniform distribution of the polyoxomolybdate clusters; it also confines the restacking of graphene oxide nanosheets. The structural and morphological analysis to unveil the nanohybrid architecture implies excellent interfacial contact, enabling fast redox reaction of polyanions, and a quick transfer of charge to the interfaces. Electrochemical characteristics tested under a two-electrode system exhibit the highest capacitance of 354 F g-1 with significantly high specific energy and power of 49.16 Wh kg-1 and 999.86 W kg-1, respectively. In addition, the cell possesses a high-rate capability and long cycle life by maintaining 96% of its capacitance over 5000 sweeping cycles. The highest specific power of ?10 »000 W kg-1 was computed with Coulombic efficiency of 92.30% at 5 A g-1 current density. Electrochemical impedance spectroscopy additionally reveals enhanced redox charge transfer due to double hybridization. Furthermore, it also demonstrates the impedance and capacitive behavior of supercapacitor cells over a definite frequency regime. ©Item Pseudocapacitive effects of polyoxometalate implanted on graphene oxide matrix with polypyrrole for symmetric Supercapacitor applications(Elsevier B.V., 2024) Biradar, B.R.; Thathron, N.; Das, P.P.; Mal, S.S.Modern technological requirements emphasize designing and manufacturing electrochemical energy storage devices with high energy and power densities and longer cycle life. Supercapacitors with hybrid electrode materials have gained considerable attention as one of these systems due to their potential usage in futuristic applications such as electric vehicles and smart electric grids, among others. In this work, we synthesize potassium 9-tungsto-2-molybdo-1-vanadosilicate K5[α-SiMo2VW9O40]⋅10H2O and graphene oxide (GO) complex treating the latter as the supporting matrix for the former. We prepare the SiMo2VW9-polypyrrole (PPy) complex and then combine that with the GO matrix. The resulting nanohybrids GO-SiMo2VW9 and GO-PPy/SiMo2VW9 are found to have enhanced electrochemical properties when used in symmetric cells. Combining GO and pseudocapacitive materials can augment SC performance owing to their excellent redox properties. GO-SiMo2VW9 and GO-PPy/SiMo2VW9 showed 55.8 % and 85.5 % capacitive behavior at a scan rate of 10 mV/s, suggesting their use as high-performance pseudocapacitive materials as hybrid electrodes. GO-PPy/SiMo2VW9 electrode material shows a specific capacitance of 351.6 F/g with energy and power densities of 48.83 Wh/kg and 999.93 W/kg, respectively, at 0.5 A/g current density. Both the electrode materials yield capacitance retention of 60 % (GO-SiMo2VW9) and 80 % (GO-PPy/SiMo2VW9) after 5000 cycles at an 8A/g current density with almost 100 % coulombic efficiency, implying the stability of the electrode material. © 2024 Elsevier B.V.Item Carbon Nanotube-Supported Vanadium Substituted Phospho-Molybdate Nanohybrid for Supercapacitor Applications(John Wiley and Sons Inc, 2025) Biradar, B.R.; Swetha, M.T.; Thathron, N.; Puniyanikkottil, M.A.; Hanchate, A.; Das, P.P.; Mal, S.S.Owing to the depletion of conventional energy sources, our civilization is slowly transitioning to renewables. Therefore, designing effective energy storage systems is one of the most pressing technical demands. The quest for improved energy and power densities in energy storage devices, particularly those with long cycle life, has pushed the investigation of novel materials intended to build effective supercapacitors. In this work, nanohybrid materials are synthesized using a hydrothermal technique by mixing carbon nanotubes and a polyoxometalate cluster, H4[PVMo11O40].xH2O. Henceforth, this complex is acronymed as CNT-PVMo11. Further, electrochemical analysis of CNT-PVMo11 nanohybrid is carried out to examine various characteristics of the supercapacitor cell made with this nanohybrid. The cyclic voltammetry confirms the diffusive-dominant charge-storage process, quantifying a 72.83% diffusion mechanism at a scan rate of 1 mV s?1. The galvanostatic charge–discharge analysis of CNT-PVMo11 nanohybrid material showed a specific capacitance of 229.35 F g?1 with energy and power densities of 31.85 Wh kg?1 and 2000 W kg?1, respectively, at 1 A g?1 current density. The electrode material also shows 90% capacitance retention even after 6000 cycles at 8 A g?1 current density, indicating the material's remarkable stability. The high specific capacitance, excellent energy density, and impressive cycling stability of the hybrid material make it a promising candidate for next-generation supercapacitor electrodes. © 2025 Wiley-VCH GmbH.