Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
2 results
Search Results
Item Flexural fatigue analysis of steel fibre reinforced concrete(2012) Girish, M.G.; Chandrashekar, A.; Ravi Shankar, A.U.This paper presents the experimental investigation carried on Steel Fiber Reinforced Concrete (SFRC) subjected to repeated loading. The SFRC beam specimen of size 500mm × 100mm × 100mm containing mixed steel fibers of size 50mm × 2mm × 0.6mm and 0.5mm?× 30mm in different proportions were tested under two point flexural fatigue load at a frequency of 2Hz at various stress levels. The readings obtained from the flexural fatigue test were used to plot S-N diagram and also to perform statistical analysis using two parameter Weibull distributions. © 2012 CAFET-INNOVA TECHNICAL SOCIETY.Item A Study on Elastic Deformation Behavior of Steel Fiber-Reinforced Concrete for Pavements(Springer, 2019) Chandrashekar, A.; Palankar, N.; Durga Prashanth, L.; Mithun, B.M.; Ravi Shankar, A.U.The present study discusses the experimental investigation of steel fiber-reinforced concrete slabs on ground under wheel load with the objective of understanding the stress behavior when subjected to central and edge wheel loading. The steel fiber-reinforced fly ash concrete slabs of 900 mm × 900 mm, 150 mm thickness were investigated in this study. Strain gauges and data acquisition system were used to measure the strains at the center and the edge of the slab under the action of the load. The load versus strain relationship under central and edge loading for reference concrete and steel fiber fly ash concrete showed a linear variation even up to the pressure of 2.5 MPa, which is much beyond the conventional tyre inflation pressure of 0.8 MPa. The load versus strain graphs clearly signify the higher modulus of elasticity of fly ash steel fiber-reinforced concrete. The stresses were calculated using IITRIGID software and ANSYS software and were found matching significantly. The value of modulus of elasticity of fly ash steel fiber-reinforced concrete (FS) using ANSYS model for experimental values of load and strains measured was approximated to 34,000 N/mm2 and was found to closely match with the experimentally obtained modulus of elasticity. No significant effect of Poisson’s ratio of concrete on load–strain characteristics was observed within the range 0.15–0.2 of concrete. © 2019, The Institution of Engineers (India).