Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Filters

20232

Settings

Author: search.filters.author.Bonthu, D.Subject: search.filters.subject.3D printing

Search Results

Now showing 1 - 2 of 2
  • No Thumbnail Available
    Item
    3D printed functionally graded foams response under transverse load
    (Elsevier B.V., 2023) Bonthu, D.; Mahesh, V.; Powar, S.; Doddamani, M.
    The applications of 3D printing are rapidly increasing in aerospace and naval applications. Nonetheless, 3D printing (3DP) of graded foams exhibiting property variation along the thickness direction is yet to be explored. In the current work, the different volume fractions of hollow glass micro balloon (GMB) reinforced high-density polyethylene (HDPE) composite based graded foams are 3D printed using the fused deposition modelling (FDM) technique. The bonding between successive layers and porosity distribution of these graded configurations are studied using micro-CT scan. Further, the 3D Printed functionally graded foams (FGFs) are tested for flexural response, and results are compared with numerical values. The micro-CT results showed delamination absence between the layers. In neat HDPE layers, porosity is not evident, while minor porosity creeps in the layers having the highest GMB content. Experimental results of the flexural test showed that the graded sandwiches exhibited better strength than the graded core alone. Compared to neat HDPE, the modulus of FGF-2 (H20–H40–H60) increased by 33.83%, implying better mechanical stiffness. Among all the FGFs, FGF-2 exhibited a better specific modulus. A comparative study of experimental and numerical results showed a slight deviation due to neglecting the induced porosity. © 2023 The Authors
  • No Thumbnail Available
    Item
    Dynamic response of 3D printed functionally graded sandwich foams
    (Emerald Publishing, 2023) Bonthu, D.; Bharath, B.; Bekinal, S.I.; Jeyaraj, J.; Doddamani, M.
    Purpose: The purpose of this study was to introduce three-dimensional printing (3DP) of functionally graded sandwich foams (FGSFs). This work was continued by predicting the mechanical buckling and free vibration behavior of 3DP FGSFs using experimental and numerical analyses. Design/methodology/approach: Initially, hollow glass microballoon-reinforced high-density polyethylene-based polymer composite foams were developed, and these materials were extruded into their respective filaments. These filaments are used as feedstock materials in fused filament fabrication based 3DP for the development of FGSFs. Scanning electron microscopy analysis was performed on the freeze-dried samples to observe filler sustainability. Furthermore, the density, critical buckling load (Pcr), natural frequency (fn) and damping factor of FGSFs were evaluated. The critical buckling load (Pcr) of the FGSFs was estimated using the double-tangent method and modified Budiansky criteria. Findings: The density of FGSFs decreased with increasing filler percentage. The mechanical buckling load increased with the filler percentage. The natural frequency corresponding to the first mode of the FGSFs exhibited a decreasing trend with an increasing load in the pre-buckling regime and an increase in post-buckled zone, whereas the damping factor exhibited the opposite trend. Originality/value: The current research work is valuable for the area of 3D printing by developing the functionally graded foam based sandwich beams. Furthermore, it intended to present the buckling behavior of 3D printed FGSFs, variation of frequency and damping factor corresponding to first three modes with increase in load. © 2023, Emerald Publishing Limited.