Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item Porous cobalt chalcogenide nanostructures as high performance pseudo-capacitor electrodes(Elsevier Ltd, 2017) Bhat, K.S.; Shenoy, S.; Nagaraja, H.S.; Sridharan, K.Electrochemical supercapacitor is an essential technology that is pivotal for the development of reliable energy storage devices. Herein, we report the fabrication of supercapacitor electrodes using nanostructured porous cobalt chalcogenide (CoTe2 and CoSe2) electrodes, anticipating an enhanced performance owing to their higher contact area with electrolyte and large pore volume enabling shorter diffusion paths for ion exchange. In this regard, we synthesized CoTe2 and CoSe2 nanostructures via an anion-exchange-reaction between pre-synthesized Co(OH)2 hexagonal nanosheets and chalcogen (tellurium and selenium) ions under hydrothermal conditions. Structural, morphological and compositional properties of the as-synthesized materials are examined using X-ray diffraction, Raman spectroscopy, scanning electron microscopy, high resolution transmission electron microscopy and energy dispersive X-ray spectroscopy. Pseudo-capacitive properties of CoTe2 and CoSe2 nanostructures as working electrodes are studied through cyclic voltammetry and galvanostatic charge-discharge methods using an electrochemical workstation. CoSe2 electrode delivered a specific capacitance of 951 F g?1 at a scan rate of 5 mV s?1, which surprisingly is almost three times higher in comparison to CoTe2 electrode (360 F g?1). Both CoTe2 and CoSe2 electrodes exhibited good capacitance retention capability for 2500 CV cycles. The superior electrochemical performance of the nanoporous CoSe2 electrode indicate their applicability for high-performance energy storage device applications. © 2017 Elsevier LtdItem Effect of oxygen substitution and phase on nickel selenide nanostructures for supercapacitor applications(Institute of Physics Publishing helen.craven@iop.org, 2018) Bhat, K.S.; Nagaraja, H.S.Electrochemical supercapacitors are the eminent technology for the progress of energy storage devices. The current manuscript deals with the formation of oxygen substituted nickel selenide nanostructures and their use as active electrode material for supercapacitor, expecting an enhanced performance owing to their sheet-like geometry, high specific surface area and porous assembly. In this context, Ni(OH)2 (nickel hydroxide) nanostructures were synthesized employing one-pot hydrothermal method and the ion-exchange reaction of Ni(OH)2 nanostructures with selenium resulted in cubic-NiSe2 (nickel selenide) nanostructures. Further, annealing NiSe2 nanostructures at intermediate pressure (10-3 Torr) has realized the partial oxygen substitution in place of selenium, resulting in NiSe/NiO nanostructures along with phase change from cubic-NiSe2 to hexagonal-NiSe. Supercapacitor electrodes fabricated using NiSe/NiO nanostructures delivered the specific capacitance of 83.5 F g-1 at the scan rate of 2 mV s-1, which is surprisingly more than a double as compared with pristine NiSe2 electrodes (37.4 F g-1). Annealing at intermediate pressure and high temperature significantly enhanced the specific capacitances of the nanostructured electrodes and also accompanied with the good capacitance retention of 94% for 5000 CV cycles. © 2018 IOP Publishing Ltd.Item Effect of isoelectronic tungsten doping on molybdenum selenide nanostructures and their graphene hybrids for supercapacitors(Elsevier Ltd, 2019) Bhat, K.S.; Nagaraja, H.S.Electrochemical supercapacitors are vital for the advancement of energy storage devices. Herein, we report the synthesis of molybdenum selenide (MoSe 2 ), tungsten-doped molybdenum selenide (W–MoSe 2 ) and their graphene (G) composites (W–MoSe 2 /G) via a facile hydrothermal method. Physiochemical properties of the as-synthesized samples are examined using X-ray diffraction, Raman spectroscopy, thermogravimetric analysis, X-ray photoelectron spectroscopy, Brunauer–Emmett–Teller measurements, scanning electron microscopy, high resolution transmission electron microscopy and energy dispersive X-ray spectroscopy measurements. Used as working electrodes for supercapacitors, MoSe 2 nanostructures could deliver the specific capacitance of 106 F g ?1 at 2 mV s ?1 scan rate. Further, doping with tungsten (W) demonstrates the variation of specific capacitances with 2 M % of tungsten as the optimum doping amount, delivering the maximum specific capacitance of 147 F g ?1 . Furthermore, graphene composites of these nanostructures deliver the enhanced specific capacitances of 248 F g ?1 and complimented with excellent capacitance retention capability of 102% for 20000 cycles. © 2019 Elsevier LtdItem Morphology-dependent electrochemical performances of nickel hydroxide nanostructures(Indian Academy of Sciences, 2019) Bhat, K.S.; Nagaraja, H.S.Electrochemical capacitors form part of the developing technologies in the field of alternative energy sources. In the present work, nickel hydroxide (Ni(OH) 2) nanosheets and microflowers are hydrothermally prepared employing different chemical precursors. Structure, morphology and chemical analysis are conducted using powder X-ray diffraction, field emission scanning electron microscopy and energy-dispersive X-ray spectroscopy measurements. Electrochemical performances as supercapacitor electrodes of the synthesized nanostructures are evaluated through cyclic voltammetry and galvanostatic charge–discharge measurements with three-electrode configurations. The results indicated the specific capacitance of 180 and 417Fg-1 at a scan rate of 5mVs-1 for Ni(OH) 2 nanosheets and microflowers, respectively. The higher specific capacitances for Ni(OH) 2 microflowers could be attributed to the higher specific surface area, morphology, electronic conductivity and porosity. Both Ni(OH) 2 nanostructures exhibited good capacitance retention for 1500 cycles. © 2019, Indian Academy of Sciences.Item Enhanced Electrochemical Performance of Low-Content Graphene Oxide in Porous Co3O4 Microsheets for Dual Applications of Lithium-Ion Battery Anode and Lithium-Ion Capacitor(Springer, 2024) Lakshmi Sagar, G.; Brijesh, K.; Mukesh, P.; Amudha, A.; Bhat, K.S.; Nagaraja, H.S.The enhancement of electrochemical performance in lithium-ion battery (LIB) anode materials through nanostructures is of paramount importance, facilitated by the synergistic integration of these unique architectures with active materials, which increases the availability of active sites and decreases the diffusion path for lithium ions. In this investigation, we successfully synthesized cobalt oxide (Co3O4) microsheets composed of small nanoparticles (measuring 28–33 nm), employing a straightforward hydrothermal process followed by annealing. Furthermore, to enhance the composite’s ability to endure volume changes and increase its electrical conductivity, we created a Co3O4/reduced graphene oxide (rGO) composite embedding a judicious amount of graphene oxide (GO). This engineered composite exhibited remarkable specific discharge capacity of 1081 mAh g−1 at 100 mA g−1, a substantial improvement over the pristine material’s capacity of 718 mAh g−1. The composite demonstrated reduced irreversible capacity loss relative to the pristine counterpart and approached a reversible capacity of nearly 99%. Even after 400 cycles under the demanding conditions of high current density of 500 mA g−1, the composite managed to retain 81% of its initial capacity, underscoring its exceptional cycling stability. Moreover, the application of the Co3O4/rGO//carbon black (CB) assembly in lithium-ion capacitors (LIC) yielded notable energy density of 15.6 Wh kg−1 at elevated power density of 1007 W kg−1. These LIC devices demonstrated robust cyclic stability across extended cycles, sustaining 56% of their initial capacity after 2000 cycles while operating at a current density of 2 A g−1. Graphical Abstract: [Figure not available: see fulltext.]. © 2024, The Minerals, Metals & Materials Society.Item Enhancing conductivity of Bi2O3 through ‘Fe3+’ doping for pseudocapacitor application(Springer Science and Business Media Deutschland GmbH, 2025) G, L.S.; Bhat, K.S.; Mukesh, P.; Hegde, A.P.; Kumar, A.; Brijesh, K.; Nagaraja, H.S.Binary metal oxides have emerged as pSromising materials for advanced electrochemical energy storage systems due to their superior performance characteristics. In this study, we focus on bismuth oxide (Bi?O?), a material renowned for its high theoretical capacity, wide potential range, and exceptional power density, as a potential candidate for supercapacitors. Iron doping was employed as a strategy to enhance its electrochemical performance and modulate the band gap, thereby improving conductivity and charge storage efficiency. Fe-doped bismuth oxide (Fe-Bi?O?) was synthesized via a solvothermal method with varying iron concentrations (2%, 4%, and 6%), followed by annealing. The pure and iron-doped bismuth oxide samples revealed a combination of monoclinic and cubic phases and a prominent micro-sheet architecture. The introduction of iron doping led to a noticeable reduction in the band gap, highlighting its role in fine-tuning the electronic properties for enhanced energy storage capabilities. The electrochemical evaluation highlighted the 4% Fe-Bi?O? sample as the optimal composition, achieving a remarkable specific capacity of 904 F g?1, a substantial improvement over 101 F g?1 for pristine Bi?O?, at 1 A g?1 in a 2 M KOH electrolyte. Moreover, this sample exhibited outstanding cyclic stability, retaining 104 F g?1 after 2000 cycles at 10 A g?1. © The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature 2025.