Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
5 results
Search Results
Item Nickel selenide nanostructures as an electrocatalyst for hydrogen evolution reaction(Elsevier Ltd, 2018) Bhat, K.S.; Nagaraja, H.S.Electrochemical water splitting has gained momentum for the development of alternative energy sources. Herein, we report the synthesis of two different nickel selenide nanostructures of different morphology and composition employing hydrothermal method. NiSe2 nanosheets were obtained by the anion-exchange reaction of Ni(OH)2 with Se ions for 15 h. On the other hand, NiSe nanoflakes were synthesized by the direct selenization of nickel surface with the reaction time of 2 h. Tested as an electrocatalyst for hydrogen evolution reaction, NiSe2 nanosheets and NiSe nanoflakes can afford a geometric current density of 10 mA cm?2 at an overpotential of 198 mV and 217 mV respectively. The measured Tafel slope values of NiSe nanoflakes are 28.6 mV dec?1, which is three times lower as compared with NiSe2 nanosheets (72.1 mV dec?1). These results indicates the HER kinetics of NiSe nanoflakes are at par with the state-of-the-art Pt/C catalyst and also complimented with the short synthesis time of 2 h. Further, both nickel selenides exhibit ultra-long term stability for 30 h as evident from constant current chronopotentiometry and electrochemical impedance spectroscopy results. © 2018 Hydrogen Energy Publications LLCItem Effect of isoelectronic tungsten doping on molybdenum selenide nanostructures and their graphene hybrids for supercapacitors(Elsevier Ltd, 2019) Bhat, K.S.; Nagaraja, H.S.Electrochemical supercapacitors are vital for the advancement of energy storage devices. Herein, we report the synthesis of molybdenum selenide (MoSe 2 ), tungsten-doped molybdenum selenide (W–MoSe 2 ) and their graphene (G) composites (W–MoSe 2 /G) via a facile hydrothermal method. Physiochemical properties of the as-synthesized samples are examined using X-ray diffraction, Raman spectroscopy, thermogravimetric analysis, X-ray photoelectron spectroscopy, Brunauer–Emmett–Teller measurements, scanning electron microscopy, high resolution transmission electron microscopy and energy dispersive X-ray spectroscopy measurements. Used as working electrodes for supercapacitors, MoSe 2 nanostructures could deliver the specific capacitance of 106 F g ?1 at 2 mV s ?1 scan rate. Further, doping with tungsten (W) demonstrates the variation of specific capacitances with 2 M % of tungsten as the optimum doping amount, delivering the maximum specific capacitance of 147 F g ?1 . Furthermore, graphene composites of these nanostructures deliver the enhanced specific capacitances of 248 F g ?1 and complimented with excellent capacitance retention capability of 102% for 20000 cycles. © 2019 Elsevier LtdItem Modulations of physio-chemical and electronic properties of metalorganic KHO single crystals through Co(OH)2 nanoparticles doping(Springer New York LLC barbara.b.bertram@gsk.com, 2019) Mahendra, K.; Bhat, K.S.; Nagaraja, H.S.; Udayashankar, N.K.Semiorganic crystals play vital role in the design and development of optical devices. In this context, we report the synthesis of metalorganic potassium hydrogen oxalate oxalic acid dihydrate (KHO) single crystals using slow solvent evaporation technique. Further, Co(OH)2 nanoparticles pre-synthesized using hydrothermal method are doped to KHO single crystals. Doping of Co(OH)2 nanoparticles in the crystal system were confirmed through XRD, EDAX and PL measurements. The XRD measurements indicate a shift in the peak positions and variation in the overall intensities. On the other hand, PL measurements also indicate enhanced emission peaks confirming the successful doping of Co(OH)2 nanoparticles in the KHO system. As the effect of doping, the declination in the optical bandgap and improvement of electronic conductivity were also observed. © 2019, Springer Science+Business Media, LLC, part of Springer Nature.Item Enhanced Electrochemical Performance of Low-Content Graphene Oxide in Porous Co3O4 Microsheets for Dual Applications of Lithium-Ion Battery Anode and Lithium-Ion Capacitor(Springer, 2024) Lakshmi Sagar, G.; Brijesh, K.; Mukesh, P.; Amudha, A.; Bhat, K.S.; Nagaraja, H.S.The enhancement of electrochemical performance in lithium-ion battery (LIB) anode materials through nanostructures is of paramount importance, facilitated by the synergistic integration of these unique architectures with active materials, which increases the availability of active sites and decreases the diffusion path for lithium ions. In this investigation, we successfully synthesized cobalt oxide (Co3O4) microsheets composed of small nanoparticles (measuring 28–33 nm), employing a straightforward hydrothermal process followed by annealing. Furthermore, to enhance the composite’s ability to endure volume changes and increase its electrical conductivity, we created a Co3O4/reduced graphene oxide (rGO) composite embedding a judicious amount of graphene oxide (GO). This engineered composite exhibited remarkable specific discharge capacity of 1081 mAh g−1 at 100 mA g−1, a substantial improvement over the pristine material’s capacity of 718 mAh g−1. The composite demonstrated reduced irreversible capacity loss relative to the pristine counterpart and approached a reversible capacity of nearly 99%. Even after 400 cycles under the demanding conditions of high current density of 500 mA g−1, the composite managed to retain 81% of its initial capacity, underscoring its exceptional cycling stability. Moreover, the application of the Co3O4/rGO//carbon black (CB) assembly in lithium-ion capacitors (LIC) yielded notable energy density of 15.6 Wh kg−1 at elevated power density of 1007 W kg−1. These LIC devices demonstrated robust cyclic stability across extended cycles, sustaining 56% of their initial capacity after 2000 cycles while operating at a current density of 2 A g−1. Graphical Abstract: [Figure not available: see fulltext.]. © 2024, The Minerals, Metals & Materials Society.Item Reinforcing NiO microsphere structural stability via amorphous carbon sheets obtained from waste milk for lithium-ion capacitor application(Springer Science and Business Media B.V., 2025) Lakshmi Sagar, G.; Brijesh, K.; Mukesh, P.; Hegde, A.P.; Kumar, A.; Paliwal, A.; Bhat, K.S.; Nagaraja, H.S.In the pursuit of sustainable chemistry and environmentally friendly energy storage, the study addressed the limitations of nickel oxide utilized as the active material for the anode in lithium-ion capacitors. Despite its abundance and favorable environmental properties, NiO suffered from significant volumetric expansion and slow electrochemical kinetics compared to carbon materials. To overcome these issues, amorphous carbon was extracted from spoiled waste milk through a simple combustion process, effectively converting biomass waste into renewable resources. The engineered NiO/amorphous carbon composite, synthesized through hydrothermal and annealing processes, mitigated the limitations of NiO. Field Emission Scanning Electron Microscopy confirmed the deposition of amorphous carbon sheets encasing NiO microspheres, which preserved structural integrity during electrochemical cycling. The amorphous carbon acted as a stabilizing matrix, encapsulating NiO microspheres to mitigate volumetric expansion and enhance lithium-ion transport kinetics. Electrochemical tests demonstrated a specific discharge capacity of 1230 mAh g?1 at a current density of 100 mA g?1, retaining 401 mAh g?1 after 1000 cycles at 1 A g?1, nearly doubling the retention performance of pristine NiO. Furthermore, the NiO/AC//AC lithium-ion capacitor achieved an energy density of 25.4 Wh kg?1 at a power density of 1991 W kg?1, maintaining 96% capacity after 3500 cycles. This study highlighted the potential of waste-derived carbon in developing high-performance, sustainable energy storage systems. © The Author(s), under exclusive licence to Springer Nature B.V. 2025.