Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item Novel Fe-Ni-Graphene composite electrode for hydrogen production(Elsevier Ltd, 2015) Badrayyana, S.; Bhat, D.K.; Shenoy, U.S.; Ullal, Y.; Hegde, A.We have developed a novel, efficient and economical composite electrode for hydrogen production. The electrode has been formed by embedding graphene in the Fe-Ni matrix via room temperature electrodeposition. The obtained active coatings have been tested for their efficiency and performance as electrode surfaces for hydrogen evolution reaction (HER) in 6 M KOH by cyclic voltammetry and chronopotentiometry techniques. The coating obtained at 60 mA cm-2 exhibited approximately 3 times higher activity for hydrogen production than that of binary Fe-Ni alloy. Addition of graphene to electrolyte bath resulted in porous 3D projections of nano-sized spheres of Fe-Ni on the surface of graphene, which effectively increased the electrochemically active surface area. XPS analysis results showed the equal distribution of both Ni metal and NiO active sites on the composite. The addition of graphene favoured the deposition of metallic nickel, which accelerated the rate determining proton discharge reaction. All these factors remarkably enhanced the HER activity of Fe-Ni-Graphene (Fe-Ni-G) composite electrode. The Tafel slope analysis showed that the HER follows Volmer-Tafel mechanism. The structure-property relationship of Fe-Ni-G coating has been discussed by interpreting field emission scanning electron microscopy (FESEM), X-ray photoelectron spectroscopy (XPS) and X-ray diffraction (XRD) analysis results. © 2015 Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.Item Facile solvothermal synthesis and high supercapacitor performance of NiCo2O4 nanorods(Elsevier Ltd, 2019) Sethi, M.; Bhat, D.K.NiCo2O4 nanorod arrays were synthesized employing a facile low-temperature solvothermal approach, followed by post-calcination treatment. The structural, morphological and elemental characterizations were done by diffraction, microscopic and spectroscopic techniques. The prepared sample was studied as an active electrode material for supercapacitor application in 2 M KOH aqueous electrolyte. The cyclic voltammetry (CV), galvanostatic charge-discharge (GCD) and electrochemical impedance spectral (EIS) studies were carried out to know the electrochemical activity of the prepared material. From the CV study, a high capacitance value of 440 F g?1 was obtained at a scan rate of 5 mV s?1 in a 3-electrode method. Apart from high capacitance value, the prepared electrode depicted 94% initial capacitance retention value after 2000 charge-discharge cycles at a current density of 8 A g?1. The fabricated symmetrical supercapacitor depicted a high energy density of 12.6 Wh kg?1 and a high power density of 4003 W kg?1. This was attributed to the better electrical conductivity of NiCo2O4 nanorods. © 2018 Elsevier B.V.Item Porous graphene-NiCo2O4 nanorod hybrid composite as a high performance supercapacitor electrode material(Royal Society of Chemistry, 2020) Sethi, M.; Shenoy, U.S.; Bhat, D.K.The template free low temperature solvothermal synthesis of high capacitive porous graphene-NiCo2O4 nanorod composites has been carried out. Solvothermal synthesis followed by calcination in air led to the development of a highly porous hybrid nanocomposite, which acts as a buffering channel for fast ion diffusion and provides robust mechanical strength. Advantages of using porous graphene to enhance the capacitance of the material were studied theoretically using First principles calculations. High capacitance values of 1533 F g-1 at a scan rate of 5 mV s-1 and 1684 F g-1 at a current density of 1 A g-1 are obtained from cyclic voltammetry data and galvanostatic charge discharge data, respectively. The electrode material possesses good cyclic stability with the retention of 94% of its initial capacitance even after 10000 charge-discharge cycles at a current density of 8 A g-1 in 2 M KOH electrolyte. The fabricated supercapacitor exhibited a high energy density of 45.3 W h kg-1 and a high power density of 17843.5 W kg-1 due to the synergistic effect of the composite components. The enhanced electrochemical function of the composite makes it a potential candidate for supercapacitor application and future studies. This journal is © 2020 The Royal Society of Chemistry and the Centre National de la Recherche Scientifique.Item A porous graphene-NiFe2O4nanocomposite with high electrochemical performance and high cycling stability for energy storage applications(Royal Society of Chemistry orders@rsc.org, 2020) Sethi, M.; Shenoy, U.S.; Bhat, D.K.It is well agreed that supercapacitors form an important class of energy storage devices catering to a variety of needs. However, designing the same using eco-friendly and earth abundant materials with high performance is still the dire need of the day. Here, we report a facile solvothermal synthesis of a porous graphene-NiFe2O4 (PGNF) nanocomposite. Thorough elemental, diffraction, microscopic and spectroscopic studies confirmed the formation of the PGNF composite, in which the NF nanoparticles are covered over the PG surface. The obtained 10 PGNF composite showed a surface area of 107 m2 g-1, with large pore volume which is favorable for charge storage properties. When utilizing the material as an electrode for a supercapacitor in a 2 M KOH aqueous electrolyte, the electrode displayed an impressive specific capacitance value of 1465.0 F g-1 at a scan rate of 5 mV s-1 along with a high capacitance retention of 94% after 10?000 discharge cycles. The fabricated symmetrical supercapacitor device exhibited an energy density of 4.0 W h kg-1 and a power density of 3600.0 W kg-1 at a high applied current density of 14 A g-1. The superior electrochemical performance is attributed to the synergetic effect of the composite components which not only provided enough electroactive channels for the smooth passage of electrolyte ions but also maintained the hybrid structure intact in the ongoing electrochemical process. The obtained results underpin the promising utility of this material for future electrochemical energy storage devices. © The Royal Society of Chemistry.Item Hassle-free solvothermal synthesis of NiO nanoflakes for supercapacitor application(Elsevier B.V., 2021) Sethi, M.; Shenoy, U.S.; Bhat, D.K.A mixed solvent solvothermal approach was employed for the synthesis of NiO (NO) nanostructures under a low temperature route. The nanoflakes when studied for its electrochemical performance in a 3-electrode method in aqueous 2 M KOH revealed a high capacitance value of 305.0 F g?1 at a scan rate of 5 mV s?1 apart from good rate capability, cyclic stability and coulombic efficiency. The fabricated symmetrical supercapacitor device also showed good electrochemical performance of pseudocapacitive nature with a high power density of 8000.0 W kg?1. The extent of surface sites taking part in the electrochemical processes reveals the enhanced performance is due to the high surface area of NO with a mesoporous structure. The enhanced conductivity of the nanoflakes also provided an unhindered path way for the ionic transport. The promising results reveal that the synthetic technique employed could be extended to other oxides as well. © 2021 Elsevier B.V.Item Exploring the potential of CoAl2O4 nanoflakes in supercapacitor applications(Elsevier B.V., 2025) Ramesh, T.P.; Shenoy, U.S.; Bhat, D.K.Spinel structured nanoparticles with binary and ternary metal oxide combinations have recently been identified as a viable material for use in supercapacitors. Two mixed-valence metal cations provide easy electron transport between various metal cations. High-performance CoAl2O4 spinel nanoflakes were synthesized using a mixed-solvent solvothermal method, followed by calcination. First principles calculations revealed high density of states near the Fermi level indicating its potential for supercapacitor applications. These nanostructured materials were then experimentally explored as promising electrode candidates for supercapacitor applications, using a 2 M KOH aqueous electrolyte. The results were impressive: the material demonstrated a high specific capacitance of 851.9 F/g at a current density of 1 A/g and the fabricated supercapacitor exhibited a power density of 14940.0 W/kg at a current density of 12 A/g. Even under more demanding conditions, the electrode maintained strong durability, in terms of cyclic stability along with high energy and power density values making it a strong contender for next-generation energy storage devices. © 2025 Elsevier B.V.