Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
8 results
Search Results
Item Nano ZnO-activated carbon composite electrodes for supercapacitors(2010) Muthu, M.S.; Bhat, D.K.; Aggarwal, A.; Prahladh Iyer, S.; Sravani, G.A symmetrical (p/p) supercapacitor has been fabricated by making use of nanostructured zinc oxide (ZnO)-activated carbon (AC) composite electrodes for the first time. The composites have been characterized by field emission scanning electron microscopy (FESEM) and X-ray diffraction analysis (XRD). Electrochemical properties of the prepared nanocomposite electrodes and the supercapacitor have been studied using cyclic voltammetry (CV) and AC impedance spectroscopy in 0.1 M Na2SO4 as electrolyte. The ZnO-AC nanocomposite electrode showed a specific capacitance of 160 F/g for 1:1 composition. The specific capacitance of the electrodes decreased with increase in zinc oxide content. Galvanostatic charge-discharge measurements have been done at various current densities, namely 2, 4, 6 and 7 mA/cm2. It has been found that the cells have excellent electrochemical reversibility and capacitive characteristics in 0.1 M Na2SO4 electrolyte. It has also been observed that the specific capacitance is constant up to 500 cycles at all current densities. © 2010 Elsevier B.V. All rights reserved.Item Microwave synthesized nanostructured TiO 2 -activated carbon composite electrodes for supercapacitor(Elsevier B.V., 2012) Muthu, M.; Bhat, D.K.Electrochemical properties of a supercapacitor based on nanocomposite electrodes of activated carbon with TiO 2 nano particles synthesized by a microwave method have been determined. The TiO 2 /activated carbon nanocomposite electrode with a composition of 1:3 showed a specific capacitance 92 Fg -1 . The specific capacitance of the electrode decreased with increase in titanium dioxide content. The p/p symmetrical supercapacitor fabricated with TiO 2 /activated carbon composite electrodes showed a specific capacitance of 122 Fg -1 . The electrochemical behavior of the neat TiO 2 nanoparticles has also been studied for comparison purpose. The galvanostatic charge-discharge test of the fabricated supercapacitor showed that the device has good coulombic efficiency and cycle life. The specific capacitance of the supercapacitor was stable up to 5000 cycles at current densities of 2, 4, 6 and 7 mA cm -2 . © 2012 Elsevier B.V.Item Effect of acid dopants in biodegradable gel polymer electrolyte and the performance in an electrochemical double layer capacitor(Institute of Physics Publishing custserv@iop.org, 2015) Sudhakar, Y.N.; Muthu, M.; Bhat, D.K.Proton-conducting biodegradable gellan gum gel polymer electrolytes (GPEs) have been prepared using three different dopants, namely ortho-phosphoric (o-H3PO4), sulfuric (H2SO4) and hydrochloric acids (HCl). The GPEs were cross-linked using borax. The polymeric gels were characterized by spectroscopic, thermal, ionic conductivities and dielectric measurements. Proton conductivity was in the range of 5.1 × 10-3 to 3.7 × 10-4 s cm-1 and activation energies were between 0.14 meV and 0.19 meV, at different temperatures. Among the doped acids, the H3PO4 doped GPE exhibited thermal stability at varying temperature. Electrochemical double layer capacitors (EDLCs) were fabricated using activated carbon as electrode material and GPEs. The EDLCs were tested using cyclic voltammetry, ac impedance spectroscopic and galvanostatic charge-discharge techniques. The maximum specific capacitance value was 146 F g-1 at a scan rate of 2 mV s-1. Quite stable values were obtained at a constant current density up to 1000 cycles. © 2015 The Royal Swedish Academy of Sciences.Item Preparation and characterization of phosphoric acid-doped hydroxyethyl cellulose electrolyte for use in supercapacitor(SpringerOpen, 2015) Sudhakar, Y.N.; Muthu, M.; Bhat, D.K.A new borax cross-linked biodegradable solid polymer electrolyte based on hydroxyethyl cellulose and phosphoric acid (H3PO4) was prepared. Characterizations of doped and undoped SPE were done using Fourier transform infrared spectroscopic and electrochemical studies. The ionic conductivity of the films increased with increase in acid concentration and the ionic conductivity obtained at 303 K was 4.1 × 10-3 S cm-1. Furthermore, effects of acid concentration on ionic conductivity and activation energy were discussed. Dielectric studies showed long tail-like feature indicating capacitive nature. A supercapacitor was fabricated and its electrochemical characteristics were studied. The supercapacitor showed a fairly good specific capacitance of 83 F g-1 at 2 mV s-1 and galvanostatic charge-discharge studies showed the mirror-like pattern with 98 % columbic efficiency. Cyclic stability was measured up to 2000 cycles. © 2015 The Author(s).Item Novel Fe-Ni-Graphene composite electrode for hydrogen production(Elsevier Ltd, 2015) Badrayyana, S.; Bhat, D.K.; Shenoy, U.S.; Ullal, Y.; Hegde, A.We have developed a novel, efficient and economical composite electrode for hydrogen production. The electrode has been formed by embedding graphene in the Fe-Ni matrix via room temperature electrodeposition. The obtained active coatings have been tested for their efficiency and performance as electrode surfaces for hydrogen evolution reaction (HER) in 6 M KOH by cyclic voltammetry and chronopotentiometry techniques. The coating obtained at 60 mA cm-2 exhibited approximately 3 times higher activity for hydrogen production than that of binary Fe-Ni alloy. Addition of graphene to electrolyte bath resulted in porous 3D projections of nano-sized spheres of Fe-Ni on the surface of graphene, which effectively increased the electrochemically active surface area. XPS analysis results showed the equal distribution of both Ni metal and NiO active sites on the composite. The addition of graphene favoured the deposition of metallic nickel, which accelerated the rate determining proton discharge reaction. All these factors remarkably enhanced the HER activity of Fe-Ni-Graphene (Fe-Ni-G) composite electrode. The Tafel slope analysis showed that the HER follows Volmer-Tafel mechanism. The structure-property relationship of Fe-Ni-G coating has been discussed by interpreting field emission scanning electron microscopy (FESEM), X-ray photoelectron spectroscopy (XPS) and X-ray diffraction (XRD) analysis results. © 2015 Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.Item Facile solvothermal synthesis and high supercapacitor performance of NiCo2O4 nanorods(Elsevier Ltd, 2019) Sethi, M.; Bhat, D.K.NiCo2O4 nanorod arrays were synthesized employing a facile low-temperature solvothermal approach, followed by post-calcination treatment. The structural, morphological and elemental characterizations were done by diffraction, microscopic and spectroscopic techniques. The prepared sample was studied as an active electrode material for supercapacitor application in 2 M KOH aqueous electrolyte. The cyclic voltammetry (CV), galvanostatic charge-discharge (GCD) and electrochemical impedance spectral (EIS) studies were carried out to know the electrochemical activity of the prepared material. From the CV study, a high capacitance value of 440 F g?1 was obtained at a scan rate of 5 mV s?1 in a 3-electrode method. Apart from high capacitance value, the prepared electrode depicted 94% initial capacitance retention value after 2000 charge-discharge cycles at a current density of 8 A g?1. The fabricated symmetrical supercapacitor depicted a high energy density of 12.6 Wh kg?1 and a high power density of 4003 W kg?1. This was attributed to the better electrical conductivity of NiCo2O4 nanorods. © 2018 Elsevier B.V.Item Porous graphene-NiCo2O4 nanorod hybrid composite as a high performance supercapacitor electrode material(Royal Society of Chemistry, 2020) Sethi, M.; Shenoy, U.S.; Bhat, D.K.The template free low temperature solvothermal synthesis of high capacitive porous graphene-NiCo2O4 nanorod composites has been carried out. Solvothermal synthesis followed by calcination in air led to the development of a highly porous hybrid nanocomposite, which acts as a buffering channel for fast ion diffusion and provides robust mechanical strength. Advantages of using porous graphene to enhance the capacitance of the material were studied theoretically using First principles calculations. High capacitance values of 1533 F g-1 at a scan rate of 5 mV s-1 and 1684 F g-1 at a current density of 1 A g-1 are obtained from cyclic voltammetry data and galvanostatic charge discharge data, respectively. The electrode material possesses good cyclic stability with the retention of 94% of its initial capacitance even after 10000 charge-discharge cycles at a current density of 8 A g-1 in 2 M KOH electrolyte. The fabricated supercapacitor exhibited a high energy density of 45.3 W h kg-1 and a high power density of 17843.5 W kg-1 due to the synergistic effect of the composite components. The enhanced electrochemical function of the composite makes it a potential candidate for supercapacitor application and future studies. This journal is © 2020 The Royal Society of Chemistry and the Centre National de la Recherche Scientifique.Item A porous graphene-NiFe2O4nanocomposite with high electrochemical performance and high cycling stability for energy storage applications(Royal Society of Chemistry orders@rsc.org, 2020) Sethi, M.; Shenoy, U.S.; Bhat, D.K.It is well agreed that supercapacitors form an important class of energy storage devices catering to a variety of needs. However, designing the same using eco-friendly and earth abundant materials with high performance is still the dire need of the day. Here, we report a facile solvothermal synthesis of a porous graphene-NiFe2O4 (PGNF) nanocomposite. Thorough elemental, diffraction, microscopic and spectroscopic studies confirmed the formation of the PGNF composite, in which the NF nanoparticles are covered over the PG surface. The obtained 10 PGNF composite showed a surface area of 107 m2 g-1, with large pore volume which is favorable for charge storage properties. When utilizing the material as an electrode for a supercapacitor in a 2 M KOH aqueous electrolyte, the electrode displayed an impressive specific capacitance value of 1465.0 F g-1 at a scan rate of 5 mV s-1 along with a high capacitance retention of 94% after 10?000 discharge cycles. The fabricated symmetrical supercapacitor device exhibited an energy density of 4.0 W h kg-1 and a power density of 3600.0 W kg-1 at a high applied current density of 14 A g-1. The superior electrochemical performance is attributed to the synergetic effect of the composite components which not only provided enough electroactive channels for the smooth passage of electrolyte ions but also maintained the hybrid structure intact in the ongoing electrochemical process. The obtained results underpin the promising utility of this material for future electrochemical energy storage devices. © The Royal Society of Chemistry.