Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item Quasi-Static and High Strain Rate Compressive Response of Injection-Molded Cenosphere/HDPE Syntactic Foam(Minerals, Metals and Materials Society 184 Thorn Hill Road Warrendale PA 15086, 2016) Bharath Kumar, B.R.; Singh, A.K.; Doddamani, M.R.; Luong, D.D.; Gupta, N.High strain rate compressive properties of high-density polyethylene (HDPE) matrix syntactic foams containing cenosphere filler are investigated. Thermoplastic matrix syntactic foams have not been studied extensively for high strain rate deformation response despite interest in them for lightweight underwater vehicle structures and consumer products. Quasi-static compression tests are conducted at 10?4 s?1, 10?3 s?1 and 10?2 s?1 strain rates. Further, a split-Hopkinson pressure bar is utilized for characterizing syntactic foams for high strain rate compression. The compressive strength of syntactic foams is higher than that of HDPE resin at the same strain rate. Yield strength shows an increasing trend with strain rate. The average yield strength values at high strain rates are almost twice the values obtained at 10?4 s?1 for HDPE resin and syntactic foams. Theoretical models are used to estimate the effectiveness of cenospheres in reinforcing syntactic foams. © 2016, The Minerals, Metals & Materials Society.Item Prediction of strain rate sensitivity of high density polyethylene using integral transform of dynamic mechanical analysis data(Elsevier Ltd, 2016) Zeltmann, S.E.; Bharath Kumar, B.R.; Doddamani, M.R.; Gupta, N.Recent interest in understanding the effect of strain rate on mechanical properties has motivated this study to develop a correlation between frequency domain dynamic mechanical analysis (DMA) results and elastic modulus values that are obtained from a separate set of elaborate tensile tests conducted over a wide range of strain rates. Using the time-temperature superposition principle and the integral relations of viscoelasticity, the DMA results are converted into a time-domain relaxation function in order to predict the strain-rate dependent modulus. The transformation technique is validated with experimental results for high density polyethylene (HDPE) resin and is found to be accurate over a wide range of strain rates. Cross correlation between DMA results and tensile test results over a wide range of strain rates can help in substantially reducing the requirement for tests that are needed to characterize the material behavior with respect to strain rates, temperature and loading frequency. © 2016 Elsevier LtdItem Compressive behavior of fly ash based 3D printed syntactic foam composite(Elsevier B.V., 2019) Patil, B.; Bharath Kumar, B.R.; Doddamani, M.Syntactic foams are widely used in damage tolerance and low-density applications. In present work compressive behavior of 3D printed three-phase syntactic foams under quasi-static strain rates (0.001, 0.01 and 0.1 s?1) are investigated. Extruded filaments of High density polyethylene (HDPE) with environmentally pollutant fly ash cenospheres (0, 20, 40 and 60 vol%) are used for 3D printing. Micrography reveal that syntactic foam filament and 3D printed samples are three phase systems comprising matrix, cenosphere and porosity. Matrix porosity of about 7% makes these foams lightweight and suitable for buoyant applications. The compressive properties are extracted from the stress-strain plots. It is observed that modulus and specific modulus increases with strain rate and cenosphere content. Specific compressive strength increases with strain rate and decrease with cenosphere content. © 2019 Elsevier B.V.