Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item Magnetically retrievable nickel hydroxide functionalised AFe2O4 (A = Mn, Ni) spinel nanocatalyst for alcohol oxidation(Springer Nature, 2016) Bhat, P.B.; Badekai Ramachandra, B.R.Ultrasmall nickel hydroxide functionalised AFe2O4 (A = Mn, Ni) nanocatalyst was synthesized by traditional co-precipitation method and was examined for oxidation of aromatic alcohols to carbonyls using hydrogen peroxide as terminal oxidant. A very high surface area of 104.55 m2 g?1 was achieved for ferromagnetic MnFe2O4 and 100.50 m2 g?1 for superparamagnetic NiFe2O4, respectively. Efficient oxidation was observed due to the synergized effect of nickel hydroxide (bronsted base) on Lewis center (Fe) of the nanocatalyst. Catalyst recycling experiments revealed that the ultrasmall nanocatalyst can be easily recovered by external magnet and applied for nearly complete oxidation of alcohols for at least five successive cycles. Furthermore, the nickel hydroxide functionalised ultrasmall nanocatalyst exhibited higher efficiency for benzyl alcohol oxidation compared to Ni(OH)2, bare MnFe2O4 and NiFe2O4. Higher conversion rate was observed for nickel hydroxide functionalised NiFe2O4 compared to MnFe2O4. Ultrasmall magnetic nickel hydroxide functionalised nanocatalyst showed environmental friendly, greener route for the oxidation of alcohols without significant loss in activity and selectivity within successive runs. © 2015, The Author(s).Item Thermally stable complexes of Fe(III), Co(II), Ni(II) and Cu(II) with Schiff base derived from 4-aminoacetophenone and salicylaldehyde(Springer, 2022) Ansari, R.M.; Ramakrishna, D.; Badekai Ramachandra, B.R.The Schiff base ligand 1-(4-((2-hydroxybenzylidene)amino)phenyl)ethan-1-one, obtained from 4-aminoacetophenone and salicylaldehyde, and its complexes with Fe(III), Co(II), Ni(II) and Cu(II) have been synthesized. These complexes were characterized by FTIR spectroscopy, elemental, and SCXRD analysis. FTIR spectra of complexes show the bidentate coordination of metal ions with ligands where O and N are electron-donating sites of the azomethine group. The electronic absorption spectra of these complexes show the characteristics of absorption bands involved in the Fe, Co, and Ni complexes due to their π→π*, n→π* transitions. Further, the geometry of the complexes was deduced from the calculated magnetic moment values and single crystal XRD analysis. Graphical abstract: A Schiff base derived from the condensation reaction between 2-aminoacetophenone and salicylaldehyde was involved in the formation of four different metal complexes, i.e., with Nickel, Cobalt, Iron, and Copper. The synthetic route to forming these complexes followed an easy process, and the complexes were obtained in good yields.[Figure not available: see fulltext.] © 2022, Indian Academy of Sciences.Item Bi-functional LaMxFe1-xO3 (M = Cu, Co, Ni) for photo-fenton degradation of methylene blue and photoelectrochemical water splitting(Elsevier Ltd, 2023) James, A.; Rodney, J.D.; Rao, L.; Badekai Ramachandra, B.R.; Udayashankar, N.K.Due to growing concern over environmental remediation and the energy crisis, perovskite nanoparticles have gained wide interest in converting solar energy to sustainable fuel and also in degrading organic effluents. Herein, we report the synthesis and bi-functional activity of one-pot-glycine combustion derived LaMxFe1-xO3 (M = Cu, Co, Ni; x = 0, 0.01) for photo-Fenton degradation of Methylene Blue (MB) and photoelectrochemical water splitting. When used as a photocatalyst, with partial substitution of Cu even at a lower concentration, LaCu0.01Fe0.99O3 has exhibited excellent degradation efficiency of 96.4% in 90 min, which is 2.5 times better than the LaFeO3. On the other hand, Co and Ni modified LaFeO3 photocatalysts have demonstrated prominent activities with degradation efficiency of 93.8% and 74.8% respectively within 180 min of visible light irradiation. The retention and reusability analysis showed that LaCu0.01Fe0.99O3 is stable against photo corrosion and remains unchanged after 5 consecutive cycles of MB dye degradation. In addition, LaCu0.01Fe0.99O3 is complimented as a single catalyst for dual functions such as photocatalysis and electrocatalysis, both of which are assisted by visible light. Under illumination, the overpotential (η) improved from 507.6 mV vs RHE (dark) to 498.1 mV vs RHE (light) for O2 evolution and 220.5 mV vs RHE (dark) to 182.8 mV vs RHE (light) for H2 generation respectively. The light response of the catalyst and improvement in activity is validated by the significant enhancement in current density under exposure at both half cycle of chronoamperometry. © 2023 Hydrogen Energy Publications LLCItem Cobalt-doped LaFeO3 for photo-Fenton degradation of organic pollutants and visible-light-assisted water splitting(Springer, 2024) James, A.; Rodney, J.D.; Manojbabu, A.; Joshi, S.; Rao, L.; Badekai Ramachandra, B.R.; Udayashankar, N.K.The increasing demand for clean energy sources and the growing concerns about environmental pollution have led to a significant interest in developing efficient photocatalytic and photoelectrochemical systems. Here, we report the visible-light-induced photo-Fenton catalytic degradation of Methylene Blue (MB) dye over LaFeO3 and LaCo xFe1−xO3 (x = 0.01, 0.05, 0.1) catalysts synthesized via the facile combustion method. The LaCo0.01Fe0.99O3 has significantly enhanced the photo-Fenton catalytic efficiency of LaFeO3 from 67.75 to 93.85% for MB dye removal after 180 min of light irradiation. The rate constants calculated via the pseudo-first-order kinetics mechanism are found to be 0.00532/min for LaFeO3 and 0.01476/min for LaCo0.01Fe0.99O3, respectively. In addition, the most effective LaCo0.01Fe0.99O3 catalyst has demonstrated remarkable degradation performance towards Tetracycline (TC) and Methyl Orange (MO) dye with an efficacy of 93.81% and 69.67%, respectively, indicating its versatility. Further, the pristine and doped LaFeO3 were structurally optimized using DFT, and the computed band gaps were following the experimental data. Interestingly, the same catalyst can be employed as a light-induced electrocatalyst in addition to water treatment by taking advantage of its dual functionality. The LaCo0.01Fe0.99O3 catalyst achieved a benchmark current density of 10 mA/cm2 for H2 evolution at an overpotential of 297 mV vs. RHE which further improved to 190 mV vs. RHE under illumination. This work provides valuable insights on partial Co incorporation at the B-site of LaFeO3 for the development of visible-light-induced photocatalytic and electrocatalytic systems, which is hoped to contribute to the advancement of sustainable energy production and environmental remediation. © 2024, The Author(s), under exclusive licence to Springer Science+Business Media, LLC, part of Springer Nature.Item Biomass waste-derived porous graphitic carbon for high-performance supercapacitors(Elsevier Ltd, 2024) Hegde, S.S.; Badekai Ramachandra, B.R.Porous carbons possess considerable appeal and are in high demand as materials that can be produced from biomass waste. This study presents the transformation of Tectona grandis (Teak) sawdust into porous carbon materials, referred to as Tectona grandis sawdust-derived porous carbon (TPC), through a cost-effective FeCl3-assisted carbonization process, followed by a KOH activation. TPC samples were synthesized by carbonization at different temperatures (650–850 °C) and characterized comprehensively. Structural analysis via X-Ray diffraction (XRD), Raman, and Fourier Transform Infrared Spectroscopy (FTIR) revealed a progressive enhancement in graphitic structure and reduction of functional groups with increasing activation temperature. Field emission scanning electron microscopy (FESEM) displayed the development of intricate hollow tube-like porous networks in TPC-850, with the highest specific surface area (1767.66 m2/g) and pore volume (1.43 cm3/g). Electrochemical investigations showcased the superior performance of TPC-850 as a supercapacitor electrode due to its high graphitic nature, large surface area, and well-structured porosity. The galvanostatic charge-discharge (GCD) measurements exhibited a high specific capacitance of 572 F/g at 0.5 A/g in a 6 M KOH electrolyte. The high-frequency semicircle and low-frequency steeper region in electrochemical impedance spectroscopy (EIS) further indicated reduced resistance and enhanced ion diffusion in TPC-850. Significantly, TPC-850 demonstrated remarkable electrochemical cyclic stability, retaining 95.83 % of its initial capacity even after undergoing 4500 cycles at a scan rate of 500 mV/s. The findings underscore the viability of TPC-850 as a high-performance supercapacitor electrode material, providing insights into harnessing renewable resources for advanced energy solutions. This work highlights the potential of utilizing waste biomass for energy storage applications and demonstrates the feasibility of converting it into efficient porous carbon materials with substantial graphitization and porosity. © 2023 Elsevier LtdItem Sustainable energy storage: Mangifera indica leaf waste-derived activated carbon for long-life, high-performance supercapacitors(Royal Society of Chemistry, 2024) Hegde, S.S.; Badekai Ramachandra, B.R.Biomass waste-derived activated carbon has a wide range of applications, including air and water purification, gas separation, energy storage, and catalysis. This material has become increasingly popular in recent years as a result of the growing demand for sustainable and eco-friendly materials. In this study, Mangifera indica leaf waste-derived activated carbon has been investigated as an electrode material for high-performance supercapacitors. The dried Mangifera indica leaves were first carbonized using FeCl3 and then activated using KOH to increase their surface area and pore structure at different temperatures. The activated carbon prepared at 725 °C has shown a high specific capacitance of 521.65 F g−1 at a current density of 0.5 A g−1 and also achieved an energy density of 17.04 W h kg−1 at a power density of 242.50 W kg−1 in the 6 M KOH electrolyte. Significantly, it has demonstrated remarkable electrochemical cycling stability, retaining 96.60% of its initial capacity even after undergoing 10 001 cycles at a scan rate of 500 mV s−1. The superior electrochemical performance of the activated carbon can be attributed to its high surface area of 1232.63 m2 g−1, well-distributed pore size, and excellent degree of graphitization, which all facilitate the rapid diffusion of ions and enhance the accessibility of the electrolyte to the electrode surface. Hence, this study provides a promising route for utilizing waste biomass as a low-cost, sustainable electrode material for energy storage devices. © 2024 The Royal Society of Chemistry.