Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Author: search.filters.author.Asiri, A.M.Subject: search.filters.subject.Scanning electron microscopy

Search Results

Now showing 1 - 3 of 3
  • No Thumbnail Available
    Item
    Novel polyphenylsulfone (PPSU)/nano tin oxide (SnO2) mixed matrix ultrafiltration hollow fiber membranes: Fabrication, characterization and toxic dyes removal from aqueous solutions
    (Elsevier B.V., 2019) Nayak, M.C.; Isloor, A.M.; Siddique, I.; Balakrishna Prabhu, B.; Ismail, N.I.; Asiri, A.M.
    Novel polyphenylsulfone (PPSU)/nano tin oxide (SnO2) mixed matrix hollow fiber membranes (HFMs) were fabricated by dry-wet spinning via phase separation method. In the current research, reported the contrast between neat PPSU membrane and nanocomposite membranes (PPSU/SnO2), to determine the toxic reactive dyes namely, reactive black-5 (RB-5) and reactive orange-16 (RO-16) removal ability from the aqueous media. Scanning electron microscopy (SEM) was used to observe the HFMs cross-sectional morphological changes and surface roughness parameters of membranes were analyzed using atomic force microscopy (AFM). The surface wettability ability of HFMs was examined with a contact angle, water uptake, and porosity measurements. The cross-flow filter unit was engaged to quantify the water permeability, anti-fouling ability as well as the dye rejection ability of fabricated membranes. With increasing the SnO2 NPs wt% in PPSU polymer matrix the membrane performance was enhanced continuously, it became evident that the incorporated SnO2 NPs plays main role in membrane performance. Added, water-soluble poly (vinylpyrrolidone) (PVP) can also impact the pore morphology in membranes. At the end, PS-3 membrane exhibited lower contact angle (63.7 0), higher water uptake (74.8%), porosity (84.1%), pure water flux 362.9 L/m2 h, and high potential for dyes rejection application, of about >94% for RB-5, and >73% for RO-16 dye, respectively. From the preliminary results, it can be stated that the usage of SnO2 NPs in membrane technology become effective towards wastewater treatment. © 2019 Elsevier B.V.
  • No Thumbnail Available
    Item
    Improved desalination by polyamide membranes containing hydrophilic glutamine and glycine
    (Springer Science and Business Media Deutschland GmbH, 2019) Kolangare, I.M.; Isloor, A.M.; Siddique, I.; Asiri, A.M.; A.F., A.F.
    Water desalination and recycling of wastewater is a key challenge to meet water shortage issues. Thin film composite polyamide membranes are widely used for desalination; however, their low permeability due to a poor hydrophilicity is a major drawback. Here, we designed novel thin film composite membranes having good hydrophilicity, permeability, and stability without compromising solute rejection. We improved the membrane hydrophilicity by incorporation of hydrophilic additives, such as glycine and l-glutamine, into the polyamide layer. Hence polyamide-based flat sheet membranes were fabricated via interfacial polymerization of m-phenylenediamine and trimesoyl chloride and then were coated over a polysulfone/sulfonated polyphenylsulfone (85:15) support. Polyamide membranes were then characterized and tested for desalination. Results show that the ridge and valley structure observed by scanning electron microscopy confirms the formation of the polyamide layer on membrane surface. The performance reached the highest pure water flux of 36.23 Lm?2 h?1 and flux recovery ratio of 89.18% for membranes with 2 wt% of l-glutamine. Incorporation of 2 wt% l-glutamine induced a high permeate flux and a maximum rejection of 87.87% for MgSO4, 83.50% for Na2SO4 and 60.77% for NaCl solutions. Overall, the polyamide nanofiltration membrane with hydrophilic groups displayed superior antifouling property and can be used as a potential candidate for desalination. © 2018, Springer Nature Switzerland AG.
  • No Thumbnail Available
    Item
    Improved separation of dyes and proteins using membranes made of polyphenylsulfone/cellulose acetate or acetate phthalate
    (Springer Science and Business Media Deutschland GmbH, 2020) Kumar, M.; Isloor, A.M.; Todeti, S.R.; Gnani Peer Mohamed, G.P.S.; Siddique, I.; A.F., A.F.; Asiri, A.M.
    Industrial wastewater often contains xenobiotics such as heavy metals, dyes and proteins, yet there is a lack of efficient cleaning methods. Therefore, here we fabricated hollow fiber membranes using polyphenylsulfone containing 1, 3 and 5 wt% of cellulose acetate and cellulose acetate phthalate by non-solvent induced phase separation. Membrane morphology was characterized by field emission scanning electron microscopy. The hydrophilicity of the membranes was measured by contact angle, water uptake and porosity measurement. The thermal miscibility of the membrane with additives was assessed by thermogravimetric analysis. Hollow fiber membranes were tested for separation of azo dyes, e.g., reactive orange 16 and reactive black 5, and of proteins: bovine serum albumin, egg albumin and pepsin. Results show increasing rejection of dyes and proteins with the content of cellulose acetate and cellulose acetate phthalate. Water permeability was 41.26 L/m2 h bar for the polyphenylsulfone membrane, 64.47 L/m2 h bar for the polyphenylsulfone/5 wt% cellulose acetate membrane and 72.60 L/m2 h bar for the polyphenylsulfone/5 wt% cellulose acetate phthalate membrane. © 2020, Springer Nature Switzerland AG.