Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
2 results
Search Results
Item Effect of Build Orientation on Anisotropy in Tensile Behavior of Laser Powder Bed Fusion Fabricated SS316L(Springer, 2024) Thanumoorthy, R.S.; Chaurasia, J.K.; Anil Kumar, V.A.; Pradeep, P.I.; Balan, A.A.S.; Rajasekaran, B.; Sahu, A.; Bontha, S.In the present study, Stainless steel 316L (SS316L) cylindrical specimens were fabricated at two different build orientations and two different laser powers using Laser powder bed fusion process (LPBF). Microstructural characterization such as XRD, SEM, EBSD analysis and tensile testing were carried out on fabricated specimens in stress relieved condition to understand the anisotropic behavior of LPBF printed specimens. Horizontally oriented specimens showed higher tensile strength when compared to vertically oriented specimens for both laser powers. XRD and EBSD phase maps did not reveal the presence of any secondary phases. However, build orientation and laser power affected the crystallite size of the samples. Bimodal grain structure comprising coarse columnar grains and fine equiaxed grains were observed from the micrographs. With variation in build orientation, there was a significant change in the average grain size of the specimens. High dislocation density was observed in horizontally oriented samples built at low laser power because of dislocation annihilation that can occur at high temperatures. However, EBSD analysis revealed random weak crystallographic texture which does not vary significantly with laser power or build orientation. Variation in grain size, grain morphology, sub-grain features and dislocation density are the reasons for the anisotropic tensile behavior observed in LPBF printed SS316L coupons in stress relieved condition. © ASM International 2023.Item Tailoring the Microstructure and Mechanical Properties of Laser Powder-Directed Energy-Deposited Inconel 625 Using Scan Strategies(Springer, 2025) Aromal, S.S.; Malathesh, P.B.; Thanumoorthy, R.S.; Agasti, S.K.; Praharaj, A.K.; Anil Kumar, V.A.; Sudarshan Rao, G.S.; Bontha, S.The current study is focused on the influence of different scan strategies on the microstructural evolution, crystallographic texture, and mechanical properties of the Inconel 625 (IN625) fabricated using the laser powder-directed energy deposition (LP-DED) process. Prior to the deposition of the bulk specimens, an optimized set of process parameters (laser power (P), scan speed (v), and feed rate (f)) was selected through analysis of single-track deposits. The single tracks were thoroughly analyzed based on the aspect ratio, track stability, dilution, and shape of the melt pool. Further, six rectangular blocks of IN625 with different scan strategies (unidirectional ? 0°, bidirectional ? 0°, 45°, 67°, 90°, and spiral) were fabricated using the optimized process parameters for deposition. Samples with a 0° unidirectional scan strategy exhibited higher yield strength values but lower ductility. Notably, the sample with a scan orientation of 67° exhibited superior isotropic properties that are required to bear intense multi-axial loads when compared to other samples. The results indicated that the sample with a 67° scan orientation has the best combination of both strength and ductility. This can be attributed to finer cells/grains, which occur due to fragmentation of cells/grains during their growth across the successive layers, a higher fraction of low-angle grain boundaries (LAGBs), and variation of vector length within a layer. EBSD analysis revealed that samples with a 67° scan orientation exhibited a random crystallographic texture (MUD = 2.2), which suggests isotropic behavior compared to other samples. © ASM International 2025.