Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
5 results
Search Results
Item Noninvasive Model-Based Open-Circuit Switch Fault Detection of AC-Bypass Leg Switches in Transformerless PV Inverter(Institute of Electrical and Electronics Engineers Inc., 2021) Ahmad, M.W.; Brahmendra Yadav Gorla, N.B.Y.; Malik, H.; Panda, S.K.Transformerless inverters are being used for integrating photovoltaic (PV) sources into the grid. Highly efficient and reliable inverter concept (HERIC) inverter is one such topology, which is derived from an H-bridge by adding a bypass leg on the ac side using two back-to-back insulated gate bipolar transistors (IGBTs). Open-circuit fault in the bypass leg would result in conduction of current through antiparallel diodes of the main switches of the inverter, effectively making the inverter operate in bipolar mode. As a result of the fault, there would not be an issue of leakage current, and the operation would continue at the expense of increased conduction losses and dc-offset in the grid current. This article proposes an online noninvasive model-based technique to detect switch faults in the bypass leg of the HERIC inverter. The grid current at the peak of the carrier signal is predicted based on the measured grid current at the start of the zero states. By comparing the estimated and measured grid currents at the peak of the carrier signal, the faulty switch in the bypass leg is localized. Once the fault is localized, the inverter's modulation scheme is changed to conventional bipolar mode to improve the performance of the converter during the post-fault stage. A detailed simulation study is carried out to verify the effectiveness of the proposed approach. Experimental tests on the prototype converter show that the proposed algorithm can reliably detect the open-circuit fault in switches of the bypass leg, and once a fault is detected, the algorithm would change the modulation scheme to bipolar mode to minimize the inverter loss and dc-offset in the grid current. © 2013 IEEE.Item A New Single-Source Nine-Level Quadruple Boost Inverter (NQBI) for PV Application(Institute of Electrical and Electronics Engineers Inc., 2022) Singh, A.K.; Raushan, R.; Mandal, R.K.; Ahmad, M.W.Multi-level inverters (MLIs) with switched capacitors are becoming popular due to their utilization in AC high-voltage applications as well as in the field of renewable energy. To achieve the required magnitude of output voltage, the switched capacitor (SC) technique employs a lesser number of DC sources in accordance with the voltage across the capacitor. Designing an efficient high-gain MLI with fewer sources and switches needs a rigorous effort. This paper introduces a prototype of a nine-level quadruple boost inverter (NQBI) topology powered by one solar photo-voltaic source using fewer capacitors, switches, and diodes when compared to the other SC-MLIs topology. The suggested NQB inverter produces nine levels of voltage in its output by efficiently balancing the voltages of the two capacitors. The various SC-MLIs are compared in order to highlight the benefits and drawbacks of the proposed nine-level quadruple boost inverter (NQBI) topology. To validate the efficacy of the proposed solar photovoltaic based NQBI without grid connection, detailed experimental results are presented in a laboratory setting under various test conditions. © 2013 IEEE.Item Design and Implementation of Different Drive Topologies for Control of Induction Motor for Electric Vehicle Application(River Publishers, 2022) Husain, M.A.; Rajput, R.; Gupta, M.K.; Tabrez, M.; Ahmad, M.W.; Ilahi Bakhsh, F.I.To improve driving range in Electric vehicles (EV), parallel-series connection of battery cells is a necessity. Supressing the circulating current in the battery board of parallel connected battery strings helps improve the lifespan of the batteries. This study presents a comparison of the requirements of parallel strings of batteries in three different popular topologies for open end winding induction motor (IM) drives in EV. The topologies analyzed are a 3-phase voltage source inverter (VSI), a Dual fed inverter and three single-phase HBridge VSIs. These converters are modulated using Space vector pulse width modulation (SVPWM) as it has better performance compared to Sine PWM. MATLAB-Simulink models are developed for the converter topologies. The simulation results show that the three single-phase inverter topology feeding the drive is the best alternative when compared on the basis of battery requirement and switch loss. Moreover, each H-bridge inverter (in the three single-phase inverter topology) can be used as charger and the problem of circulating current during charging will also be least as compared to other schemes. © 2022 River Publishers.Item A Reduced Component Count Self-Balance Quadruple Boost Seventeen-Level Switched Capacitor Inverter(Institute of Electrical and Electronics Engineers Inc., 2024) Ahmed, S.; Raushan, R.; Ahmad, M.W.A switched capacitor multilevel inverter (SCMLI) enables high-quality output voltage waveforms for various industrial and renewable energy applications. SCMLI uses a combination of capacitors and switches to generate multiple voltage levels from a single dc source, thereby reducing the overall cost and size of the system. This article proposes a novel configuration of a 17-level SCMLI. The proposed converter can boost four times the input voltage by exploiting the series-parallel connection of capacitors with the dc voltage source. With simple pulsewidth modulated (PWM) control, the capacitor voltages are inherently balanced under different loading conditions. Furthermore, for 11 switches, only seven independent switching signals are required. Loss analysis reveals that the proposed SCMLI has significantly reduced conduction losses, capacitor ripple voltage, voltage stress, and cost function (CF) when compared with other topologies available in the literature. Finally, the simulation results are obtained at different loads and modulation indexes. The results are experimentally validated with a scaled-down laboratory prototype. © 2024 Institute of Electrical and Electronics Engineers Inc.. All rights reserved.Item An Inductorless Triple Boost 13-Level Switched Capacitor Inverter with Reduced Ripple Current(Institute of Electrical and Electronics Engineers Inc., 2024) Ahmed, M.S.; Raushan, R.; Ahmad, M.W.Switched capacitor (SC) multilevel inverter (SCMLI) is a promising alternative to traditional voltage source inverters for industrial and renewable energy applications. In SCMLI, capacitors are used in a specific sequence during charging and discharging either in parallel or series with the source for level generation. During the charging period of the capacitor, a large ripple current is generated. This ripple may cause an increase in the peak current and ripple voltage of the capacitors. The reliability and life expectancy of the inverter can be severely affected by this ripple current of the capacitor. This article proposes an inductorless self-balance single-phase 13-level inverter with triple boosting capability. It aims to reduce the ripple current in both the source and capacitors by arranging the switching sequence in a particular fashion to implement a partial charging technique in the capacitors. Furthermore, it results in better efficiency and reduced current stress without the need for any source inductance or a complicated control algorithm. The performance of the proposed inverter is verified through its laboratory prototype under dynamic load conditions and varying modulation indexes. © 1986-2012 IEEE.