Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
Search Results
Item Studies on copper coated polysulfone/modified poly isobutylene alt-maleic anhydride blend membrane and its antibiofouling property(2013) Isloor, A.M.; Ganesh, B.M.; Isloor, S.; A.F., A.F.; Nagaraj, H.S.; Pattabi, M.As nanofiltration is gaining more and more importance in the field of desalination, one has to address the many obstacles in order to achieve effective/efficient filtration. One such issue is biofouling and microbial attack to the membrane. This paper describes about the study on copper coating onto the membrane surface as biofouling protective layer. This is an attempt to come up with a new approach for desalination and an antimicrobial membrane. The work indicates that, the copper coated membrane can resist the possible microbial attack to some extent while maintaining good salt rejection and appreciable flux. SEM and EDX studies had shown the distribution of copper on the membrane surface. The copper coated membrane had shown the maximum salt rejection of about 96% for 3500ppm NaCl solution and also it had shown the pure water flux of 36Lm-2h-1. © 2012 Elsevier B.V.Item Enhanced hydrophilicity and salt rejection study of graphene oxide-polysulfone mixed matrix membrane(2013) Ganesh, B.M.; Isloor, A.M.; A.F., A.F.Graphene oxide (GO) dispersed polysulfone (PSf) mixed matrix membranes were prepared by wet phase inversion method. The morphology of membranes was studied using scanning electron microscope (SEM) images. The variation in hydrophilicity was studied by measuring surface wettability and water swelling experiments. The performance of membranes in terms of pure water flux and salt rejection was studied. SEM images depict enhanced macrovoids, while the contact angle data reveals that, GO incorporated membrane surface is moderately hydrophilic. Membranes exhibited improved salt rejection after GO doping. Membrane with 2000ppm GO loading has exhibited maximum of 72% Na2SO4 rejection at 4bar applied pressure. The salt rejection seems to depend on pH of the feed solution and it has been witnessed that the salt rejection showed an increasing trend with increase in the pH. © 2012 Elsevier B.V.Item Permeation, Antifouling and desalination performance of TiO2 nanotube incorporated PSf/CS blend membranes(2013) Kumar, R.; Isloor, A.M.; A.F., A.F.; Abdul Rashid, S.A.; Ahmed, A.A.Polysulfone (PSf) and chitosan (CS) blend membranes were prepared by incorporating titanium dioxide nanotubes (TiO2NT) in different compositions. The proper blending of PSf and CS in the PSf/CS/TiO2 membranes was confirmed by ATR-IR spectroscopy. The influence of nanotubes on morphology of membranes was investigated by Field Emission Scanning Electron Microscopy (FESEM). The effect of nanotubes on hydrophilicity of the membranes was studied by water swelling and contact angle measurements. The distribution of TiO2NT on the membrane surface was determined by Transmission Electron Microscope (TEM) analysis. The permeation property of PSf/CS/TiO2NT membranes was carried out by measuring the time dependent pure water flux (PWF). Bovine serum albumin (BSA) protein rejection studies were performed to know the antifouling properties. The rheological percolation threshold of PSf/CS/TiO2NT solutions was measured by viscosity studies. The nanotubes incorporated PSf/CS membranes showed enhanced permeation and antifouling properties compared to PSf/CS and nascent PSf ultrafiltration membranes. Membranes prepared well above rheological percolation threshold showed drastic reduction in pore size and acted as nanofiltration (NF) membranes. © 2013 Elsevier B.V.Item Modification of PSf/PIAM membrane for improved desalination applications using Chitosan coagulation media(2013) Kumar, R.; A.F., A.F.; Kassim, M.A.; Isloor, A.M.Polysulfone (PSf)/poly (isobutylene-alt-maleic anhydride) (PIAM) nanofiltration membranes were modified by changing the coagulation bath with various concentrations of glutaraldehyde cross-linked Chitosan solutions. Further the membranes were treated with 0.1N NaOH solution in order to achieve the hydrolysis of PIAM. The morphological changes of the membranes were determined using scanning electron microscope. The blending of PSf/PIAM membrane, the incorporation of Chitosan (CS) molecules in membrane matrix and the hydrolysis of PIAM in the membrane upon alkali treatment were studied by Attenuated Total Reflectance Infra Red (ATR-IR) spectroscopy. The hydrophilicity of modified membranes was measured using the contact angle analyzer. The pressure and time dependent pure water flux of modified PSf/PIAM/CS membranes were measured and compared with PSf/PIAM membranes (after alkali treatment). The antifouling property of membranes was determined using Bovine Serum Albumin (BSA) protein rejection studies. The modified membranes showed improved hydrophilicity and reduced pore size. The order of rejection of membranes for various electrolytes was Na2SO4>MgSO4>NaCl at minimum pressure of 0.2MPa TMP. The antifouling property of modified membranes increased with an increase in the composition of Chitosan in coagulation bath and membrane M-0.8 showed a maximum fouling resistance ratio of 74%. © 2013 Elsevier B.V.