Journal Articles
Permanent URI for this collectionhttps://idr.nitk.ac.in/handle/123456789/19884
Browse
Search Results
Item All-printed WO3 films on an Ag-interdigitated electrode derived from aqueous screen-printable inks for room-temperature ammonia gas detection(Institute of Physics, 2025) Praveen, L.L.; Singh, N.P.; Vardhan, R.V.; Mandal, S.In this work, all-printed tungsten oxide (WO3) sensors were fabricated from nanoparticle-based screen-printable inks, where the WO3 nanopowders were hydrothermally synthesized with various HCl concentrations to give enhanced room-temperature detection of ammonia (NH3) gas. The monoclinic phase of WC powders (calcined WO3) with square nanoplate-like morphology and porosities was identified from x-ray diffraction, field-emission scanning electron microscopy and Brunauer-Emmett-Teller surface area analysis. The silver precursor ink-derived interdigitated electrodes were found to be crystalline with an average finger width and Ag film thickness of 1 ± 0.4 mm and 3.8 ± 0.5 µm, respectively. The formulated WO3 inks with hydroxyethyl cellulose showed a thixotropic fluid-like behavior and exhibited a viscosity of ?9 × 104 mPa s, which is a key requirement for screen printing. Rheological study of the formulated WC inks revealed a thixotropic nature, with all WC inks showing a viscosity of 85 ± 3 Pa s and a recovery rate of 80% in the recovery stage. This work explains the role of pH in hydrothermally synthesis of WO3 by correlating the gas-sensing characteristics of the screen-printed sensors fabricated from formulated inks, where the WC-15 gas sensor showed a maximum gas response of ?340 towards 100 ppm of NH3 gas. This facile and cost-effective method for fabricating chemiresistive gas sensors could pave the way for the development of flexible and printable devices for ppb-level detection of NH3 gas and its monitoring. © 2025 IOP Publishing Ltd. All rights, including for text and data mining, AI training, and similar technologies, are reserved.