Journal Articles
Permanent URI for this collectionhttps://idr.nitk.ac.in/handle/123456789/19884
Browse
3 results
Search Results
Item Thermo-elastic response of SUS316-Al2O3 functionally graded beams under various heat loads(Elsevier Ltd, 2017) Malik, P.; Kadoli, R.Geometric nonlinearity and temperature dependent material properties are accounted for in the theoretical analysis of time dependent thermo-elastic response of thin functionally graded material (FGM) SUS316-Al2O3 beam subjected to various heat loads. A two dimensional Lagrangian rectangular finite element is used to obtain the temperature distribution on the transverse plane of the beam. Nonlinear thermo-elastic deflection and thermal stresses are evaluated for various structural and thermal boundary conditions. Thermo-elastic oscillations are observed in case of beams subjected to step, concentrated line and shock heat load whereas thermo-elastic deflection is observed for beams subjected to moving heat load. As the thermal load increases, the nonlinear thermal deflection of FGM beam are higher compared to linear analysis. In general, temperature dependency of material properties influence the amplitude of thermal oscillations. High thermal stresses are induced in beams with pin-pin and clamp-pin boundary condition as compared to hinge-hinge beam. © 2017 Elsevier LtdItem Thermal induced motion of functionally graded beams subjected to surface heating(Ain Shams University, 2018) Malik, P.; Kadoli, R.Thin beam of the functionally graded (FG) type subjected to a step heat input on one surface and insulated or exposed to convective heat loss on the opposite surface is under consideration for the evaluation of thermal induced motion. The dynamic displacement and dynamic thermal moment of the beam are analysed when the temperature gradient is independent of the beam displacement. The power law index dictates the metal–ceramic distribution across thickness of the beam and its effect on the thermal vibration of the beam is examined. The article discusses, in depth, the influence of various factors such as length to thickness ratio of beam, heat transfer boundary conditions, physical boundary conditions, and metal–ceramic combination on the thermal oscillations of FG beam. It is found that attenuation of the amplitude of static thermal deflection and superimposed thermal oscillations is a strong function of the metal–ceramic combination for the FG beam. © 2015 Faculty of Engineering, Ain Shams UniversityItem Nonlinear bending and free vibration response of SUS316-Al2O3 functionally graded plasma sprayed beams: theoretical and experimental study(SAGE Publications Inc. claims@sagepub.com, 2018) Malik, P.; Kadoli, R.Functionally graded SUS316-Al2O3 beams with ceramic content varying from 0 to 40% were prepared by a plasma spraying technique. Nonlinear finite element analysis was used to obtain the static deflection and free vibration of a clamped-free functionally graded beam. Von Kármán geometric nonlinearity and power law variation in material gradation through the beam thickness are considered in the analysis. The maximum error between the experimental and nonlinear finite element results for deflection is 6.68% and 14.31% on the fundamental frequency. Numerical results have also been attempted using ANSYS 3D solid element and they compare more closely with the experimental results. © 2016, © The Author(s) 2016.