Journal Articles
Permanent URI for this collectionhttps://idr.nitk.ac.in/handle/123456789/19884
Browse
13 results
Search Results
Item Hydrogen addition on combustion and emission characteristics of high speed spark ignition engine- An experimental study(Taylor's University # 1, Jalan Taylor's Subang Jaya, Selangor Darul Ehsan 47500, 2016) Shivaprasad, K.V.; Chitragar, P.R.; Kumar, G.N.The present article aims at characterizing the combustion and emission parameters of a single cylinder high speed SI engine operating with different concentrations of hydrogen with gasoline fuel. The conventional carburetted SI engine was modified into an electronically controllable engine, wherein ECU was used to control the injection timings and durations of gasoline. The engine was maintained at a constant speed of 3000 rpm and wide open throttle position. The experimental results demonstrated that heat release rate and cylinder pressure were increased with the addition of hydrogen until 20%. The CO and HC emissions were reduced considerably whereas NOx emission was increased with the addition of hydrogen in comparison with pure gasoline engine operation. © School of Engineering, Taylor’s University.Item Performance and emission analysis of a single cylinder CI engine using Simarouba glauca biodiesel(Springer Heidelberg, 2017) Bedar, P.; Chitragar, P.R.; Shivaprasad, K.V.; Kumar, G.N.It is well known fact that diesel engines are commonly used for transportation and power generation due to their high efficiency, low fuel consumption and durability. On contrary these engines churn out harmful and hazardous emissions like particulate matter (PM) and nitrogen oxides (NOx). Recently Bio-origin renewable fuels have taken center stage of discussion because of their ability to replace depleting fossil fuels and capacity to reduce hazardous engine exhausts emissions when used in diesel engines. In the present experimental study Simarouba glauca biodiesel is used in a naturally aspirated four stroke single cylinder air cooled direct injection kirloskar DA10 engine. The main objective is to investigate the effect of biodiesel and exhaust gas recirculation (EGR) on the performance and emission characteristics of a CI engine at 180 bar fuel injection pressure (FIP) with standard injection timing. B20, B40 biodiesel blends with 10, 15 and 20% EGR ratios were used for the study to investigate brake thermal efficiency (BTE), carbon monoxide (CO), unburned hydrocarbons (UBHC), NOx, and smoke opacity. Reduction in CO, HC and smoke opacity is noticed with simarouba biodiesel fuel while increasing NOx compared to diesel. Application of EGR along with biodiesel resulted in simultaneous reduction of nitrogen oxides and smoke without affecting engine performance. It was found from experiment that B20 blend at 15% EGR shown superior performance characteristics compared to other conditions. © Springer India 2017.Item Effect of hydrogen addition on combustion and emissions performance of a high speed spark ignited engine at idle condition(Serbian Society of Heat Transfer Engineers, 2018) Shivaprasad, K.V.; Chitragar, P.R.; Kumar, G.N.The fuel depletion and environmental pollution have pushed studies on improving the combustion and emission characteristics of internal combustion engines with several alternative fuels. Expert studies proved that hydrogen is one of the prominent energy source which has exceptional combustion qualities that can be used for improving combustion and emissions performance of gasoline-fueled spark ignition engines. This paper introduced an experiment conducted on a single cylinder high speed gasoline engine equipped with a hydrogen injection system to discover the combustion and emissions characteristics with various hydrogen gasoline blends at idle condition. For this purpose, the conventional carburetted high speed spark ignition engine was modified into an electronically controllable engine with help of electronic control unit which dedicatedly used to control the ignition timings and injection duration of gasoline fuel. © 2018 Society of Thermal Engineers of Serbia.Item Experimental studies on the impact of part-cooled high-pressure loop EGR on the combustion and emission characteristics of liquefied petroleum gas(Springer Science and Business Media B.V., 2020) Oommen, L.P.; Kumar, G.N.Liquefied petroleum gas is preferred and adopted in automotive engines because of its efficient burning and cleaner emission characteristics. Since LPG contains less carbon molecules and higher carbon to hydrogen ratios than gasoline or diesel, it has a much higher emission reduction potential both in the cases of regulated and non-regulated emissions. A major disadvantage of deploying LPG widely is the amount of NOx generation owing to the higher temperatures developed in the combustion chamber. In this study, part-cooled EGR is applied in varying rates (12%, 18%, 24%) in order to analyze the effects produced in the performance and emission characteristics of a multicylinder MPFI engine fuelled by 100% LPG at four different loading conditions and four different operating speeds. It can be observed that the application of an optimum rate of cooled EGR reduces the NOx emissions drastically even though at the expense of hydrocarbon emissions. The fuel consumption of the test engine is reduced up to 12.28% with the application of 18% percentage of part-cooled EGR. It can be inferred from the experimental studies that 18% part-cooled EGR is the optimum flow rate of recirculation which is most effective during the part load operation of the engine (50–75%) and at higher engine speeds. However, the emission of oxides of nitrogen reduced by 7.8% at 24% recirculation. The statistical analysis of combustion shows a reduction in combustion stability with increased flow of recirculation. © 2020, Akadémiai Kiadó, Budapest, Hungary.Item Combustion, performance and emission analysis of preheated KOME biodiesel as an alternate fuel for a diesel engine(Springer Science and Business Media B.V., 2020) Kodate, S.V.; Yadav, A.; Kumar, G.N.In the present work, karanja oil methyl ester (KOME) biodiesel is used in a compression ignition engine to find an alternative to diesel. The use of biodiesel in a CI engine leads to poor performance and high brake specific fuel consumption due to the higher viscosity and lower calorific value of biodiesel. This problem can be reduced by increasing the injection temperature of biodiesel or its blends to a certain temperature. In this study, working fuel is tested at preheating temperatures of 95 °C for various loading conditions (0, 25, 50, 75 and 100%). Effect of different KOME biodiesel–diesel blends (B0, B30, B50 and B100) on engine performance, combustion and emissions is studied at different loads. At higher temperature, the viscosity of the fuel decreases which leads to better combustion, improves the atomization as well as vaporization of fuel in a diesel engine, resulting in higher engine performance and lower emissions of CO and HC, with slight increment in NOX and CO2 emission compared to unheated neat diesel and biodiesel blends. The result shows that for 100% biodiesel (B100) at full load, BTE is improved by 9.1% compared to unheated case. Preheating of B100 fuel upto 95 °C at full load decreases the BSFC, CO and HC emission by 6.5%, 8.1% and 10.6%, respectively, compared to unheated case. © 2020, Akadémiai Kiadó, Budapest, Hungary.Item Effect of hydrogen enrichment on performance, combustion, and emission of a methanol fueled SI engine(Elsevier Ltd, 2021) Nuthan Prasad, B.S.; Pandey, J.K.; Kumar, G.N.The study of potentially high rated alternative fuel (Methanol) for the IC engines is an exciting topic in the recent research advancement. However, the study of combination of methanol and hydrogen is considered to address both economic and environmental needs. Hydrogen with best combustion characteristics will compensate for the drawbacks of methanol as a fuel. In the present investigation hydrogen enrichment to methanol has shown a significant enhancement in performance and combustion; the overall emission has reduced substantially. The experiments for a different set of trials, including hydrogen enrichment ranging between 5% and 20% with 2.5% increment, the engine is operated with wide-open throttle (WOT) condition for different speeds. The increase in enrichment of hydrogen has shown a rise in BTE, BP, and a reduced BSEC value. The percentage increase in BTE is between 20 and 30%, and an increase in hydrogen beyond 12.5% would affect the volumetric efficiency, and thus performance declines after that. The exhaust emissions have a huge impact on hydrogen enrichment; CO, HC, and CO2 emission are reduced by 30–40%; however, an increase in cylinder temperature due to rapid combustion slightly increases the NOx emission. Thus hydrogen enriched methanol operating at higher compression ratio can improve the overall engine characteristics significantly. © 2021 Hydrogen Energy Publications LLCItem Investigation of preheated Dhupa seed oil biodiesel as an alternative fuel on the performance, emission and combustion in a CI engine(Elsevier Ltd, 2021) Kodate, S.V.; Satyanarayana Raju, P.; Yadav, A.K.; Kumar, G.N.The present study investigates the suitability of preheated Vateria indica methyl ester (VIME) as an alternative fuel for a diesel engine. VIME is a renewable, non-toxic and sustainable alternative biodiesel obtained from Dhupa fat by transesterification. This study aims to evaluate the combustion, performance, and emission characteristics of four different blends such as B0 (0% VIME and 100% mineral diesel), B30, B50 and B100 at elevated fuel inlet temperatures ranging from 35 °C to 95 °C. The tests are carried out in a single cylinder diesel engine at optimum loading condition and fixed speed. Results are obtained in terms of brake thermal efficiency (BTE), brake specific fuel consumption (BSFC), in-cylinder pressure, heat release rate and exhaust emissions (CO, HC, NOX, CO2 and soot). It is observed that the preheating of blends decreases the viscosity which enhances fuel spray characteristics, leading to higher engine performance, lower CO and HC emissions with a slight increase in NOX and CO2 emissions. BTE and peak in-cylinder pressure for B100 at 95 °C and 75% load are increased by 7.44%, 2.97% respectively compared to unheated B100 biodiesel. BSFC, CO, HC emissions at 75% load for B100 at 95 °C are reduced by 26.73%, 28.08%, 42.7% respectively compared to unheated B100. © 2021 Elsevier LtdItem Effect of parallel LPG fuelling in a methanol fuelled SI engine under variable compression ratio(Elsevier Ltd, 2022) Dinesh, M.H.; Pandey, J.K.; Kumar, G.N.In the present experimental study, five LPG fractions from 25% to 45% based on total energy are tested in a methanol fuelled SI engine at compression ratios (CR) varying from 12 to 15. Results are affirmative towards methanol/LPG dual fuel. The brake power, brake thermal efficiency, and volumetric efficiency are found to increase by 51%, 21.2%, and 13% respectively by changing from 25% LPG fraction at CR12 to 45% LPG fraction at CR15. The flame development period is found to decrease with CR and LPG, while the flame propagation period and total combustion duration are found to decrease with CR but increase with LPG. The maximum cylinder pressure and net heat release rate are found to increase by 101% and 27.8% respectively and advanced. CO emissions are found to decrease with CR while increase with LPG fraction. HC is found to decrease with LPG as well as CR. CO2 emissions are found to increase continuously with increasing LPG fractions and CR. The NOx emissions are also found to increase explicitly with LPG and CR, a net 209% increase in it is found 25% LPG at CR 12–45% LPG at CR15. © 2021 Elsevier LtdItem Influence of ignition timing on performance and emission characteristics of an SI engine fueled with equi-volume blend of methanol and gasoline(Taylor and Francis Ltd., 2023) Nuthan Prasad, B.S.; Kumar, G.N.In the present investigation, experiments were conducted in wide open throttle condition (WOT) for different speed ranging from 1400 rpm to 1800 rpm at an interval of 200 on a single-cylinder four-stroke port-injected; spark-ignition engine. The engine fueled with equi-volume blend of methanol/gasoline was tested for different ignition timing and its effects on engine characteristics. The experiment results shown, retardation of ignition timing to 14⁰ BTDC exhibits excellent results compared to 24⁰ BTDC ignition timing. The results obtained show a good agreement of improvisation observed with M50 fuel in terms of BTE and BSEC at a speed of 1600 rpm when compared to gasoline fuel. The optimal ignition timing attributes to good combustion efficiency with increasing cylinder pressure and heat release rate. However, low carbon–hydrogen ratio and oxygen content in methanol aids to reduced NOx, HC, and CO emissions by 50%, 35%, and 40%, respectively. The small increase of 10% in CO2 emission is observed; this is due to retardation of ignition time, which allows the M50 fuel to absorb sufficient energy and achieve complete combustion. © 2019 Taylor & Francis Group, LLC.Item Study of combustion and emission of a SI engine at various CR fuelled with different ratios of biobutanol/hydrogen fuel(Elsevier Ltd, 2023) Pandey, J.K.; Kumar, G.N.The global requirement is shifting to territorial independence of energy sources, and the introduction of alcohols and biofuels are the primary sectors. Recently agriculture products-based ethanol has replaced a larger portion of gasoline. Butanol is another impressive fuel in the same chain, much better than ethanol in many parameters. Butanol has certain limitations, too, such as higher latent heat and low heating value. Therefore, biobutanol/hydrogen is tested experimentally at various compression ratios (CR) in the present study. Brake thermal efficiency was not significantly changed by CR at 90% butanol, while CR is more impressive with increasing hydrogen. The flame development period was reduced by 34%, while the flame propagation phase was reduced by 29% by increasing CR to 15 and hydrogen to 25%. Peak pressure and heat release rate surged by 12.89% and 12.32% and advanced by 6°CA. The coefficient of variations is also reduced by 21% by increasing CR to 15 and hydrogen to 30%. Higher hydrogen faced combustion difficulties due to increasing stratification and heterogeneity during combustion. Unlikely to trend, Tmax (peak cylinder temperature) and NOx were continuously increased with CR and hydrogen due to increased fuel quantity and larger mass burning before TDC. However, CO and HC emissions were reduced by CR due to increased BTE (brake thermal efficiency) and reduced by hydrogen due to less HC supply. A slight increase in HC and CO was noticed for higher hydrogen due to local heterogeneity and disassociation at high temperatures. © 2023 Hydrogen Energy Publications LLC